Canale

When heat-electric generating station turbine rotors are under operation there is a probability of forming surface cracks in axial canal and heat grooves. Evolution of the above defects can cause a serious crash. Therefore, in accordance with safety standards periodic inspection of the rotor component parts is required. 

There are difficulties of detecting defects in axial canal because of solid sediment layer of 1. 2 mm thick on the canal surface. When using known defectoscope devices a preliminary labor-intensive mechanical treatment of the axial canal surface is needed. The experience of application of different methods of rotor axial canal control in multifunction automatic device ROTOR - K has pointed to the fact that the most effective method is eddy current one [1]. All the dangerous cracks were just detected by the eddy current method, the part of the cracks were not... 

In order to solve the problem of detect control of axial canal without preliminary surface clearing, the eddy-current transformer with operating butt end... 

B. 1. Volkov, V. M. Temryukh. Complex control of rotor turbine from the axis canal side. /Thesis of the reports at the 14 th Russian scientific and technical conference Non-destruction control and diagnostics . Moscow, 1996, p. 435... 

The surface viscosity can be measured in a manner entirely analogous to the Poiseuille method for liquids, by determining the rate of flow of a film through a narrow canal under a two-dimensional pressure difference Ay. The apparatus is illustrated schematically in Fig. IV-7, and the corresponding equation for calculating rj is analogous to the Poiseuille equation [99,100]... 

While the canal viscometer provides absolute viscosities and the effect of the substrate drag can be analyzed theoretically, the shear rate is not constant and the measurement cannot be made at a single film pressure as a gradient is required. Another basic method, more advantageous in these respects, is one that goes back to Plateau... 

TableCurve, Jandel Scientific, SYSTAT Software Inc., 510 Canal Boulevard, Suite F, Richmond, CA.

TableCurve is available from Systat Software Inc., 501 Canal Boulevard, Suite E, Richmond, CA 94804-2028 (http //www.systat.com/products/tablecurve2d/). A free trial version of TableCurve is available at this web site. Systat offers other curvefitting and statistical software.

The sulfur-bearing cap rock, being an enclosed formation, is essentially the equivalent of a pressure vessel. Hot water, pumped into the formation to melt sulfur, must be withdrawn after cooling at approximately the same rate as it is put in, otherwise the pressure in the formation would increase to the point where further water injection would be impossible. Bleedwater weUs, used to extract water from the formations, usually are located on the flanks of the dome away from the mining area where the water temperature is lowest. The water is treated to remove soluble sulfides and other impurities before being discharged to disposal ditches or canals. 

Great Lakes River / canals Coastwise Ait Total... 

In some places and under certain conditions, freshwater can be obtained more cheaply by desalination of seawater than by transporting water. This is tme when all the costs of extremely large monetary investments in dams, reservoirs, conduits, and pumps to move the water are considered. Before the rapid escalation of fuel costs between 1973 and 1980, the cost of desalination of seawater to adequately supply southern California would have been less than that of transport to the Peripheral Canal. This would have been the case even if there were an unlimited supply of water in the mountains of northern California, a condition that does not appear to exist. It has been shown that before 1973 a seacoast town could have been suppHed with 7-12 x lO" /d of freshwater more cheaply by desalination than by damming and piping water a distance of >160 km km (7). Indeed, the 1987—1992 drought in California has compelled the city of Santa Barbara to constmct a water desalination plant, and a 76,000-m /d plant is plaimed for the western coast of Florida (8). 

The demand for cement was stimulated by the growth of canal systems ia United States duting the nineteenth century. Process improvements were made ia the calciaation of certain limestones for the manufacture of natural cements, which were gradually displaced by Pordand cement. This latter was named ia a 1824 patent because of its color and resemblance to a natural limestone quarried on the Isle of Pordand ia England. Research conducted siace that time has provided a clear picture of the composition, properties, and fields of stabiUty of the principal systems found ia Pordand cement. These results led to the widely used Bogue calculation of composition based on oxide analysis (1). Details beyond the scope of this article may be found ia the Hterature (2). 

The cotton fiber is a single biological cell, 15 to 24 p.m in width and 12 to 60 mm long it has a central canal, or lumen, down its length except at the tip... 

Pipe Lines For quantities of fluid which an economic investigation indicates are sufficiently large and continuous to justify the investment, pipe lines are one of the lowest-cost means of transportation. They have been built up to 1.22 m (48 in) or more in diameter and about 3200 km (2000 mi) in length for oil, gas, and other products. Water is usually not transported more than 160 to 320 km (100 to 200 miles), but the conduits may be much greater than 1.22 m (48 in) in diameter. Open canals are also used for water transportation. 

Potable Water RO and NF both play a major role in providing potable water, defined either by the WHO criterion of <1000 ppm total dissolved solids (TDS) or the U.S. EPA limit of 500 ppm TDS. RO is most prominent in the Middle East and on islands where potable-water demand has outstripped natural supply. A plant awaiting startup at Al Jubail, Saudi Arabia produces over 1 mVs of fresh water (see Table 22-17). Small units are found on ships and boats. Seawater RO competes with multistage flash distillation (MSF) and multieffect distillation (MED) (see Sec. 13 Distillation ). It is too expensive to compete with conventional civil supply (canals, pipelines, w ls) in most locations. Low-pressure RO and NF compete with electrodialysis for the desalination of brackish water. The processes overlap economically, but they are sufficiently different so that the requirements of the application often favor one over the others. 

Soaked rags, cloth or papers, must be destroyed in an incineration plant at 1000°C. Disposal at a landfill area is not advisable for during rain they may be carried by storm drains into rivers, canals or ponds. 

This formula is another variation on the Affinity Laws. Monsieur s Darcy and VVeisbach were hydraulic civil engineers in France in the mid 1850s (some 50 years before Mr. H VV). They based their formulas on friction losses of water moving in open canals. They applied other friction coefficients from some private experimentation, and developed their formulas for friction losses in closed aqueduct tubes. Through the years, their coefficients have evolved to incorporate the concepts of laminar and turbulent flow, variations in viscosity, temperature, and even piping with non uniform (rough) internal. surface finishes. With. so many variables and coefficients, the D/W formula only became practical and popular after the invention of the electronic calculator. The D/W forntula is extensive and eomplicated, compared to the empirieal estimations of Mr. H W. 

---