Discharge of Capacitor

After a complete charging of a capacitor to a potential equivalent to that of the power source V°, a discharge can be started by connecting the charged capacitor to a loop circuit with a resistor R. In this discharging loop, the only 

The solution to this first-order differential in terms of charge q is 

Graph of time constants for capacitor charging and discharging. 

---

Figure 11. Time display of temperature profiles of BC + Cl2 reaction waves. The system was placed in the vapor of liquid nitrogen. The solid curve resulted from initiation by slow heating, and the dashed curve by rapid heating (discharge of capacitor through heater).

A time delay is built in to allow discharge of a charged capacitor up to 90% before it is reswitched. This is achieved by introducing a timer into the relay s switching... 

Determine the discharge device for the discharge of a three-phase 6.6 kV, 50 Hz, 1000 kVAr, yconnected capacitor bank, connected in units of 10 x 100 kVAr each, through an automatic p.f. correction relay, having a closing cycle of 10 seconds. Data available from the capacitor manufacturer,... 

For more than one capacitor bank one RVT for each bank will be necessary for the correct discharge of each bank, (Figure 26.5). An RVT, if provided with an additional star-connected tertiary winding rated for 110 V line to line, can aiso check the discharge condition and its duration and if it meets the design requirements. This can even be monitored remotely through a relay and control panel. 

Tank/soil potential measurements cannot be made on objects to be protected with very high coating resistances which are found in rare cases of defect-free coating, and particularly with resin coatings. Off potentials change relatively quickly with time, similar to the discharge of a capacitor, and show erroneous values that are too positive [8]. This is the case with coating resistances of 10 Q m. If there are defects, the resistance is clearly much lower. The advice in Section 3.3.2.2 is then applicable for potential measurement. 

Test methods reporting the decrease of stored energy during discharge of a capacitor use the relation... 

The reverse process of discharging the capacitor occurs when both electrodes are electrically connected. Through this connection, the system is allowed to reach its equilibrium state, and charge flows from the negative to the positive electrode until both Fermi levels are aligned again. 

As a first step we have examined the discharge of SC having the volume of V, capacitance of C and inner resistance of Rin. For such a capacitor charged up to the voltage U, and then discharged to a nonlinear load to keep the constant power P until the voltage decreases to U/2 the expression (5) for the energy density (E = E/V) and power density (p = P/V) can be derived [3],... 

---