Copper ions, complex-formation

If, however, phosphoric acid is used, the iron(III) ions are rapidly removed from the column, and a sharp separation results. Subsequently, the copper(II) ions can be removed with hydrochloric acid. Clearly the phosphate ions form a much more stable complex with iron(III) ions, which are rendered colourless, than with copper(II). Complex formation is undoubtedly an important factor in other types of chromatography, particularly in inorganic separations on paper, but in no other technique has it been exploited to quite the same extent as in ion-exchange chromatography. 

The anhydrous chloride is prepared by standard methods. It is readily soluble in water to give a blue-green solution from which the blue hydrated salt CuClj. 2H2O can be crystallised here, two water molecules replace two of the planar chlorine ligands in the structure given above. Addition of dilute hydrochloric acid to copper(II) hydroxide or carbonate also gives a blue-green solution of the chloride CuClj but addition of concentrated hydrochloric acid (or any source of chloride ion) produces a yellow solution due to formation of chloro-copper(ll) complexes (see below). 

The concentration of copper(I) ion remaining ia solution is not appreciable. However, aqueous copper(I) ion can be stabilized by complex formation with various agents such as chloride, ammonia, cyanide, or acetonitrile. 

K has the value of about 1 x 10 at 298 K, and in solutions of copper ions in equilibrium with metallic copper, cupric ions therefore greatly predominate (except in very dilute solutions) over cuprous ions. Cupric ions are therefore normally stable and become unstable only when the cuprous ion concentration is very low. A very low concentration of cuprous ions may be produced, in the presence of a suitable anion, by the formation of either an insoluble cuprous salt or a very stable complex cuprous ion. Cuprous salts can therefore exist in contact with water only if they are very sparingly soluble (e.g. cuprous chloride) or are combined in a complex, e.g. [Cu(CN)2) , Cu(NH3)2l. Cuprous sulphate can be prepared in non-aqueous conditions, but because it is not sparingly soluble in water it is immediately decomposed by water to copper and cupric sulphate. 

A further factor which must also be taken into consideration from the point of view of the analytical applications of complexes and of complex-formation reactions is the rate of reaction to be analytically useful it is usually required that the reaction be rapid. An important classification of complexes is based upon the rate at which they undergo substitution reactions, and leads to the two groups of labile and inert complexes. The term labile complex is applied to those cases where nucleophilic substitution is complete within the time required for mixing the reagents. Thus, for example, when excess of aqueous ammonia is added to an aqueous solution of copper(II) sulphate, the change in colour from pale to deep blue is instantaneous the rapid replacement of water molecules by ammonia indicates that the Cu(II) ion forms kinetically labile complexes. The term inert is applied to those complexes which undergo slow substitution reactions, i.e. reactions with half-times of the order of hours or even days at room temperature. Thus the Cr(III) ion forms kinetically inert complexes, so that the replacement of water molecules coordinated to Cr(III) by other ligands is a very slow process at room temperature. 

Fast sulphon black F ( C.I.26990). This dyestuff is the sodium salt of 1-hydroxy-8-( 2-hydroxynaphthylazo) -2- (sulphonaphthylazo) -3,6-disulph onic acid. The colour reaction seems virtually specific for copper ions. In ammoniacal solution it forms complexes with only copper and nickel the presence of ammonia or pyridine is required for colour formation. In the direct titration of copper in ammoniacal solution the colour change at the end point is from magenta or [depending upon the concentration of copper(II) ions] pale blue to bright green. The indicator action with nickel is poor. Metal ions, such as those of Cd, Pb, Ni, Zn, Ca, and Ba, may be titrated using this indicator by the prior addition of a reasonable excess of standard copper(II) solution. 

The data for the 1,2-diaminoethane complexes now parallels the trends in ionic radius and LFSE rather closely, except for the iron case, to which we return shortly. What is happening Copper(ii) ions possess a configuration, and you will recall that we expect such a configuration to exhibit a Jahn-Teller distortion - the six metal-ligand bonds in octahedral copper(ii) complexes are not all of equal strength. The typical pattern of Jahn-Teller distortions observed in copper(ii) complexes involves the formation of four short and two long metal-ligand bonds. 

The rate of peroxide decomposition and the resultant rate of oxidation are markedly increased by the presence of ions of metals such as iron, copper, manganese, and cobalt [13]. This catalytic decomposition is based on a redox mechanism, as in Figure 15.2. Consequently, it is important to control and limit the amounts of metal impurities in raw rubber. The influence of antioxidants against these rubber poisons depends at least partially on a complex formation (chelation) of the damaging ion. In favor of this theory is the fact that simple chelating agents that have no aging-protective activity, like ethylene diamine tetracetic acid (EDTA), act as copper protectors. 

The direction of the potential shift of the surface C-N band is the same as for the C-O band on Pt and the shift rates are ca. 30 cm 1/V for Ag and Au (22,23,25) and ca. 45 cm-1/V for Cu (33). The measurement for copper is less accurate due to formation of ion complexes with large absorption crossections and the relatively weak signal from the surface species itself. 

Another terminal bidentate ligand that has been exploited occasionally in bright disazo direct dyes is the sulphated 8-hydroxyquinoline residue (5.15). On aftercoppering, fastness to light and wet tests is enhanced by hydrolysis catalysed by the copper(II) ion and formation of a bidentate 1 2 complex (Scheme 5.3). Apparently, electron withdrawal by sulphur facilitates removal of the sulphite grouping and approach of the copper(II) cation [10]. 

Nucleophilic displacement of halogen by amines is an important method of introducing amino groups into the anthraquinone ring system. In the Ullmann reaction the displacement is catalysed by metallic copper or by copper ions so that relatively mild conditions can be used. Mechanistic studies suggest that copper(I) ions exert a catalytic effect via complex formation. Derivatives of 1,4-diaminoanthraquinone are of considerable industrial significance. Many compounds are prepared from the reduced form of quinizarin (6.6). 

In contrast to Bosman et al., who only found metal complexation in the periphery of polypropylene imine) dendrimers, Tomalia and co-workers reported on the incorporation of copper ions into the interior of PAMAM dendrimers judging from EPR and UV/Vis studies [220, 221]. Metal binding in the dendrimer interior has also been observed for dendrimers carrying multiple ligands for metal complexation within their framework such as crown-ethers [222, 223] (Cs(I)-complexes), piperazine [224] (Pd(II)- and Cu(II)-complexes) or triazocyclononane [225] (Cu(II)- and Ni(II)-complexes). In most cases addition of the metal-salt to the dendrimer led to the formation of 1 1 complexes. 

Another type of inhibitor combines with the enzyme at a site which is often different from the substrate-binding site and as a result will inhibit the formation of the product by the breakdown of the normal enzyme-substrate complex. Such non-competitive inhibition is not reversed by the addition of excess substrate and generally the inhibitor shows no structural similarity to the substrate. Kinetic studies reveal a reduced value for the maximum activity of the enzyme but an unaltered value for the Michaelis constant (Figure 8.7). There are many examples of non-competitive inhibitors, many of which are regarded as poisons because of the crucial role of the inhibited enzyme. Cyanide ions, for instance, inhibit any enzyme in which either an iron or copper ion is part of the active site or prosthetic group, e.g. cytochrome c oxidase (EC 1.9.3.1). 

Exactly the same problem arises with the recent studies of NiO solubility by Tremaine and Leblanc (25) and again the thermodynamic data on the aqueous anionic species at 300 C are likely to be more reliable than on the Ni + ion. There is good spectroscopic evidence for complex formation in chlorides of nickel (II), (26) cobalt (II) (27), and copper (II) (28) at 300°C and above. Most of the work was done at rather high Cl concentrations but qualitatively the effects of dielectric constant and concentration are as expected. A noteworthy feature (which estimation procedures will have to allow for) is the change from 6 to 4 coordination at the lower pressures (150-300 bar) and the higher Cl concentrations. This change appears to take place with only 2 or 3 Cl ions coordinated to the metal (at least in the case of Ni(II)). 

A chiral amino-acid/copper complex is bound to a silica- or polymeric stationary phase and copper ions are included in the mobile phase to ensure there is no loss of copper. Amino acids then may be separated by the formation of diastereomeric copper complexes. Water stabilizes the complex by coordinating in an axial position. Steric factors then determine which of the two complexes is more stable. One of the water molecules is usually sterically hindered from coordinating with the copper. i ... 

In summary, the copper ion transfers an electron from the unsaturated substrate to the diazo-nium cation, and the newly formed diazonium radical quickly loses nitrogen. The aryl radical formed attacks the ethylenic bond within the active complexes that originated from aryldiazo-nium tetrachlorocuprate(II)-olefin or initial arydiazonium salt-catalyst-olefln associates and yields >C(Ar)-C < radical. The latter was detected by the spin-trap ESR spectroscopy. The formation of both the cation-radical [>C=C<] and radical >C(Ar)-C < as intermediates indicates that the reaction involves two catalytic cycles. In the other case, radical >C(Ar)-C < will not be formed, being consumed in the following reaction ... 

---