Copper halide, catalysis

In contrast to the situation with copper-based catalysis, most studies on ruthenium-based catalysts have made use of preformed metal complexes. The first reports of ruthenium-mediated polymerization by Sawamoto and coworkers appeared in I995.26 In the early work, the square pyramidal ruthenium (II) halide 146 was used in combination with a cocatalyst (usually aluminum isopropoxide). 

Recently, Co(III)-allyl complexes have been described to be sulfonylated regiospecifi-cally by sulfonyl halides under irradiation (equation 42). Similarly, allyl methyl sulfone has been obtained from allyltrimethylsilane under copper(I) catalysis ... 

Under copper(l) catalysis, excellent yields of dithioesters were obtained at -50°C, and t-alkyl magnesium halides, which led mainly to polymeric products without catalysis, gave yields above 90% in the presence of a catalytic amount (5-10 mol%) of copper(i) bromide [148]. 

Some examples to illustrate these categories are listed in Table 8.1. Many examples of reactions between organomagnesium compounds and organic halides are tabulated in General Ref. [A] it should be noted, however, that for many of the earlier experiments, transition metals may have been present as impurities in the magnesium used. While under some circumstances transition metal catalysis may be beneficial, under the conditions commonly used in the early experiments it usually led to a proliferation of products. For reactions with primary alkyl and allylic halides, catalysis with copper(i) salts is often beneficial examples of such reactions are also shown in Table 8.1 and a procedure follows. 

Meenvein reaction [1, 166, before references]. The arylation of olefinic com pounds by diazonium halides with copper salt catalysis was discovered by Meerweit (1939).8 Cupric chloride has been usually employed. Cleland,9 however, prefers cuprous bromide (MCB reagent grade) and recommends that the salt (light green) be washed with acetone until the washings are colorless and then with benzene and then with hexane. The resulting solid is dried at 120° and is only faintly colored. He... 

Intramolecular displacement of an orf/to-halogen can be achieved at high temperature or with copper(I)-catalysis. " Palladium-catalysed aminations of halide can be used to form either the N-C-2 or N-C-7a links, or both, for example in the double displacement shown below. ... 

A three-component cross-coupling of A-tosylhydrazones, terminal alkynes and allyl halides yields allyl allenes, using copper(I) catalysis a copper carbene migratory insertion is proposed. 27... 

The copper-halide complexes are precursors to the catalytically active species generated upon addition of the Grignard reagents. To determine their stmcture, detailed and H-NMR spectroscopic studies were carried out at —60°C. On the basis of these experiments, it was inferred that the monomeric complex C2, relevant for catalysis, is formed from complex Cl and the Grignard reagent (MeMgBr) (Scheme 31). 

For example the coupling reactions of aryl halides, classically based on copper metal catalysis (Ullmann coupling), can now be advantageously realized when using Ni(0) or Pd(0) reagents, transient aryl metal derivatives being formed as reactive intermediates. 

This reaction is similar to 13-1 and, like that one, generally requires activated substrates. With unactivated substrates, side reactions predominate, though aryl methyl ethers have been prepared from unactivated chlorides by treatment with MeO in HMPA. This reaction gives better yields than 13-1 and is used more often. A good solvent is liquid ammonia. The compound NaOMe reacted with o- and p-fluoronitrobenzenes 10 times faster in NH3 at — 70°C than in MeOH. Phase-transfer catalysis has also been used. The reaction of 4-iodotoluene and 3,4-dimethylphenol, in the presence of a copper catalyst and cesium carbonate, gave the diaryl ether (Ar—O—Ar ). Alcohols were coupled with aryl halides in the presence of palladium catalysts to give the Ar—O—R ether. Nickel catalysts have also been used. ... 

The reaction with ammonia or amines, which undoubtedly proceeds by the SnAt mechanism, is catalyzed by copper and nickel salts, though these are normally used only with rather unreactive halides. This reaction, with phase-transfer catalysis, has been used to synthesize triarylamines. Copper ion catalysts (especially cuprous oxide or iodide) also permit the Gabriel synthesis (10-61) to be... 

Direct nucleophilic displacement of halide and sulfonate groups from aromatic rings is difficult, although the reaction can be useful in specific cases. These reactions can occur by either addition-elimination (Section 11.2.2) or elimination-addition (Section 11.2.3). Recently, there has been rapid development of metal ion catalysis, and old methods involving copper salts have been greatly improved. Palladium catalysts for nucleophilic substitutions have been developed and have led to better procedures. These reactions are discussed in Section 11.3. 

It has been found that a number of bidentate ligands greatly expand the scope of copper catalysis. Copper(I) iodide used in conjunction with a chelating diamine is a good catalyst for amidation of aryl bromides. Of several diamines that were examined, rra s-yV,yV -dimethylcyclohexane-l,2-diamine was among the best. These conditions are applicable to aryl bromides and iodides with either ERG or EWG substituents, as well as to relatively hindered halides. The nucleophiles that are reactive under these conditions include acyclic and cyclic amides.149... 

Although the preparation has been repeated, there have been no other reports of the type of reaction, (described in 1923) in which carbazole in the presence of excess potassium hydroxide and nitrobenzene at only 50°C gave a good yield of 9-(4-nitrophenyl)-carbazole, presumably via an adduct such as 43 subsequently oxidized by excess nitrobenzene and/or air. More recent examples of N-arylation of carbazoles have involved copper catalysis in reaction of aryl halides with carbazoles. Thus, copper bronze and potassium carbonate heated with the carbazole and the appropriate aromatic halide have produced 9-(4-methoxyphenyl)- and 9-(2-tolyl)carbazoles 9-(4-phenylphenyl)carbazole, l,4-di(carbazol-9-yl)benzene, 4,4 -di(carbazol-9-yl)biphenyl, and 9-(2-pyridyl)- and 9-(2-quinolyl)carbazoles 9-[2-(2-phenylphenyl)phenyl]- and 9-[2-(4-methylphenyl)phenyl] carbazoles 9-(3-bromo-6-nitrophenyl)-, 9-[3-(carbazol-9-yl]-, 9-(2-nitrophenyl)-, 9-(4-methyl-2-nitrophenyl)-, 9-(4-methoxycarbonyl)-l-nitro-, and l-nitro-9-(4-tolyl)carbazoles 9-(2-methoxycarbonylphenyl)carbazole 9-[2- 2-... 

Electrophiles also react at C-5 of 1,3-dioxin-4-ones. Two ways of activation have been reported (1) magnesiation of 5-iodo-l,3-dioxin-4-ones afforded the Grignard reagents which can be cross-coupled with allyl halides in the presence of copper cyanide <2001TL6847> or with iodoalkenes under Pd(0) catalysis <2002T4787> and (2) Sc(OTf)3-catalyzed reaction of a side-chain-hydroxylated l,3-dioxin-4-one with aldehydes provided the bicyclic dioxinone in 60-85% yield (Scheme 27) <20050L1113>. 

---