Cyanides amino

Superoxide dismutase (SOD) is a widely distributed enzyme that exists in a variety of forms. The copper-zinc enzyme (Cu,ZnSOD) is primarily located in the cytosol of eukaryotic cells. Mitochondria contain, in the matrix space, a distinctive cyanide-insensitive manganese-containing enzyme (MnSOD) similar to that found in prokaryotes. In addition, a ferrienzyme (FeSOD) has been identified in bacteria that is also insensitive to cyanide. Amino acid sequence homologies indicate two families of superoxide dismutases. One of these is composed of the Cu,ZnSODs and the other of MnSODs and FeSODs. All these superoxide dismutases catalyze the same reaction (2H -H O2 -h OJ H2O2 -t- O2) and with comparable efficiency. 

A more elaborate variation gives a generell amino acid synthesis. If the reaction between an aldehyde and cyanide is done in the presence of ammonia, the product is an a-amino-nitrile ... 

The most general methods for the syntheses of 1,2-difunctional molecules are based on the oxidation of carbon-carbon multiple bonds (p. 117) and the opening of oxiranes by hetero atoms (p. 123fl.). There exist, however, also a few useful reactions in which an a - and a d -synthon or two r -synthons are combined. The classical polar reaction is the addition of cyanide anion to carbonyl groups, which leads to a-hydroxynitriles (cyanohydrins). It is used, for example, in Strecker s synthesis of amino acids and in the homologization of monosaccharides. The ff-hydroxy group of a nitrile can be easily substituted by various nucleophiles, the nitrile can be solvolyzed or reduced. Therefore a large variety of terminal difunctional molecules with one additional carbon atom can be made. Equally versatile are a-methylsulfinyl ketones (H.G. Hauthal, 1971 T. Durst, 1979 O. DeLucchi, 1991), which are available from acid chlorides or esters and the dimsyl anion. Carbanions of these compounds can also be used for the synthesis of 1,4-dicarbonyl compounds (p. 65f.). 

Strecker synthesis (Section 27 4) Method for prepanng amino acids in which the first step is reaction of an aldehyde with ammonia and hydrogen cyanide to give an amino nitnle which IS then hydrolyzed... 

Miscellaneous Reactions. Sodium bisulfite adds to acetaldehyde to form a white crystalline addition compound, insoluble in ethyl alcohol and ether. This bisulfite addition compound is frequendy used to isolate and purify acetaldehyde, which may be regenerated with dilute acid. Hydrocyanic acid adds to acetaldehyde in the presence of an alkaU catalyst to form cyanohydrin the cyanohydrin may also be prepared from sodium cyanide and the bisulfite addition compound. Acrylonittile [107-13-1] (qv) can be made from acetaldehyde and hydrocyanic acid by heating the cyanohydrin that is formed to 600—700°C (77). Alanine [302-72-7] can be prepared by the reaction of an ammonium salt and an alkaU metal cyanide with acetaldehyde this is a general method for the preparation of a-amino acids called the Strecker amino acids synthesis. Grignard reagents add readily to acetaldehyde, the final product being a secondary alcohol. Thioacetaldehyde [2765-04-0] is formed by reaction of acetaldehyde with hydrogen sulfide thioacetaldehyde polymerizes readily to the trimer. 

Synthesis from Aldehydes and Ketones. Treatment of aldehydes and ketones with potassium cyanide and ammonium carbonate gives hydantoias ia a oae-pot procedure (Bucherer-Bergs reactioa) that proceeds through a complex mechanism (69). Some derivatives, like oximes, semicarbazones, thiosemicarbazones, and others, are also suitable startiag materials. The Bucherer-Bergs and Read hydantoia syntheses give epimeric products when appHed to cycloalkanones, which is of importance ia the stereoselective syathesis of amino acids (69,70). 

Synthesis from Thiohydantoins. A modification (71) of the Bucherer-Bergs reaction consisting of treatment of an aldehyde or ketone with carbon disulfide, ammonium chloride, and sodium cyanide affords 2,4-dithiohydantoias (19). 4-Thiohydantoias (20) are available from reaction of amino nitriles with carbon disulfide (72). Compounds (19) and (20) can be transformed iato hydantoias. 

Without other alternatives, the carboxyalkyl radicals couple to form dibasic acids HOOC(CH)2 COOH. In addition, the carboxyalkyl radical can be used for other desired radical reactions, eg, hydrogen abstraction, vinyl monomer polymerization, addition of carbon monoxide, etc. The reactions of this radical with chloride and cyanide ions are used to produce amino acids and lactams employed in the manufacture of polyamides, eg, nylon. 

Phthalocyanine sulfonic acids, which can be used as direct cotton dyes (1), are obtained by heating the metal phthalocyanines in oleum. One to four sulfo groups can be introduced in the 4-position by varying concentration, temperature, and reaction time (103). Sulfonyl chlorides, which are important intermediates, can be prepared from chlorosulfonic acid and phthalocyanines (104). The positions of the sulfonyl chloride groups are the same as those of the sulfonic acids (103). Other derivatives, eg, chlormethylphthalocyanines (105—107), / /f-butyl (108—111), amino (112), ethers (109,110,113—116), thioethers (117,118), carboxyl acids (119—122), esters (123), cyanides (112,124—127), and nitrocompounds (126), can be synthesized. 

Both urea— and melamine—formaldehyde resins are of low toxicity. In the uncured state, the amino resin contains some free formaldehyde that could be objectionable. However, uncured resins have a very unpleasant taste that would discourage ingestion of more than trace amounts. The molded plastic, or the cured resin on textiles or paper may be considered nontoxic. Combustion or thermal decomposition of the cured resins can evolve toxic gases, such as formaldehyde, hydrogen cyanide, and oxides of nitrogen. 

The water solubiUty of zinc compounds varies greatly, as shown in Table 1. Water-soluble compounds not Hsted are zinc formate [557-41-5] chlorate [10361-95-2] fluorosihcate [16871 -71 -9] and thiocyanate [557-42-6]. Also, the water-soluble amino and cyanide complexes have many uses. 

Chemical Properties. Hydrogen cyanide is a weak acid its ionization constant is of the same magnitude as that of the natural amino acids (qv). Its stmcture is that of a linear, triply bonded molecule, HC=N. 

Although a C—CN bond is normally strong, one or two cyano groups in TCNE can be replaced easily, about as easily as the one in an acyl cyanide. The replacing group can be hydroxyl, alkoxyl, amino, or a nucleophilic aryl group. Thus hydrolysis of TCNE under neutral or mildly acidic conditions leads to tricyanoethenol [27062-39-17, a strong acid isolated only in the form of salts (18). 

These dyes aie prepared by the reaction of l-amino-4-nittoanthtaquinone-2-catboxylic acid amide (108) with cyanide in water (119). 

Cyanohydrin Synthesis. Another synthetically useful enzyme that catalyzes carbon—carbon bond formation is oxynitnlase (EC 4.1.2.10). This enzyme catalyzes the addition of cyanides to various aldehydes that may come either in the form of hydrogen cyanide or acetone cyanohydrin (152—158) (Fig. 7). The reaction constitutes a convenient route for the preparation of a-hydroxy acids and P-amino alcohols. Acetone cyanohydrin [75-86-5] can also be used as the cyanide carrier, and is considered to be superior since it does not involve hazardous gaseous HCN and also virtually eliminates the spontaneous nonenzymatic reaction. (R)-oxynitrilase accepts aromatic (97a,b), straight- (97c,e), and branched-chain aUphatic aldehydes, converting them to (R)-cyanohydrins in very good yields and high enantiomeric purity (Table 10). 

In 1959 a new non-protein L-a-amino acid was isolated from the seeds of Acacia willardiana and later from other species of Acacia-, it proved to be l-/3-amino-/3-carboxyethyluracil (977) (59ZPC(316)164). The structure was confirmed by at least four syntheses in the next few years. The most important involves a Shaw synthesis (Section 2.13.3.1.2e) of the acetal (975) and hydrolysis to the aldyhyde (976) followed by a Strecker reaction (potassium cyanide, ammonia and ammonium chloride) to give DL-willardiine (977) after resolution, the L-isomer was identical with natural material (62JCS583). Although not unambiguous, a Principal Synthesis from the ureido acid (978) and ethyl formylacetate is the most direct route (64ZOB407). 

Amino-5-nitrosopyrimidines also condense with benzoylacetonitrile, phenacyl-pyridinium bromide and acetonylpyridinium chloride in the presence of sodium cyanide to produce. 7-amino-6-pteridinyl ketones (63JOC1197). Pteridine syntheses from pyridinium salts are not limited to the preparation of pteridyl ketones since pyridinium acetamide... 

Cyclic a-cyanoketones, when treated with hydroxylamine, yielded 3-amino-4,5,6,7-tetrahydro-2,1-benzisoxazole. This compound could also be obtained by sodium or potassium cyanide interaction with chlorocyclohexanone oxime (Scheme 187) (67AHC(8)277, 66Bail25>. 

The diphenylmaleimide is prepared from the anhydride, 33-87 % yield, and cleaved by hydrazinolysis, 65-75% yield. It is stable to acid (HBr, AcOH, 48 h) and to mercuric cyanide. It is colored and easily located during chromatography, and has been prepared to protect steroidal amines and amino sugars. " ... 

In the Strecker synthesis an aldehyde is converted to an a-amino acid with one more carbon atom by a two-stage procedure in which an a-fflnino nitrile is an intenne-diate. The a-fflnino nitrile is fonned by reaction of the aldehyde with ffliimonia or an fflTtmonium salt and a source of cyanide ion. Hydrolysis of the nitrile group to a carboxylic acid function completes the synthesis. 

Contains Nitrogen.—First test the original solid ni liquid by heating in a hard-glass tube with soda-lime (p. 2), and notice if the smell is that of ammonia (ammonia salt, amide or cyanide), an amine (amine or amino-acid) or a pyridine base (alkaloid). 

In at least one case, the standard Bucherer-Bergs conditions gave rise to oxazole rather hydantoin. Specifically, when 5-benzyloxy-pyridine-2-carbaldehyde (11) was treated with potassium cyanide, ammonium chloride, and ammonium carbonate in boiling ethanol/water, 5-amino-oxazol-2-ol 12 was obtained. Subsequent heating of oxazole 12 with acetic acid at reflux overnight then produced the Bucherer-Bergs product, hydantoin 13. ... 

In summary, the Bucherer-Bergs reaction converts aldehydes or ketones to the corresponding hydantoins. It is often carried out by treating the carbonyl compounds with potassium cyanide and ammonium carbonate in 50% aqueous ethanol. The resulting hydantoins, often of pharmacological importance, may also serve as the intermediates for amino acid synthesis. 

A simple and elegant one-pot synthesis of 3-amino-4-arylfurazans from the corresponding aroyl cyanides was developed by Lakhan and Singh (Scheme 102) [87IJC(B)690]. 

---