Designing electrical installations

Electrical installations at rear of driver s cab Designed, constructed, installed and... [Pg.467]

If the subsequent discovery of a nonconformity will cause minor design, production, installation, or operational problems, you should examine the features and characteristics of the item on a sampling basis. An example of this would be electrical, electronic, or mechanical components. [Pg.382]

RP 14F Recommended Practice for Design and Installation of Electrical Systems for Offshore Production Platforms RP. 500 Recommended Practice for Classification of Locations for Electrical Installations at Petroleum Facilities Classified As Class I, Division 1 and Division 2. [Pg.547]

FPN No. 5) For further information on electrical system for hazardous (classified) locations on offshore oil and gas platforms, see Design and Installation of Electrical Systems for Offshore Production Platforms, ANSl/APl RP 14F-1991. [Pg.638]

Interior wiring design and installation for most commercial and industrial uses should follow the National Electrical Code (NEC) which has been a national standard since 1970 with the passage of the Occupational Safety and Health Act (OSHA). Some localities, however, may not accept the NEC and require that their own (more stringent) standards be followed. [Pg.297]

The lEE Regulations for Electrical Installations recognize the following designations of grounding systems using a two-, three- or four-letter code as follows ... [Pg.227]

Facility electrical systems and components provide a convenient source of ignition within a hydrocarbon or ordinary occupancies whenever the design, installation or maintenance is substandard. Electrical systems or components may short, overheat, operate incorrectly, etc. These failures will present themselves as available ignition sources for hydrocarbon vapor releases. All electrical installation should be according to recognized electrical industry standards such as API RP 540 and the NEC (NFPA 70). [Pg.143]

Institute of Electrical and Electronic Engineers, Inc. (IEEE), IEEE RP 484. Design and Installation of large Lead Storage Batteries for Generating Stations and Substations. IEEE, New York, NY, 1987. [Pg.152]

All electrical equipment and wiring installed in hydrogen gas transmission and distribution compressor stations shall conform to the requirements of NFPA 70, insofar as the equipment commercially available permits. Electrical installations located in hazardous areas, as defined in NFPA 70, and that are to remain in operation during compressor station emergency shutdown, as provided in para. I-1.3.2.1(a), shall be designed to conform to NFPA 70 for Class I, Division 1 requirements. 1-1.3 Compressor Station Equipment... [Pg.168]

Emergency alarm system design and installation should be in accordance with NFPA 72. Electrical aspects of the fire alarm systems should be designed and installed in accordance with NEPA 70. When devices are located in hazardous areas, they should meet the electrical requirements suitable for that hazardous area. [Pg.184]

America s first and foremost supplier of execution hardware. His products include electric chairs, gas chambers, gallows, and lethal injection machines. He offers design, construction, installation, staff training and maintenance. ... [Pg.14]

Economic lot size, 350 Effective interest, 218-222, 224, 241 Efficiency, packing, 702-706 plate, 661-667 pump, 517-518, 520 Ejectors, cost of, 528 Electrical installation, cost of, 174, 807 Electricity, cost of, 815 Electromotive series of metals, 433 Emissivity of surfaces, 582-585 Energy balance, mechanical, 479-480 for reactor design, 715-716 total, 479-480... [Pg.901]

Electrical/mechanical systems for oral communication from and to aseptic areas should be designed and installed to permit effective cleaning and disinfection. [Pg.298]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...