Corrected State

Condenser rating is correctly stated as the rate of heat rejection. Some manufacturers give ratings in terms of the evaporator load, together with a de-rating factor, which depends on the evaporating and condensing temperatures. 

Commissioning is the completion stage of a contract, when the contractor considers that the plant is in a correct state to hand over and the purchaser considers that it is in a correct state to accept and pay for. 

Numerous types of GC injectors have been manufactured over the past four decades. The most commonly used injection techniques have been reviewed and described by Grob, who correctly states that analysts must fully understand the techniques before they can make the most appropriate choice for their particular application(s). For most GC capillary column applications, the split/splitless, programmed-temperature vaporization (PTV) and on-column injectors remain the most popular. However, over the last few years, technology has progressed rapidly to provide injectors that allow more of the sample extract on to the GC column without overloading it. 

As Einhellig (48) correctly stated, "Unless cooperative research between chemists and physiologists is conducted, we will continue to be left with the notion that an array of simple phenols cannon to a wide array of soils and situations are the major chemical allelopa-thic agents." As for the importance of the chemical identity, Putnam and Duke (17) expressed it very well "after all chemicals are identified, studies can be made on genetics, specificity, environmental influences and environmental consequences."... 

The merit of Malinin s work is the comparative study of water content of bones by reproducible methods. The measurement of water vapor pressure during the drying cannot be used dirctly to determine the RM, as Malinin correctly states. Measurement of the description rates (DR) provide a means to follow quantitatively the course of desorption drying. The method is described in Section 1.2.2, but cannot be applied in an installation used by Malinin because the condenser cannot be separated from the chamber by a valve. By using the data given in the paper of Malinin it is possible to estimate the freeze drying process of bone transplants as follows ... 

A nonmetal may adopt any oxidation number between the values predicted in the preceding two paragraphs. The only exceptions are fluorine, which is only -1 in compounds, and helium, neon, and argon, which have no known compounds. When there is a choice of oxidation states, there must be additional information available in order to allow you to choose the correct state. 

It was a hue shock to Astrid and myself when we learned last Sunday night that Hitoshi has passed away. This is a tremendous loss for our whole community. As yon correctly state, we had seen him in Tokyo twice, namely at October 12 and 13, when he attended both of my lectures. He was in good mood and spirit and we had in fact intense scientific discnssions about the chelate effect and this continued until November 3, when he sent me his last mail. We all definitely lost a veiy dear friend. Of conrse, Astrid and I have immediately written to his wife Ei... and as you say, at this time we can only pray for his sonl. 

Interview with MAJ Ketchum. His note Reflexes slower - felt he couldn t do his job. Serial 7 s tested and performed slowly. Repeated four part sentence correctly. Stated, I feel a little unsteady. With eyes closed, a little more unsteady Went to sleep immediately after lying down. 

The plant s federal Identification (ID) Number must be correctly stated. The plant s specific location must have an ID number to use the manifest. 

Enzymes normally operate within an optimal pH range in which the important amino acids of the active site have the correct state of protonation. 

The ideal gas equation, P / — nRT, stems from three relationships known to be true for gases 1 point for correctly stating the formula for the ideal gas equation. 

The literature published up to 1940 shows that the basic problems of designing successful liquid propellant engines were correctly stated,... 

Check if the specifications supplied by the manufacturer are correct. State any assumptions you make in your evaluation of the data. 

In order to define the correct state space for a qubit, one must determine... 

The structure is not compliant with chemical conventions, but the chemistry intelligence logic can automatically correct them and the compound transitions to the Corrected State. 

If the structure is automatically corrected by the chemistry intelligence logic, the compound moves into the Corrected State. At this point, the... 

As an example of the connection between perturbation theory wave function corrections and polarizability, we now calculate the linear polarizability, ax. The states are corrected to first order in H. Since the polarization operator (Zx) is field independent, polarization terms linear in the electric field arise from products of the unperturbed states and their first-order corrections from the dipole operator. The corrected states are [12]... 

Rigorous and stiff batch distillation models considering mass and energy balances, column holdup and physical properties result in a coupled system of DAEs. Solution of such model equations without any reformulation was developed by Gear (1971) and Hindmarsh (1980) based on Backward Differentiation Formula (BDF). BDF methods are basically predictor-corrector methods. At each step a prediction is made of the differential variable at the next point in time. A correction procedure corrects the prediction. If the difference between the predicted and corrected states is less than the required local error, the step is accepted. Otherwise the step length is reduced and another attempt is made. The step length may also be increased if possible and the order of prediction is changed when this seems useful. 

Minimal Configuration Interaction.—A minimum requirement of a potential energy surface is that the wavefunction continuously describe the system as the reaction takes place, producing reactants and products in their correct states. In order for this situation to be obtained, the correlation error must either be taken fully into account or at the very least, be approximately constant over that portion of the potential energy surface under consideration. As discussed and illustrated in the previous section, one should at least perform a limited configuration interaction in which those configurations needed to provide the correct description of the dissociation products are included. 

---