Diazoalkanes decomposition

Some examples of carbene dimer formation resulting from diazoalkane decomposition on transition-metal surfaces have been reported. Diazomethane is decomposed to give ethylene and N2 upon passage over a C0O/M0O3 catalyst as well as on Ni, Pd, Fe, Co, Ru and Cu surfaces 367). Similarly, 2-diazopropane is readily decomposed on Raney nickel 368). At room temperature, propene and N2 were the only detectable products, but above 50 °C, the carbene dimer 2,3-dimethyl-2-butene started to appear which reached its maximum yield at 100 °C, where approximately 40 % of the carbene fragments dimerized. It is assumed 367,368), that surface carbenes are formed as intermediates from both diazomethane and 2-diazopropane which either dimerize or desorb by migration of a P-hydrogren, if available (Scheme 40). 

Allyl sulfides and allyl amines. Rhodium-catalyzed decomposition of ethyl diazoacetate in the presence of these allyl compounds generates products 136 and 137, respectively, derived from [2,3] rearrangement of an S- or N-ylide intermediate, besides small amounts of carbene dimers No cyclopropane and no product resulting from the ylide by [1,2] rearrangement were detected. Besides RhjfOAc) and Rhg(CO)i6, the rhodium(I) catalysts [(cod)RhCl]2 and [(CO)2RhCl]2 were found to behave similarly, but yields with the only allyl amine tested, CH =CH—CH NMe, were distinctly lower with the latter two catalysts. Reaction temperatures are higher than usually needed in rhodium-promoted diazoalkane decomposition, which is certainly due to competition between the diazo compound and the allylic hetero-... 

New evidence as to the nature of the intermediates in catalytic diazoalkane decomposition comes from a comparison of olefin cyclopropanation with the electrophilic metal carbene complex (CO)jW—CHPh on one hand and Rh COAc) / NjCHCOOEt or Rh2(OAc)4 /NjCHPh on the other . For the same set of monosubstituted alkenes, a linear log-log relationship between the relative reactivities for the stoichiometric reaction with (CO)5W=CHPh and the catalytic reaction with RhjfOAc) was found (reactivity difference of 2.2 10 in the former case and 14 in the latter). No such correlation holds for di- and trisubstituted olefins, which has been attributed to steric and/or electronic differences in olefin interaction with the reactive electrophile . A linear relationship was also found between the relative reactivities of (CO)jW=CHPh and Rh2(OAc) NjCHPh. These results lead to the conclusion that the intermediates in the Rh(II)-catalyzed reaction are very similar to stable electrophilic carbenes in terms of electron demand. As far as cisjtrans stereoselectivity of cyclopropanation is concerned, no obvious relationship between Rh2(OAc) /N2CHCOOEt and Rh2(OAc),/N2CHPh was found, but the log-log plot displays an excellent linear relationship between (CO)jW=CHPh and Rh2(OAc) / N2CHPh, including mono-, 1,1-di-, 1,2-di- and trisubstituted alkenes In the phenyl-carbene transfer reactions, cis- syn-) cyclopropanes are formed preferentially, whereas trans- anti-) cyclopropanes dominate when the diazoester is involved. 

Diazoalkane decomposition. Surprisingly, tetraphenylethylene is almost as efficient as various copper catalysts for decomposition of diazoalkanes to car-benoids. For example, diazomethane and cyclohexene in the presence of this catalyst react to form norcarane in 15 5% yield with copper catalysis the yield of norcarane is 24%. Cyclopropanations have been observed with this hydrocarbon catalyst with a variety of diazo compounds diazomethane, a-diazoacetophenone, and diazofluorene. Diphenyldiazomethane, however, is converted mainly into benzophenone azine, (C5H5)2C=NN=C(C6Hs)2. 

Analogous to the decomposition of diazoalkanes, thermolysis of azides leads to the production of nitrenes. This is exemplified for ethyl... 

Carbenes from Diazo Compounds. Decomposition of diazo compounds to form carbenes is a quite general reaction that is applicable to diazomethane and other diazoalkanes, diazoalkenes, and diazo compounds with aryl and acyl substituents. The main restrictions on this method are the limitations on synthesis and limited stability of the diazo compounds. The smaller diazoalkanes are toxic and potentially explosive, and they are usually prepared immediately before use. The most general synthetic routes involve base-catalyzed decomposition of V-nitroso derivatives of amides, ureas, or sulfonamides, as illustrated by several reactions used for the preparation of diazomethane. 

Reaction of diazo compounds with a variety of transition metal compounds leads to evolution of nitrogen and formation of products of the same general type as those formed by thermal and photochemical decomposition of diazoalkanes. These transition... 

Carbenes from Sulfonylhydrazones. The second method listed in Scheme 10.8, thermal or photochemical decomposition of salts of arenesulfonylhy-drazones, is actually a variation of the diazoalkane method, since diazo compounds are intermediates. The conditions of the decomposition are usually such that the diazo compound reacts immediately on formation.147 The nature of the solvent plays an important role in the outcome of sulfonylhydrazone decompositions. In protic solvents, the diazoalkane can be diverted to a carbocation by protonation.148 Aprotic solvents favor decomposition via the carbene pathway. 

The reaction conditions should be as mild as possible to prevent uncontrolled decomposition of the diazoalkane and carbene complex product. 

The EfZ ratio of stilbenes obtained in the Rh2(OAc)4-catalyzed reaction was independent of catalyst concentration in the range given in Table 22 357). This fact differs from the copper-catalyzed decomposition of ethyl diazoacetate, where the ratio diethyl fumarate diethyl maleate was found to depend on the concentration of the catalyst, requiring two competing mechanistic pathways to be taken into account 365), The preference for the Z-stilbene upon C ClO -or rhodium-catalyzed decomposition of aryldiazomethanes may be explained by the mechanism given in Scheme 39. Nucleophilic attack of the diazoalkane at the presumed metal carbene leads to two epimeric diazonium intermediates 385, the sterically less encumbered of which yields the Z-stilbene after C/C rotation 357,358). Thus, steric effects, favoring 385a over 385 b, ultimately cause the preferred formation of the thermodynamically less stable cis-stilbene. 

The q1-coordinated carbene complexes 421 (R = Ph)411 and 422412) are rather stable thermally. As metal-free product of thermal decomposition [421 (R = Ph) 110 °C, 422 PPh3, 105 °C], one finds the formal carbene dimer, tetraphenylethylene, in both cases. Carbene transfer from 422 onto 1,1-diphenylethylene does not occur, however. Among all isolated carbene complexes, 422 may be considered the only connecting link between stoichiometric diazoalkane reactions and catalytic decomposition [except for the somewhat different results with rhodium(III) porphyrins, see above] 422 is obtained from diazodiphenylmethane and [Rh(CO)2Cl]2, which is also known to be an efficient catalyst for cyclopropanation and S-ylide formation with diazoesters 66). 

It is suggested that the real carbene, generated by thermolysis of the diazo or diazirine precursors or photolysis of 40, gives mostly 1,3-insertion, whereas photolysis of either the diazoalkane or diazirine yields much 1,2-Me migration directly from precursor excited states.15 1 An analogous intervention of 1,2-Me migration via RIES was also observed in the photolytic decomposition of f-butylchlorodiazirine (24) to f-butylchlorocarbene (18) cf. Eq. 14.27... 

The thermal decomposition of 91a gave rise to a 2 1 mixture of 92a and 93 in a total yield of 33%. 91b afforded diazoalkane 94 in 76% yield, which was a crystalline compound, whose structure could be determined by X-ray analysis. Besides 94, 92b was produced in trace quantities. However, when the pyrolysis reaction of 91b was carried out at 9 torr, 92b was isolated in 48% yield. Decomposition of 91c resulted also in a 1.4 1 mixture of 92c and 95 in 34% yield, whereas 92d was the sole product (37% yield) of 91d.27... 

It has been known for a long time that the decomposition of diazoalkanes can be catalyzed by transition metal complexes [493-496]. Carbene complexes were proposed as possible intermediates by Yates in 1952 [497]. However, because reactions of diazoalkanes with metal complexes tend to be difficult to control, it was not until 1975 [498] that stable carbene complexes could be directly obtained from diazoalkanes (Figure 3.19). 

Transition metal complexes which react with diazoalkanes to yield carbene complexes can be catalysts for diazodecomposition (see Section 4.1). In addition to the requirements mentioned above (free coordination site, electrophi-licity), transition metal complexes can catalyze the decomposition of diazoalkanes if the corresponding carbene complexes are capable of transferring the carbene fragment to a substrate with simultaneous regeneration of the original complex. Metal carbonyls of chromium, iron, cobalt, nickel, molybdenum, and tungsten all catalyze the decomposition of diazomethane [493]. Other related catalysts are (CO)5W=C(OMe)Ph [509], [Cp(CO)2Fe(THF)][BF4] [510,511], and (CO)5Cr(COD) [52,512]. These compounds are sufficiently electrophilic to catalyze the decomposition of weakly nucleophilic, acceptor-substituted diazoalkanes. 

Because of the high nucleophilicity and reactivity of diazoalkanes, catalytic decomposition occurs readily, not only with a wide range of transition metal complexes but also with Brpnsted or Lewis acids. Well-established catalysts for diazodecomposition include zinc halides [638,639], palladium(II) acetate [640-642], rhodium(II) carboxylates [626,643] and copper(I) triflate [636]. Copper(II)... 

The normal byproducts formed during the transition metal-catalyzed decomposition of diazoalkanes are carbene dimers and azines [496,1023,1329], These products result from the reaction of carbene complexes with the carbene precursor. Their formation can be suppressed by slow addition (e.g. with a syringe motor) of a dilute solution of the diazo compound to the mixture of substrate and catalyst. Carbene dimerization can, however, also be a synthetically useful process. If, e.g., diazoacetone is treated with 0.1% RuClCpIPPhjij at 65 °C in toluene, cw-3-hexene-2,5-dione is obtained in 81% yield with high stereoselectivity [1038]. 

---