1.3- Dipolar cycloaddition reactions regioselectivity

The authors have also elaborated a microwave-enhanced one-pot procedure [90] for the Huisgen 1,3-dipolar cycloaddition reaction. In a typical procedure, a pyrazinone with a triple bond connected to the core via C - O linkage, was reacted with a suitable benzylic bromide and NaNs in presence of the Cu(I) catalyst in a t Bu0H/H20 system under microwave irradiation (Scheme 26). The cycloaddition was found to proceed cleanly and with full regioselectivity. As the azide is generated in situ, this procedure avoids the isolation and purification of hazardous azides, which is especially important when handling the ahphatic ones, which are known to be toxic and explosive in nature. 

Analogously, the 1,3-dipolar cycloaddition reaction of 2-diazopropane with propargyl alcohol 62b, performed at 0 °C in dichloromethane, was completed in less then 10 h and led to a monoadduct 63b with the same regioselective addition mode of 59 to the triple bond. The HMBC spectrum showed correlations between the ethylenic proton and the carbons C3 and C5 and between the methyl protons and the carbons C3 and C4. 

An interesting antibody-catalyzed intermolecular asymmetric 1,3-dipolar cycloaddition reaction between 4-acetamidobenzonitrile N-oxide and N,N-dimethylacrylamide generating the corresponding 5-acylisoxazoline was observed (216). Reversed regioselectivity of nitrile oxide cycloaddition to a terminal alkene was reported in the reaction of 4-A rt-butylbenzonitrile oxide with 6A-acrylamido-6A-deoxy-p-cyclodextrin in aqueous solution, leading to the formation of the 4-substituted isoxazoline, in contrast to the predominance of the 5-substituted regioisomer from reactions of monosubstituted alkenes (217). 

Dipolar cycloaddition reaction of trimethylstannylacetylene with nitrile oxides yielded 3-substituted 5-(trimethylstannyl)isoxazoles 221. Similar reactions of (trimethylstannyl)phenylacetylene, l-(trimethylstannyl)-l-hexyne, and bis (trimethylsilyl)acetylene give the corresponding 3,5-disubstituted 4-(trimethyl-stannyl)isoxazoles 222, almost regioselectively (379). The 1,3-dipolar cycloaddition reaction of bis(tributylstannyl)acetylene with acetonitrile oxide, followed by treatment with aqueous ammonia in ethanol in a sealed tube, gives 3-methyl-4-(tributylstannyl)isoxazole 223. The palladium catalyzed cross coupling reaction of... 

The general method, that has been widely used for the synthesis of perhydropyrrolo[1,2-6]isoxazoles, is based on a cycloaddition reaction of cyclic nitrones with dipolarophiles. The nitrone is easily available by oxidation of the corresponding hydroxylamine with mercuric chloride. The cycloaddition of nitrone to dipolarophiles is highly regioselective and stereoselective and have been often applied in the total synthesis of natural products <20010L1367, 2004BML3967, 2005JOC3157>. As one representative example of dipolar cycloaddition, reaction... 

The 1,3-dipolar cycloaddition reaction of 3,4-dihydroisoquinoline N-oxides 75 with 71b and 32 proceeded regioselectively to give diastereomeric mixtures of isoxa-zolidines 76 and 77 [75]. 

On the other hand, reactions of nitrile oxides with 1,2-disubstituted olefins are slower and regioselectivity usually was not so high. For example, benzonitrile oxides, obtained from the corresponding chlorooximes 167, undergo 1,3-dipolar cycloaddition reaction with methyl cinnamate to produce the 5-phenyl 168 and 4-phenyl 169 regioisomers in approximately an 80 20 ratio °. However, use of A,iV-diethylcinnamamide as the dipolarophile... 

In addition to the role of substituents in determining regioselectivity, several other structural features affect the reactivity of dipolarophiles. Strain increases reactivity. Norbomene, for example, is consistently more reactive than cyclohexene in 1,3-dipolar cycloadditions. Conjugated functional groups also usually increase reactivity. This increased reactivity has most often been demonstrated with electron-attracting substituents, but for some 1,3-dipoles, enamines, enol ethers, and other alkenes with donor substituents are also quite reactive. Some reactivity data for a series of alkenes with a few 1,3-dipoles are given in Table 6.3. Scheme 6.5 gives some examples of 1,3-dipolar cycloaddition reactions. 

The statement made in 1986 by Gingrich and Baum (10), with regard to miinchnones, that the most important reactions (of mtinchnones) from a synthetic point of view are 1,3-dipolar cycloaddition reactions, certainly applies to all mesoionic heterocycles and is more true today than it was in 1986. Although the factors governing the regioselectivity of unsymmetrical mesoionic cycloadditions are not always completely understood, the synthetic utility of this chemistry is enormous and indisputable. 

The structural requirements of the mesomeric betaines described in Section III endow these molecules with reactive -electron systems whose orbital symmetries are suitable for participation in a variety of pericyclic reactions. In particular, many betaines undergo 1,3-dipolar cycloaddition reactions giving stable adducts. Since these reactions are moderately exothermic, the transition state can be expected to occur early in the reaction and the magnitude of the frontier orbital interactions, as 1,3-dipole and 1,3-dipolarophile approach, can be expected to influence the energy of the transition state—and therefore the reaction rate and the structure of the product. This is the essence of frontier molecular orbital (EMO) theory, several accounts of which have been published. 16.317 application of the FMO method to the pericyclic reactions of mesomeric betaines has met with considerable success. The following section describes how the reactivity, electroselectivity, and regioselectivity of these molecules have been rationalized. 

Nitrile oxides react with the methyl enol ethers of (Rs)-l -fluoro-alkyl-2-(p-tolylsulfinyl)ethanones to produce (45,5/f,/fs)-4,5-dihydroisoxazoles with high regio-and diastereo-selectivity.87 In the 1,3-dipolar cycloaddition of benzonitrile oxide with adamantane-2-thiones and 2-methyleneadamantanes, the favoured approach is syn, as predicted by the Cieplak s transition-state hyperconjugation model.88 The 1,3-dipolar cycloaddition reaction of acetonitrile oxide with bicyclo[2.2.l]hepta-2,5-diene yields two 1 1 adducts and four of six possible 2 1 adducts.89 Moderate catalytic efficiency, ligand acceleration effect, and concentration effect have been observed in the magnesium ion-mediated 1,3-dipolar cycloadditions of stable mesitonitrile oxide to allylic alcohols.90 The cycloaddition reactions of acryloyl derivatives of the Rebek imide benzoxazole with nitrile oxides are very stereoselective but show reaction rates and regioselectivities comparable to simple achiral models.91. 

As measured by the criteria of stereospecificity, regioselectivity, kinetic isotope effects, and solvent effects [117-120, 541-543], 1,3-dipolar cycloaddition reactions represent orbital symmetry-allowed [n + n s] cycloadditions, which usually follow concerted pathways Diels-Alder reactions and 1,3-dipolar cycloadditions resemble each other, as demonstrated by the small solvent effects on their bimolecular rate constants. In going from nonpolar to polar solvents, the rate constants of 1,3-dipolar cycloadditions change only by a factor of 2... 10 [120, 131-134]. 

---