Chain propagation activation energy,

In general, the activation energies for both cationic and anionic polymerization are small. For this reason, low-temperature conditions are normally used to reduce side reactions. Low temperatures also minimize chain transfer reactions. These reactions produce low-molecular weight polymers by disproportionation of the propagating polymer ... 

Bond energies. The net reaction CD + RH = RC1 + HC1 proceeds by a chain mechanism in which the propagators are Cl and R (but not H ), and chain-breaking occurs by dimerization of Cl. Write a scheme consistent with this and derive its rate law. Show how one can use E and AH for the bond dissociation of CP to calculate an activation energy for an elementary reaction. 

Activation energies for chain termination are smaller than for chain propagation, but they are significantly greater than zero. This might not have been anticipated inasmuch as methyl radicals seem to combine in the gas phase without measurable activation energy. ... 

Bond energy considerations indicate that the initiation reaction (4.2.2) should be quite slow because its activation energy must be quite high (at least equal to the bond dissociation energy). If one were dealing with an open sequence reaction mechanism, such a step would imply that the overall reaction rate would also be low because in these cases the overall reaction becomes approximately equal to that of the rate limiting step. In the case of a chain reaction, on the other hand, the overall reaction rate is usually much faster because the propagation steps occur many times for each time that an initiation step occurs. 

Transfer reaction to the monomer, leading to the insertion of an unsaturated end group, is an important reaction in cationic chain polymerisation. As the activation energies of both termination and transfer reactions are higher than that of the propagation step, cationic chain polymerisation can only lead to high molecular masses when undertaken at low temperatures, typically — 100°C. 

The traditional chain oxidation with chain propagation via the reaction RO/ + RH occurs at a sufficiently elevated temperature when chain propagation is more rapid than chain termination (see earlier discussion). The main molecular product of this reaction is hydroperoxide. When tertiary peroxyl radicals react more rapidly in the reaction R02 + R02 with formation of alkoxyl radicals than in the reaction R02 + RH, the mechanism of oxidation changes. Alkoxyl radicals are very reactive. They react with parent hydrocarbon and alcohols formed as primary products of hydrocarbon chain oxidation. As we see, alkoxyl radicals decompose with production of carbonyl compounds. The activation energy of their decomposition is higher than the reaction with hydrocarbons (see earlier discussion). As a result, heating of the system leads to conditions when the alkoxyl radical decomposition occurs more rapidly than the abstraction of the hydrogen atom from the hydrocarbon. The new chain mechanism of the hydrocarbon oxidation occurs under such conditions, with chain... 

The acylperoxyl radical is extremely active due to the high dissociation energy of O—H bond (D0—h = 418 k J mol 1 in benzaldehyde [73]) and accelerates the chain propagation. 

The polar carbonyl group interacts with the polar transition state of the reaction between the peroxyl radical and the C—H bond of the aldehyde. This interaction lowers the activation energy of this reaction (see Section 8.1.4). As a result, all the three factors, viz., the strong RC(0)00—H bond formed, the weak C—H bond of the oxidized aldehyde, and the polar interaction in the transition state, contribute to lowering the activation energy of the reaction RC(0)00 + RCH(O) and increasing the rate constant of the chain propagation reaction (see Section 8.1.4). 

Since the reactants (R02 ketone) and the transition state have a polar character, they are solvated in a polar solvent. Hence polar solvents influence the rate constants of the chain propagation and termination reactions. This problem was studied for reactions of oxidized butanone-2 by Zaikov [81-86]. It was observed that kp slightly varies from one solvent to another. On the contrary, kt changes more than ten times from one solvent to another. The solvent influences the activation energy and pre-exponential factor of these two reactions (see Table 8.16). 

The cross-disproportionation of nitroxyl and hydroperoxyl radicals is an exothermic reaction. For example, the enthalpies of disproportionation of TEMPO radical with H02, Me2C(0H)02, and cydo-C(,Y 10(OH)O2 radicals are equal to 109, —92, and 82 kJ mol-1, respectively. The Ee0 value for the abstraction of an H atom from the O—H bond in ROOH by a nitroxyl radical is 45.6 kJ mol 1 and AHe min = —58 kJ mol-1. Since AHe < AHe min, (see Chapter 6), the activation energy of such exothermic reactions for these reactions is low (E 0.5RT), and the rate constant correspondingly is high [31 34]. Therefore, in the systems in which hydroperoxyl, hydroxyperoxyl, and aminoperoxyl radicals participate in chain propagation, the cyclic chain termination mechanism should be realized. 

Nair et al. studied the kinetics of the polymerization of MMA at 60-95 °C using N,1SP-diethyl-NjW-di(hydroxyethyl)thiuram disulfide (30a) as the thermal in-iferter [142]. The dependence of the iniferter concentration on the polymerization rate was examined. The chain transfer constant of the propagating radical of MMA to 30a was determined to be 0.23-0.46 at 60-95 °C, resulting in the activation energy of 37.6 kj/mol for the chain transfer. Other derivatives 30b-30d were also prepared and used to derive telechelic polymers with the terminal phosphorus, amino, and other functional aromatic groups [143-145]. Thermal polymerization was also investigated with the end-functional poly(St) and poly(MMA) which were prepared using the iniferter 13 [146]. 

If the DP is indeed independent of monomer concentration, the chain-breaking reactions which remain important at -180° must be of the same order with respect to monomer concentration as the propagation reaction. The most obvious conclusion is that monomer transfer is the dominant chain breaking reaction, so that DP = kp/km it follows that the activation energy, EDP, characterising the low temperature branch of the Arrhenius plot is Ep -Em = -0.2 kcal/mole. 

If the system is one of both chain branching and propagating steps, a could equal 1.01, which would indicate that one out of a hundred reactions in the system is chain branching. Moreover, hidden in this assumption is the effect of the ordinary activation energy in that not all collisions cause reaction. Nevertheless, this point does not invalidate the effect of a small amount... 

---