Molding composition

Modell-sand, m. molding sand facing sand, -stoff, 7n. modeling composition, molding material. [Pg.302]

Liquid Composite Molding (LCM) is the common name for several similar processes for the manufacturing of polymeric fiber reinforced composites. Widely used processes that belong to this class are Resin Transfer Molding (RTM), Vacuum-Assisted Resin Injection (VARI), and Structural-Reaction Injection Molding (S-RIM). [Pg.359]

The thermal properties (i.e., density, specific heat capacity, and thermal conductivity) have a particularly strong influence on the curing behavior. The exothermal peak temperature is one example It can differ significantly between a composite mold with low thermal mass and a metal mold [35], A more thorough discussion of pros and cons of different mold materials can be found in Morena [37]. [Pg.382]

Morena, J.J. Advanced Composite Mold Making (1988) Van Nostrand Reinhold, New York... [Pg.387]

Aromatic amines are widely used as curing agents for epoxy resins. However, they are not used as widely in adhesive formulations as they are in composites, molding compounds, and castings. They offer cured epoxy structures with good heat and acid resistance. [Pg.96]

The latest trend in foamed composites is automotive structural parts produced by the SRIM (structural reaction-injection-molding) process. The SRIM process is a method of the reactive liquid injection molding (i.e., LIM). LIM includes RIM (reaction injection molding), RRIM (reinforced RIM) and RTM (resin transfer molding). IX M (Liquid Composite Molding) is a relatively new technical term which includes SRIM, RRIM and RTM (Resin Transfer Molding). [Pg.169]

Liquid composite molding (LCM) processes such as resin transfer molding (RTM) have been long established in the automotive and aerospace industries as versatile technologies for manufacturing medium to large composite parts with complex geometries at low cost. All LCM processes involve the injection of a liquid resin into a dry fiber perform, and are... [Pg.2317]

Figure 6. Two-Shot Process Second shot composite molding.

Mono-Coat . [Chem-Trend Chem-Trend A/S] Solvent-based mold release system for use on laminates, composite molding, rubber molding, mold conditioning. [Pg.237]