Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Saturated carbonyls

Fielicke A, von Helden G, Meijer G, Pederson D, Simard B, Rayner D (2005) Gold cluster carbonyls Saturated adsorption of CO on gold cluster cations, vibrational spectroscopy, and implications for their structures. J Am Chem Soc 127 8416... [Pg.315]

Remote carbonylation. Saturated alcohols form 5-lactones on reaction with Pb(OAc)4 and carbon monoxide. [Pg.202]

In the method of Belscher [1], a nitrogen stream saturated with Fe(CO)5 at some temperature is combined in the bulb-shaped reactor of the apparatus hown in Fig. 338 with a stream of very hot nitrogen. The hot-gas quantity is always several times that of the cold one. Thus, for example, if the carbonyl-saturated Ng flows at a rate of 2 liters/hour, the flow rate of the hot N g must be 40-100 liters/hour. If the reaction temperature is maintained between 200 and 700°C and the Fe concentration in the decomposition zone does not exceed 10 mg./liter, a uniform, fibrous product collects in the settling chamber. [Pg.1636]

Normally the reaction of thiols with carbonyls, saturated or unsaturated, leads to the formation of dithioacetals when acid catalysts such as zinc chloride or p-toluene-sulphonic acid are present (see section II.A. 1). Occasionally, under special reaction conditions thioenol ethers have been formed using these same catalysts but never in the presence of acid-sensitive substituents. Pyridine hydrochloride as the catalyst has been successfully used to give excellent yields of the thioenol ethers of A -3-ketosteroids even in the presence of sensitive groups . Thus, desoxy-corticosterone acetate (92) was converted to its 3-benzylthioenol ether... [Pg.288]

Reductive Cleavage of Alkylcobalt Carbonyls. Saturated product-formation accompanies not only the catalytic aldehyde-formation as a side reaction but the stoichiometric aldehyde-formation as well. Beside carbonylated products substantial amounts (20-40%) of saturated product is the result of the reaction of various olefins and HCo(CO)4 using a low olefin HCo(CO)4 molar ratio. Under such conditions with 1-substituted vinylarenes and with conjugated diolefins almost exclusively the saturation of the carbon-carbon double bond occurs. See Table 13 for characteristic examples. [Pg.1099]

Ketal formation of a,p-unsaturated carbonyls are usually slower than for the saturated case. [Pg.67]

The most commonly used protected derivatives of aldehydes and ketones are 1,3-dioxolanes and 1,3-oxathiolanes. They are obtained from the carbonyl compounds and 1,2-ethanediol or 2-mercaptoethanol, respectively, in aprotic solvents and in the presence of catalysts, e.g. BF, (L.F. Fieser, 1954 G.E. Wilson, Jr., 1968), and water scavengers, e.g. orthoesters (P. Doyle. 1965). Acid-catalyzed exchange dioxolanation with dioxolanes of low boiling ketones, e.g. acetone, which are distilled during the reaction, can also be applied (H. J. Dauben, Jr., 1954). Selective monoketalization of diketones is often used with good success (C. Mercier, 1973). Even from diketones with two keto groups of very similar reactivity monoketals may be obtained by repeated acid-catalyzed equilibration (W.S. Johnson, 1962 A.G. Hortmann, 1969). Most aldehydes are easily converted into acetals. The ketalization of ketones is more difficult for sterical reasons and often requires long reaction times at elevated temperatures. a, -Unsaturated ketones react more slowly than saturated ketones. 2-Mercaptoethanol is more reactive than 1,2-ethanediol (J. Romo, 1951 C. Djerassi, 1952 G.E. Wilson, Jr., 1968). [Pg.165]

Migration of a hydride ligand from Pd to a coordinated alkene (insertion of alkene) to form an alkyl ligand (alkylpalladium complex) (12) is a typical example of the a, /(-insertion of alkenes. In addition, many other un.saturated bonds such as in conjugated dienes, alkynes, CO2, and carbonyl groups, undergo the q, /(-insertion to Pd-X cr-bonds. The insertion of an internal alkyne to the Pd—C bond to form 13 can be understood as the c -carbopa-lladation of the alkyne. The insertion of butadiene into a Ph—Pd bond leads to the rr-allylpalladium complex 14. The insertion is usually highly stereospecific. [Pg.7]

Addition of dihydrosilane to a, /J-unsaturated carbonyl compounds such as citral (49), followed by hydrolysis, affords saturated citroneJlal (50) directly. The reaction is used for the selective reduction of conjugated double bonds[45,46]. In addition to Pd catalyst, the use of a catalytic amount of... [Pg.518]

Triethylammonium formate is another reducing agent for q, /3-unsaturated carbonyl compounds. Pd on carbon is better catalyst than Pd-phosphine complex, and citral (49) is reduced to citronellal (50) smoothly[55]. However, the trisubstituted butenolide 60 is reduced to the saturated lactone with potassium formate using Pd(OAc)2. Triethylammonium formate is not effective. Enones are also reduced with potassium formate[56]. Sodium hypophosphite (61) is used for the reduction of double bonds catalyzed by Pd on charcoal[57]. [Pg.520]

The reaction is carried out at low temperature in aqueous medium and then allowed to stand overnight (221). Ammonium thiocarbamate is prepared from a cold saturated solution of ammonium thiocyanate, which is gradually added to dilute sulfuric acid at 25°C. The liberated carbonyl sulfide is passed into a saturated solution of alcoholic ammonia at about 10°C (221). The fairly low yield indicates that the reaction has not been greatly developed. [Pg.258]

Acetaldehyde can be isolated and identified by the characteristic melting points of the crystalline compounds formed with hydrazines, semicarbazides, etc these derivatives of aldehydes can be separated by paper and column chromatography (104,113). Acetaldehyde has been separated quantitatively from other carbonyl compounds on an ion-exchange resin in the bisulfite form the aldehyde is then eluted from the column with a solution of sodium chloride (114). In larger quantities, acetaldehyde may be isolated by passing the vapor into ether, then saturating with dry ammonia acetaldehyde—ammonia crystallizes from the solution. Reactions with bisulfite, hydrazines, oximes, semicarb azides, and 5,5-dimethyl-1,3-cyclohexanedione [126-81 -8] (dimedone) have also been used to isolate acetaldehyde from various solutions. [Pg.53]

A particularly useful reaction has been the selective 1,2-reduction of a, P-unsaturated carbonyl compounds to aHyUc alcohols, accompHshed by NaBH ia the presence of lanthanide haUdes, especially cerium chloride. Initially appHed to ketones (33), it has been broadened to aldehydes (34) and acid chlorides (35). NaBH by itself gives mixtures of the saturated and unsaturated alcohols. [Pg.304]

Although saturated alcohols are sufftcientiy stable toward quinones to be used as solvents for these oxidation reactions, hen2ylic (43) and aHyUc alcohols are often readily converted to the corresponding carbonyl compounds (44), as shown in equation 2 for ben2ene systems (33). For the substituents indicated, yields are as follows ... [Pg.408]

The main synthetic route to high nuclearity metal carbonyl clusters involves a condensation process (/) a reaction induced by coordinatively unsaturated species or (2) a reaction between coordinatively saturated species in different oxidation states. As an example of (/), Os2(CO)22 can be condensed to form a series of higher coordinated species (89). [Pg.68]

Hydrogenation of cinnamaldehyde has been studied extensively since selectivity has often been an issue. Under mild conditions the carbonyl group is reduced giving cinnamyl alcohol, whereas at elevated temperatures complete reduction to 3-phenylpropanol [122-97 ] results. It is possible to saturate the double bond without concomitant reduction of the carbonyl group through selective hydrogenation with a ferrous chloride-activated palladium catalyst (30), thereby producing 3-phenylpropanol [104-53-0]. [Pg.175]

Nucleophilic attack on ring atoms of large heterocycles is largely confined to saturated systems, saturated parts of partially unsaturated systems, and to carbonyl functions and the like. These reactions are not fundamentally different from those of corresponding acyclic systems, except for transannular reactions. [Pg.25]

EtOH), which is also obtained when tetrahydrojervine is reduced by sodium in butanol. In these reactions it is thought that the A -double bond has been saturated in dihydro jervine, and that the carbonyl group is reduced in the formation of the jervinols. [Pg.706]

When saturated steroidal ketones are reduced in ammonia, an alcohol is usually present to act as a proton donor and high yields of steroidal alcohols are obtained. Under these conditions, reduction probably proceeds by protonation of the radical-anion (or ketyl) (61), which results from a one electron addition to the carbonyl group, followed by addition of a second electron and proton. Barton has proposed that reduction proceeds via protonation of the dianion (62) arising from addition of two electrons to the carbonyl group. This proposal implies that the ketyl (61) undergoes addition of a second electron in preference to undergoing protonation by the... [Pg.33]


See other pages where Saturated carbonyls is mentioned: [Pg.327]    [Pg.130]    [Pg.327]    [Pg.130]    [Pg.511]    [Pg.470]    [Pg.517]    [Pg.139]    [Pg.493]    [Pg.153]    [Pg.116]    [Pg.150]    [Pg.126]    [Pg.12]    [Pg.14]    [Pg.86]    [Pg.138]    [Pg.765]    [Pg.55]    [Pg.157]    [Pg.51]    [Pg.11]    [Pg.753]    [Pg.33]    [Pg.248]    [Pg.295]    [Pg.706]    [Pg.727]    [Pg.728]    [Pg.36]    [Pg.38]    [Pg.41]   
See also in sourсe #XX -- [ Pg.1295 ]




SEARCH



Activated hydrogens in saturated carbonyl compounds

Carbonyl compounds saturated

Carbonyl oxides saturated hydrocarbon oxidation

Carbonyls, saturated, activation

Saturated Acyclic Carbonyl Compounds

Saturated Cyclic Carbonyl Compounds

© 2024 chempedia.info