Cinnamaldehyde, 1,2-additions

As shown in the case of cinnamaldehyde, addition to the carbonyl functionality occurs in preference to attack at the electron-poor double bond. The extent to which stereogenic aldehydes can control the stereochemical course of these cycloadditions is discussed in Section 1.6.1.2.3.2. The success of the tin-based cocatalyst to induce reaction is explained in terms of the formation of an intermediate stannyl ether which exhibits greater reactivity towards 7t-allyl palladium cations than free alkoxide ions. The addition to ketones is less general and one of the more successful examples is given. 

Physical and Chemical Properties. The (F)- and (Z)-isomers of cinnamaldehyde are both known. (F)-Cinnamaldehyde [14371-10-9] is generally produced commercially and its properties are given in Table 2. Cinnamaldehyde undergoes reactions that are typical of an a,P-unsaturated aromatic aldehyde. Slow oxidation to cinnamic acid is observed upon exposure to air. This process can be accelerated in the presence of transition-metal catalysts such as cobalt acetate (28). Under more vigorous conditions with either nitric or chromic acid, cleavage at the double bond occurs to afford benzoic acid. Epoxidation of cinnamaldehyde via a conjugate addition mechanism is observed upon treatment with a salt of /-butyl hydroperoxide (29). 

Manufacture. Cinnamaldehyde is routinely produced by the base-cataly2ed aldol addition of ben2aldehyde /7(9(9-with acetaldehyde [75-07-0], a procedure which was first estabUshed in the nineteenth century (31). Formation of the (H)-isomer is favored by the transition-state geometry associated with the elimination of water from the intermediate. The commercial process is carried out in the presence of a dilute sodium hydroxide solution (ca 0.5—2.0%) with at least two equivalents of ben2aldehyde and slow addition of the acetaldehyde over the reaction period (32). 

A 500-ml, three-necked, round-bottom flask is equipped with a condenser, a dropping funnel, and a thermometer in the reaction mixture. In the flask is placed a mixture of 85% hydrazine (115 ml, 118 g) and 225 ml of 95% ethanol with a few boiling chips. The solution is brought to reflux (mantle) and cinnamaldehyde (100 g, 0.76 mole) is added dropwise over about 30 minutes followed by an additional 30 minutes of refluxing. A still head is attached to the flask and volatiles (ethanol, water, hydrazine hydrate) are slowly distilled at atmospheric pressure until the pot temperature reaches 200° (about 3 hours). Hereafter, phenylcyclopropane is collected over the range 170-180°. When the pot temperature exceeds 250°, the recovery is complete. The crude product (55-65 g) is washed twice with 50-ml portions of water and dried (anhydrous potassium carbonate). Distillation under vacuum through a short column affords the product, bp 60°/13 mm, 79-80°/37 mm, n f 1.5309, about 40 g (45%). 

Reduction of unsaturated carbonyl compounds to the saturated carbonyl is achieved readily and in high yield. Over palladium the reduction will come to a near halt except under vigorous conditions (73). If an aryl carbonyl compound, or a vinylogous aryl carbonyl, such as in cinnamaldehyde is employed, some reduction of the carbonyl may occur as well. Carbonyl reduction can be diminished or stopped completely by addition of small amounts of potassium acetate (i5) to palladium catalysts. Other effective inhibitors are ferrous salts, such asferroussulfate, at a level of about one atom of iron per atom of palladium. The ferrous salt can be simply added to the hydrogenation solution (94). Homogeneous catalysts are not very effective in hydrogenation of unsaturated aldehydes because of the tendencies of these catalysts to promote decarbonylation. 

In order to synthesize 1,3-diphenyl-l, 3-diamines 3 containing a C2 axis of symmetry, which can be employed as auxiliaries and controller groups in asymmetric syntheses, the diastereoselective addition of organometallic reagents to racemic pyrazolines 2, prepared from cinnamaldehyde (l)23, was investigated. 

The lithio-derivative derived from cyclohexyl phenyl sulfone underwent 1,2-addition to cyclohexenylideneacetaldehyde or cinnamaldehyde to give the corresponding / -hydroxysulfones387. Reactions of 2,2-dimethyl-4-lithio-1,3-oxathiane 3,3-dioxide 308... 

CHROMIUM TRIOXIDE-PYRIDINE COMPLEX, preparation in situ, 55, 84 Chrysene, 58,15, 16 fzans-Cinnamaldehyde, 57, 85 Cinnamaldehyde dimethylacetal, 57, 84 Cinnamyl alcohol, 56,105 58, 9 2-Cinnamylthio-2-thiazoline, 56, 82 Citric acid, 58,43 Citronellal, 58, 107, 112 Cleavage of methyl ethers with iodotri-methylsilane, 59, 35 Cobalt(II) acetylacetonate, 57, 13 Conjugate addition of aryl aldehydes, 59, 53 Copper (I) bromide, 58, 52, 54, 56 59,123 COPPER CATALYZED ARYLATION OF /3-DlCARBONYL COMPOUNDS, 58, 52 Copper (I) chloride, 57, 34 Copper (II) chloride, 56, 10 Copper(I) iodide, 55, 105, 123, 124 Copper(I) oxide, 59, 206 Copper(ll) oxide, 56, 10 Copper salts of carboxylic acids, 59, 127 Copper(l) thiophenoxide, 55, 123 59, 210 Copper(l) trifluoromethanesulfonate, 59, 202... 

Spilling recently introduced various chiral diol ligands for Ti-catalyzed addition of dimethyl phosphite to cinnamaldehyde (Scheme 5-31). 

Other excellent results have been reported by Kang et al. for the addition of ZnEt2 to aldehydes by using chiral cyclic amino thiol ligands depicted in Scheme 3.7. A total enantioselectivity was obtained when (lR,25)-l-phenyl-2-piperidinopropane-1-thiol was used as the ligand in the reactions of substituted benzaldehydes. However, -hexanal and traw -cinnamaldehyde could only be... 

We have shown that the direct arylation of acrolein toward the synthesis of cinnamaldehyde derivatives was an efficient procedure. Using the palladacycle 1 as catalyst, substituted aldehydes 3 were prepared with up to 87% isolated yield from condensed aiyl bromides (Scheme 21.1, Route 1) that was extended successfully to heteroaiyl bromides, like bromoquinolines (6). Alternatively, the acrolein diethyl acetal was used as olefin and a selective formation of the saturated ester 4 was attained under the same reaction conditions (Scheme 21.1, Route 2). The expected aldehydes 3 were, however, obtained from most of the aiyl halides used under modified conditions. It was shown that the addition of n-Bu4NOAc in the medium... 

Et2Zn also participates in the reductive coupling as a formal hydride source. Results for the Ni-catalyzed, Et2Zn-promoted homoallylation of carbonyl compounds with isoprene are summarized in Table 7 [30]. Et2Zn is so reactive that for the reaction with reactive aromatic aldehydes it causes direct ethylation of aldehydes, and the yields of homoallylation are diminished (runs 1 and 2). Unsaturated aldehydes seem to be subject to the Michael addition of Et2Zn. Accordingly, for the reaction with cinnamaldehyde, none of the expected homoallylation product is produced instead, the 1,4-addition product of Et2Zn, 3-phenylpentanal is produced exclusively (run 3). 

A 1-1. three-necked round-bottomed flask, fitted with a dropping funnel and a mechanical stirrer, is cooled in an ice-salt mixture. To the flask are added 55.5 g. (50 ml., 0.42 mole) of freshly distilled cinnamaldehyde (Note 1) and 225 ml. of acetic anhydride. When the temperature of the solution has reached 0-5° a solution of 18 ml. of concentrated nitric acid (sp. gr. 1.42) in 50 ml. of glacial acetic acid is added slowly through the dropping funnel while the mixture is stirred. The time of addition is 3-4 hours, during which the temperature is kept below 5°. After the addition is complete, the mixture is allowed to warm slowly to room temperature. The. reaction flask is then dismantled and stoppered, and the reaction mixture is allowed to stand 2 days. 

The stereoselective addition of the titanium enolate of A-acetyl-4-phenyl-l,3-thiazolidine-2-thione 153 to the cyclic A-acyl iminium ion 154 is utilized in the synthesis of (-)-stemoamide, a tricyclic alkaloid <06JOC3287>. The iminium ion addition product 155 undergoes magnesium bromide-catalyzed awtz-aldol reaction with cinnamaldehyde 156 to give adduct 157, which possesses the required stereochemistry of all chiral centers for the synthesis of (-)-stemoamide. 

Superior yields of ethers from aldehydes are obtained by the use of several other electrophilic species. The addition of 5 mol% of trityl perchlorate to a mixture of triethylsilane and 3-phenylpropanal in dichloromethane at 0° produces an 83% yield of bis-(3-phenylpropyl) ether within 10 minutes (Eq. 176),329 Reductive polycondensation of isophthalaldehyde occurs with two equivalents of triethylsilane in the presence of 10 mol% of trityl perchlorate to give 40-72% yields of polyether with average molecular weights ranging from 6,500 to 11,400 daltons (Eq. 177).337 Addition of one equivalent of an alkoxytrimethylsilane to the reaction mixture produces unsymmetrical ethers in good to excellent yields. Thus, a mixture of (ii)-cinnamaldehyde, 3-phenylpropoxytrimethylsilane, and triethylsilane in dichloromethane reacts under the influence of a catalytic amount of trityl perchlorate to give the unsymmetrical ether in 88% yield (Eq. 178).329... 

When carried out under standard conditions with Et3SiH/TFA, reduction of acrolein leads to a mixture of allyl alcohol, 1-propanol, and di-n-propyl ether in addition to allyl trifluoroacetate and -propyl trifluoroacetate.434 The 1,2-reduction of cinnamaldehyde with triethoxysilane in the presence of fluoride ion provides the corresponding allyl alcohol in good yields (Eq. 261). 

Selection of the reaction conditions brings about a complete reversal between 1,2- and 1,4-addition in the reaction of cinnamaldehyde (Scheme 83).386... 

Another a, i-unsaturated aldehyde analyzed is cinnamaldehyde. Its liquid-phase hydrogenation has been studied in our research group [20, 51, 94], using Pt, Ni and Cu-based tin-modified hi- and organobimetaUic catalysts (in all cases with Si02 as support). The catalytic results obtained showed that in aU cases there was a marked promoting effect of Sn on the selectivity to cinnamic alcohol (UOL). The specific modification of the monometallic systems due to Sn addition from the application of SOMC/M markedly increases the selectivity to UOL, especially in the case of Ni, where it goes from zero selectivity for the monometallic to 25% for the NiSn catalyst. Pt-based systems modified by Sn yield the best Suol values. 

The synthesis of y-lactams has been achieved under similar reaction conditions (Table 18) [124]. Initially, Bode and co-workers screened a variety of acyl imines in order to find suitable electrophiles. Control experiments provided evidence for carbene addition to the acyl imine, yielding a stable complex with complete inhibition of the desired reactivity. Reversibility of this addition was key to the success of the reaction. A -4-Methoxybenzenesulfonyl imines 212 proved to be the most efficient partners for lactamization with cinnamaldehydes 228 to provide y-lactams 229 in moderate yields and good diastereoselectivities. Notably, no benzoin or S tetter products or their corresponding derivatives were observed during this reaction. 

---