Direct arylation, palladium-catalyzed

Although the direct arylation reactions catalyzed by transition metal complexes (other than palladium) are discussed in this chapter, the corresponding palladium-catalyzed transformations are summarized in Chapter 10. A detailed overview of the mechanistic aspects of metaldirect arylations is provided in Chapter 11. 

Palladium-catalyzed aminations of aryl halides is now a well-documented process [86-88], Heo et al. showed that amino-substituted 2-pyridones 54 and 55 can be prepared in a two-step procedure via a microwave-assisted Buchwald-Hartwig amination reaction of 5- or 6-bromo-2-benzyloxypyri-dines 50 and 51 followed by a hydrogenolysis of the benzyl ether 52 and 53, as outlined in Fig. 9 [89]. The actual microwave-assisted Buchwald-Hartwig coupling was not performed directly at the 2-pyridone scaffold, but instead at the intermediate pyridine. Initially, the reaction was performed at 150 °C for 10 min with Pd2(dba)3 as the palladium source, which provided both the desired amino-pyridines (65% yield) as well as the debrominated pyridine. After improving the conditions, the best temperature and time to use proved... 

Yasuda S, Yorimitsu H, Oshima K (2008) Synthesis of aryliron complexes by palladium-catalyzed transmetalation between [CpFe(CO)2l] and aryl Grignard reagents and their chemistry directed toward organic synthesis. Organometallics 27 4025 027 Jonas K, Schieferstein L (1979) Simple route to Li- or Zn-metalated r -cyclopentadien-yliron-olefin complexes. Angew Chem Int Ed Engl 18 549-550... 

The synthesis of 1-alkenylboronic acids from l-alkenylmagnesiums or -lithiums suffers from difficulty in retaining the stereochemistry of 1-aikenyl halides, but the palladium-catalyzed coupling reaction of diboron 82 with 1-aikenyl halides or tri-flates directly provides 1-alkenylboronic esters (Scheme 1-43) [157, 158]. Although the reaction conditions applied to the aryl coupling resulted in the formation of an... 

Fluorous ligands introduce an ease of purification in that the tagged phosphine ligand, the palladium catalyst complexed ligand, and the oxidized ligand can be completely removed by direct fluorous solid-phase separation (F-SPE) prior to product isolation. Similarly, an example of a fluorous palladium-catalyzed microwave-induced synthesis of aryl sulfides has been reported, whereby the product purification was aided by fluorous solid-phase extraction [91]. 

Aryl and vinyl nitriles have been prepared very efficiently from the corresponding bromides by palladium-catalyzed reactions under microwaves. This energy source has been employed for the conversion of these nitriles into aryl and vinyl tetrazoles by cycloaddition reactions with sodium azide (Scheme 9.66). The direct transformation of aryl halides to the aryl tetrazoles in a one pot procedure could be accomplished both in solution and on a solid support [115], The reactions were complete in a few minutes, a reaction time considerably shorter than those previously reported for the thermal reactions. The cydoadditions were performed with sodium azide and ammonium chloride in DMF and, although no explosion occurred in the development of this work, the authors point out the necessity of taking adequate precautions against this eventuality. 

Watanabe reports a new method for the direct conversion of o-choroacetaldehyde N,N-disubstituted hydrazones into 1-aminoindole derivatives 93 by palladium-catalyzed intramolecular ring closure of 92 in the presence of P Bu3 or the bisferrocenyl ligand 94 <00AG(E)2501>. When X = Cl, this cyclizative process can be coupled with other Pd-catalyzed processes with nucleophilic reagents (e.g., amines, azoles, aryl boronic acids) so as to furnish indole derivatives with substituents on the carbocyclic ring. 

Several reports have been made of a successful catalyzed addition/ substitution reaction resulting in direct attachment of phosphorus to aromatic rings. The preparation of mixed triarylphosphines has been accomplished by the reaction of tin- or silicon-substituted diphe-nylphosphines with aryl halides catalyzed by palladium reagents.74 A similar transformation has also been reported using nickel catalysis.75 The addition/substitution of diphenylphosphine to triflate functionalized phenolic linkages has been of use for the preparation of substances as analogues of tyrosine-related amino acid derivatives, accomplished with catalysis by palladium acetate (Equation 4.29).76... 

Palladium-catalyzed directed intramolecular activations of aryl C-H bonds have been reported, as in the phenyla-tion of heterocycle analogs. Palladacycles are proposed intermediates, acting as effective catalysts, and the mechanism is likely to proceed via oxidation of Pd(ll) to Pd(iv) by the iodonium salt, as for the Equation (57), which described the activation of benzylic i/-CH bonds (Equations (121)—(123).109... 

Fagnou et al. reported the synthesis of mukonine (11) starting from methyl vanillate (644). This synthesis uses both a palladium(0)-catalyzed intermolecular direct arylation and an intramolecular cyclization reaction. Triflation of methyl vanillate (644) afforded the aryl triflate 645. Using a Buchwald-Flartwig amination protocol, the latter was subjected to direct arylation with 2-chloroaniline (646) to furnish the corresponding diarylamine 647. Finally, intramolecular cyclization of 647 afforded mukonine (11). To date, this is the best synthesis (three steps, 75% overall yield) available for mukonine based on commercially available methyl vanillate (644) (582) (Scheme 5.45). 

Since Wakamatsu serendipitously discovered amidocarbonylation while performing the cobalt-catalyzed hydroformyla-tion of olefins in 1971, this unique carbonylation reaction, affording a-amino acids directly from aldehydes, has been extensively studied.More recently, palladium-catalyzed processes have been developed to expand the scope of this reaction.The Pd-catalyzed amidocarbonylation has been applied to aldehydes,aryl halides, and imines. As a related reaction, lactamization " of aryl halides catalyzed by a rhodium complex has also been developed. 

Substituted imidazole 1-oxides 228 are predicted to be activated toward electrophilic aromatic substitution, nucleophilic aromatic substitution, and metallation as described in Section 1. Nevertheless little information about the reactivity of imidazole 1-oxides in these processes exists. The reason for this lack may be the high polarity of the imidazole 1-oxides, which makes it difficult to find suitable reaction solvents. Another obstacle is that no method for complete drying of imidazole 1-oxides exists and dry starting material is instrumental for successful metallation. Well documented and useful is the reaction of imidazole 1-oxide 228 with alkylation and acylation reagents, their function as 1,3-dipoles in cycloadditions, and their palladium-catalyzed direct arylation. 

Protons at C2 of imidazole 1-oxides 228 are acidic and are exchanged with deuterium even in weakly acidic solution. The exchange rate increases with increasing pH (2004S2678). Although the mechanism is not fully understood, the palladium-catalyzed direct arylation of imidazole 1-oxides most likely involves deprotonation so that the observed regi-oselective arylation reflects the propensity to proton abstraction found to decrease in the order C2 > C5 > C4 (2009JA3291). 

The palladium-catalyzed and the copper-cocatalyzed direct arylation of imidazole 1-oxides 280 shown in Scheme 83 may involve transmetallation (2008JA3276, 2009JA3291). However, classical transmetallation like conversion of imidazolyllithium compounds to imidazolylzinc compounds has not been reported. 

Palladium-catalyzed carbonylation reactions with aryl halides are powerful methods of generating aromatic amides, hydrazides, esters and carboxylic acids [25]. We have previously reported the exploitation of Mo(CO)6 as a robust carbon monoxide-releasing reagent in palladium-catalyzed carbonylation reactions [26-29]. This stable and inexpensive solid delivers a fixed amount of carbon monoxide upon heating or by the addition of a competing molybdenum coordinating ligand (for example DBU). This allows for direct liberation of carbon monoxide in the reaction mixture without the need for external devices. 

Chiral quinolinones can be accessed by the palladium-catalyzed coupling between aryl bromides and /3-amino acids, followed by intramolecular acid-catalyzed cyclisation (Equation 136) <1998TA1137>. The reaction of 2-amino-1,3-diene with quinolinone yields the acridine derivative directly (Scheme 75) <1997J(P1)2807>. 

The initial step of the catalytic cycle is oxidative addition of aryl triflate to a BINAP-coordinated Pd(0) species. Since, in the actual catalytic system, Pd(OAc)2 and (/ )-BINAP are used as the precursors of the Pd(0) species, reduction of Pd(OAc)2 into the BINAP-coordinated Pd(0) species should be operative prior to the catalytic reaction. Although Pd(OAc)2 is the most commonly used precursor of a Pd(0) species in many palladium-catalyzed organic reactions, no direct information has been reported so far on its reduction process. In this study, we confirmed for the first time that the reduction proceeds according to the process involving a combination of tertiary phosphine (BINAP) and water as the reducing reagent (Scheme 8) (Ozawa, F. Kubo, A. Hayashi, T., submitted for publication). 

Lipshutz and colleagues presented recently palladium-catalyzed direct coupling reactions of alkyl iodides and vinyl bromides or iodides catalyzed by 1 mol% Pd(amphos)Cl2 in the presence of zinc and TMEDA in a biphasic aqueous/poly-(ethylene glycol tocopheryl sebacate) reaction medium [198], Internal olefins were obtained in 51-95% yield. For aryl-substituted (Aj-vinyl bromides, retention of double bond geometry was observed, while different degrees of isomerization occurred for (Z)-isomers, which may indicate the intervention of a radical addition process in the course of the coupling process. Alkyl-substituted (Z)-vinyl halides were transformed in contrast with retention of alkene geometry. Aryl halides also reacted [199],... 

The palladium-catalyzed formation of diarylamines has been used in several contexts to form molecules with biological relevance. The ability to prepare haloarenes selectively by an ortho-metallation halogenation sequence allows for the selective delivery of an amino group to a substituted aromatic structure. Snieckus has used directed metallation to form aryl halides that were subsequently reacted with anilines to prepare diarylamines (Eq. 34)) [156]. Frost and Mendon a have reported an iterative strategy to prepare (by palladium-catalyzed chemistry) amides and sulfonamides that may act as peptidomimetics. Diarylamine units are constructed using the DPPF-ligated palladium catalysts, and the products are then acylated or sulfo-nated with 4-bromo benzoyl or arylsulfonyl chlorides [157]. 

The transition metal catalyzed synthesis of arylamines by the reaction of aryl halides or tri-flates with primary or secondary amines has become a valuable synthetic tool for many applications. This process forms monoalkyl or dialkyl anilines, mixed diarylamines or mixed triarylamines, as well as N-arylimines, carbamates, hydrazones, amides, and tosylamides. The mechanism of the process involves several new organometallic reactions. For example, the C-N bond is formed by reductive elimination of amine, and the metal amido complexes that undergo reductive elimination are formed in the catalytic cycle in some cases by N-H activation. Side products are formed by / -hydrogen elimination from amides, examples of which have recently been observed directly. An overview that covers the development of synthetic methods to form arylamines by this palladium-catalyzed chemistry is presented. In addition to the synthetic information, a description of the pertinent mechanistic data on the overall catalytic cycle, on each elementary reaction that comprises the catalytic cycle, and on competing side reactions is presented. The review covers manuscripts that appeared in press before June 1, 2001. This chapter is based on a review covering the literature up to September 1, 1999. However, roughly one-hundred papers on this topic have appeared since that time, requiring an updated review. 

---