Curie effect

Fig. 4. The effect of temperature for Mng 6 Zng 3 Fe Fe on (a) initial magnetic permeabiUty, )J., measured on a polycrystalline toroid appHed as a core for a coil driven by a low (B <0.1 mT) ampHtude, low (10 kHz) frequency sinusoidal signal and (b) magnetocrystalline anisotropy constant, measured on a monocrystalline sphere showing the anisotropy/compensation temperature Tq and the Curie temperature, T. To convert joules to calories, divide by...

From the write and read process sketched so far, some requirements for MO media can be derived (/) a high perpendicular, uniaxial magnetic anisotropy K in order to enable readout with the polar Kerr effect (2) a magnetoopticady active layer with a sufficient figure of merit R 0- where R is the reflectivity and the Kerr angle (T) a Curie temperature between 400 and 600 K, the lower limit to enable stable domains at room temperature and the upper limit because of the limited laser power for writing. 

Figure 10 presents the Curie temperature (T ) vs the TM-content (x) for Co- and Fe-based biaary alloys. Alloying rare-earth elements with small amounts of transition metals (x < 0.2) leads to a decrease ia Curie temperature. This is particularly obvious ia the Gd—Co system where it corresponds to a nonmagnetic dilution similar to that of Cu (41,42). This iadicates that TM atoms experience no exchange coupling unless they are surrounded by a minimum number j of other TM atoms. The critical number is j = 5 for Fe and j = 7 for Co. The steep iacrease of for Co-based alloys with x about 0.7 is based on this effect. 

Fig. 3. Effect of siHcon on properties of iron (10). = Curie temperature = magnetocrystaUine anisotropy constant. To convert T to G, multiply by...

The detrimental effects of Si addition are (/) Si iacreases the yield strength and decreases the ductiHty of iron such that commercial-grade materials are limited to ca 4% Si, and (2) as shown ia Eigure 3, the saturation iaduction and Curie temperature are decreased with increasing siHcon content. 

Potassium Phosphates. The K2O—P20 —H2O system parallels the sodium system in many respects. In addition to the three simple phosphate salts obtained by successive replacement of the protons of phosphoric acid by potassium ions, the system contains a number of crystalline hydrates and double salts (Table 7). Monopotassium phosphate (MKP), known only as the anhydrous salt, is the least soluble of the potassium orthophosphates. Monopotassium phosphate has been studied extensively owing to its piezoelectric and ferroelectric properties (see Ferroelectrics). At ordinary temperatures, KH2PO4 is so far above its Curie point as to give piezoelectric effects in which the emf is proportional to the distorting force. There is virtually no hysteresis. 

Ceramics that display the pyroelectric effect also exhibit a variatioa ia polarizatioa with temperature, as showa ia Figure 2. The aature of the temperature variatioa is depeadeat oa the type of crystallographic transformatioa that the material displays at the Curie poiat ie, whether the transitioa is first or secoad order. 

The above discussion ignores all paramagnetic effects including band paramagnetism. Evidence for a Curie-like contribution is seen at low temperatures in some of the curves displayed in Fig. 5 and could arise, in part, from paramagnetic impurities (see below). 

Piezoelectric energy is a form of electric energy produced by certain solid materials when they are deformed. (The word piezo has its roots in the Greek word piezein meaning to press. ) Discovery of the piezoelectric effect is credited to Pierre and Jacques Curie who observed in 1880 that certain quartz crystals produced electricity when put under pressure. 

Crystals with one of the ten polar point-group symmetries (Ci, C2, Cs, C2V, C4, C4V, C3, C3v, C(, Cgv) are called polar crystals. They display spontaneous polarization and form a family of ferroelectric materials. The main properties of ferroelectric materials include relatively high dielectric permittivity, ferroelectric-paraelectric phase transition that occurs at a certain temperature called the Curie temperature, piezoelectric effect, pyroelectric effect, nonlinear optic property - the ability to multiply frequencies, ferroelectric hysteresis loop, and electrostrictive, electro-optic and other properties [16, 388],... 

An evaluation of the retardation effects of surfactants on the steady velocity of a single drop (or bubble) under the influence of gravity has been made by Levich (L3) and extended recently by Newman (Nl). A further generalization to the domain of flow around an ensemble of many drops or bubbles in the presence of surfactants has been completed most recently by Waslo and Gal-Or (Wl). The terminal velocity of the ensemble is expressed in terms of the dispersed-phase holdup fraction and reduces to Levich s solution for a single particle when approaches zero. The basic theoretical principles governing these retardation effects will be demonstrated here for the case of a single drop or bubble. Thermodynamically, this is a case where coupling effects between the diffusion of surfactants (first-order tensorial transfer) and viscous flow (second-order tensorial transfer) takes place. Subject to the Curie principle, it demonstrates that this retardation effect occurs on a nonisotropic interface. Therefore, it is necessary to express the concentration of surfactants T, as it varies from point to point on the interface, in terms of the coordinates of the interface, i.e.,... 

The overall set of partial differential equations that can be considered as a mathematical characterization of the processing system of gas-liquid dispersions should include such environmental parameters as composition, temperature, and velocity, in addition to the equations of bubble-size and residence-time distributions that describe the dependence of bubble nucleation and growth on the bubble environmental factors. A simultaneous solution of this set of differential equations with the appropriate initial and boundary conditions is needed to evaluate the behavior of the system. Subject to the Curie principle, this set of equations should include the possibilities of coupling effects among the various fluxes involved. In dispersions, the possibilities of couplings between fluxes that differ from each other by an odd tensorial rank exist. (An example is the coupling effect between diffusion of surfactants and the hydrodynamics of bubble velocity as treated in Section III.) As yet no analytical solution of the complete set of equations has been found because of the mathematical difficulties involved. To simplify matters, the pertinent transfer equation is usually solved independently, with some simplifying assumptions. 

The calculated energy of interaction of an atomic moment and the Weiss field (0.26 uncoupled conduction electrons per atom) for magnetic saturation is 0.135 ev, or 3070 cal. mole-1. According to the Weiss theory the Curie temperature is equal to this energy of interaction divided by 3k, where k is Boltzmann s constant. The effect of spatial quantization of the atomic moment, with spin quantum number S, is to introduce the factor (S + 1)/S that is, the Curie temperature is equal to nt S + l)/3Sk. For iron, with 5 = 1, the predicted value for the Curie constant is 1350°K, in rough agreement with the experimental value, 1043°K. 

An obvious refinement of the simple theory for cobalt and nickel and their alloys can be made which leads to a significant increase in the calculated value of the Curie temperature. The foregoing calculation for nickel, for example, is based upon the assumption that the uncoupled valence electrons spend equal amounts of time on the nickel atoms with / = 1 and the nickel atoms with J = 0. However, the stabilizing interaction of the spins of the valence electrons and the parallel atomic moments would cause an increase in the wave function for the valence electrons in the neighborhood of the atoms with / = 1 and the parallel orientation. This effect also produces a change in the shape of the curve of saturation magnetization as a function of temperature. The details of this refined theory will be published later. 

A nice derivation is given by Dr. Pascal Man, Directeur de recherche, CNRS, Universite Pierre et Marie Curie-Paris 6 at his web site http //www.pascal-man.coni/tensor-quadmpole-interaction/ V20-static.shtml. The Mathematica-5 script is also given and can be used for solving the first order Hamiltonian to explain quadmpole effects in high-field NMR spectra. 

---