Copper continued importance

Properties of T2O. Some important physical properties of T2O are Hsted in Table 2. Tritium oxide [14940-65-9] can be prepared by catalytic oxidation of T2 or by reduction of copper oxide using tritium gas. T2O, even of low (2—19% T) isotopic abundance, undergoes radiation decomposition to form HT and O2. Decomposition continues, even at 77 K, when the water is fro2en. Pure tritiated water irradiates itself at the rate of 10 MGy/d (10 rad/d). A stationary concentration of tritium peroxide, T2O2, is always present (9). AH of these factors must be taken into account in evaluating the physical constants of a particular sample of T2O. 

Yullj Additive Method. No electrolytic plating step is used ia the fully additive process. The copper circuit is formed directly on the board without a continuous copper film. Heavy-build electroless coppers are used to iacrease the final thickness of the entire circuit. This process is much more difficult to control than the others. Additive processiag is becoming increasingly important ia high aspect ratio, very small diameter through-holes that caimot be easily electrolyticaHy plated. 

Estimates of the earliest use of copper vary, but 5000 BC is not unreasonable. By about 3500 BC it was being obtained in the Middle East by charcoal reduction of its ores, and by 3000 BC the advantages of adding tin in order to produce the harder bronze was appreciated in India, Mesopotamia and Greece. This established the Bronze Age , and copper has continued to be one of man s most important metals. 

Secondly, under certain conditions copper may suffer intense localised pitting corrosion, leading sometimes to perforation of the tube, in quite a short time. This form of attack is not common and depends on a combination of unusual circumstances, one of which is the possession by the tube of a fairly, but not entirely, continuous film or scale that is cathodic to the copper pipe in the supply water this can set up corrosion at the small anodes of bare copper exposed at faults or cracks in the film. Carbon films give rise to such corrosion, but since 1950, when the importance of carbon films was... 

The NO/NO+ and NO/NO- self-exchange rates are quite slow (42). Therefore, the kinetics of nitric oxide electron transfer reactions are strongly affected by transition metal complexes, particularly by those that are labile and redox active which can serve to promote these reactions. Although iron is the most important metal target for nitric oxide in mammalian biology, other metal centers might also react with NO. For example, both cobalt (in the form of cobalamin) (43,44) and copper (in the form of different types of copper proteins) (45) have been identified as potential NO targets. In addition, a substantial fraction of the bacterial nitrite reductases (which catalyze reduction of NO2 to NO) are copper enzymes (46). The interactions of NO with such metal centers continue to be rich for further exploration. 

The solvent method may also be performed either by continuous (in cascades) or by batch operation. Continuous techniques in particular have gained considerable technical importance. A phthalonitrile/copper chloride solution is typically treated at 120 to 140°C in a flow tube furnace and the temperature subsequently increased to 180 to 250°C. The entire process requires approximately 1.5 to 2 hours and affords the pigment in practically quantitative yield. The excellent purity of the product eliminates the need for additional purification with dilute acid or base prior to finishing, a procedure which plays a major role in the baking process. These... 

---