Benzoic acid mixture

Figure 5 Dissolution rates of salicylic acid-benzoic acid mixtures. ( ) Benzoic acid from melt (O) salicylic acid from melt (A) salicylic acid from mechanical mix ( ) Benzoic acid from mechanical mix. (From Ref. 19.)... 

Siciliano, S. Germida, J. Degradation of chlorinated benzoic acid mixtured by plant-bacteria associations. Environ. Toxicol. Chem. 1998, 17 (4), 728-733. 

Figure 7.63. Phase diagram of the naphthalene-benzoic acid mixture il74. 175). Points on phase diagram taken from eight DTA curves.

As mentioned earlier, the control of properties in a supercritical fluid can allow separation to be incorporated into a recrystallisation process. This uses the so-called crossover effect, which arises when the isotherms of solubility versus pressure for two compounds at the same temperature can cross, i.e. the solubility of one compound is greater at a lower temperature, whereas that of the other compound is higher at a higher temperature, and they are equal at an intermediate temperature. Chimowitz et al. [103], by expansion of the solution from an extraction vessel down to 1 bar, measured solubility of 1 10 w/w decanediol-benzoic acid mixture in supercritical carbon dioxide. They experimentally defined the crossover behaviour for the two compounds, and subsequently achieved the separation of almost pure benzoic acid [104] from the 1 10 w/w decanediol-benzoic acid mixture. In a subsequent study, Sako et al separated phenanthrene and naphthalene to 97 wt% purity from a 1 1 w/w mixture using a similar technique [105]. 

Aluminum complex greases, obtained by the reaction of aluminum isopropylate with a mixture of benzoic acid and fatty acids. These greases have a remarkable resistance to water, very good adhesion to metallic surfaces, good mechanical stability properties and resistance to temperature. They are less common than the first two types. 

Place I g. of benzamide and 15 ml. of 10% aqueous sodium hydroxide solution in a 100 ml. conical flask fitted with a reflux water-condenser, and boil the mixture gently for 30 minutes, during which period ammonia is freely evolved. Now cool the solution in ice-water, and add concentrated hydrochloric acid until the mixture is strongly acid. Benzoic acid immediately separates. Allow the mixture to stand in the ice-water for a few minutes, and then filter off the benzoic add at the pump, wash with cold water, and drain. Recrystallise from hot water. The benzoic acid is obtained as colourless crystals, m.p. 121°, almost insoluble in cold water yield, o 8 g. (almost theoretical). Confirm the identity of the benzoic acid by the tests given on p. 347. 

Hydrolysis of />-Tolunitrile. As in the case of benzonitrile, alkaline h> drolysis is preferable to hydrolysis by 70% sulphuric acid. Boil a mixture of 5 g. of p-tolunitrile, 75 ml. of 10% aqueous sodium hydroxide solution and 15 ml. of ethanol under a reflux water-condenser. The ethanol is added partly to increase the speed of the hydrolysis, but in particular to prevent the nitrile (which volatilises in the steam) from actually crystallising in the condenser. The solution becomes clear after about i hour s heating, but the boiling should be continued for a total period of 1-5 hours to ensure complete hydrolysis. Then precipitate and isolate the p-toluic acid, CH3CgH4COOH, in precisely the same way as the benzoic acid in the above hydrolysis of benzonitrile. Yield 5 5 g. (almost theoretical). The p-toluic acid has m.p. 178°, and may be recrystallised from a mixture of equal volumes of water and rectified spirit. 

Prepare a mixture of 30 ml, of aniline, 8 g. of o-chloro-benzoic acid, 8 g. of anhydrous potassium carbonate and 0 4 g. of copper oxide in a 500 ml. round-bottomed flask fitted with an air-condenser, and then boil the mixture under reflux for 1 5 hours the mixture tends to foam during the earlier part of the heating owing to the evolution of carbon dioxide, and hence the large flask is used. When the heating has been completed, fit the flask with a steam-distillation head, and stcam-distil the crude product until all the excess of aniline has been removed. The residual solution now contains the potassium. V-phenylanthrani-late add ca. 2 g. of animal charcoal to this solution, boil for about 5 minutes, and filter hot. Add dilute hydrochloric acid (1 1 by volume) to the filtrate until no further precipitation occurs, and then cool in ice-water with stirring. Filter otT the. V-phcnylanthranilic acid at the pump, wash with water, drain and dry. Yield, 9-9 5 g. I he acid may be recrystallised from aqueous ethanol, or methylated spirit, with addition of charcoal if necessary, and is obtained as colourless crystals, m.p. 185-186°. 

Hydrolysis of Benzanilide. For this hydrolysis, it is necessary to use 70% sulphuric acid (see Hydrolysis of Acetanilide, p. 108). Add I g. of benzanilide to 10 ml. of 70% sulphuric acid, and boil the mixture gently in a small flask under a reflux water-condenser for 30 minutes. Hydrolysis will now be complete, but much of the benzoic acid will have vaporised in the steam and then solidified in the conden-... 

Example. Dissolve 0 3 g. of benzoic acid in a minimum of hot water (about 70 ml.) and add 5% aqueous sodium hydro.xide until the solution is just alkaline to methyl-orange, then add i drop of dilute hydrochloric acid. Pour this solution of the sodium salt into a solution of 0 5 g, of benzylthiouronium chloride in 5 ml. of water, and cool the stirred mixture in ice-water. Filter off the benzylthiouronium salt which has separated, and recrystallise from ethanol con taining 10% of water cream-coloured cr> stals, m.p. i66 . (M.ps., pp. 543 545.)... 

B) Benzoyl derivatives. Most amino-acids can be benzoyl-ated when their solutions in 10% aqueous sodium hydroxide are shaken with a small excess of benzoyl chloride until a clear solution is obtained (Schotten-Baumann reaction, p. 243). Acidification of the solution then precipitates the benzoyl derivative and the excess of benzoic acid, and the mixture must be filtered off, washed with water, and recrystallised (usually from ethanol) to obtain the pure derivative. (M.ps., p. 555 )... 

I. Oxidation to benzoic acid. Boil a mixture of i ml. of benzyl chloride, 50 ml. of saturated aqueous KMn04 solution and 2 g. of anhydrous Na.jCOj under reflux for 30 minutes. Acidify with cone. HCl and then add 25% Na SOj solution until the brown precipitate of MnOj has dissolved. On cooling, benzoic acid crystallises out. Filter through a small Buchner funnel, wash with water and identify (P 347) When recrystallised from water, benzoic acid has m.p. 121 . 

Benzoates. Dissolve 0-5 g. of the amino acid in 10 ml. of 10 per cent, sodium bicarbonate solution and add 1 g. of benzoyl chloride. Shake the mixture vigorously in a stoppered test-tube remove the stopper from time to time since carbon dioxide is evolved. When the odour of benzoyl chloride has disappeared, acidify with dilute hydrochloric acid to Congo red and filter. Extract the solid with a little cold ether to remove any benzoic acid which may be present. RecrystaUise the benzoyl derivative which remains from hot water or from dilute alcohol. 

Pour the aqueous solution remaining from the ether extraction with stirring into a mixture of 80 ml. of concentrated hydrochloric acid, 80 ml. of water and about 100 g. of crushed ice. Filter the precipitated benzoic acid at the pump, wash it with a little cold water, drain, and recrystallise from boiling water. The yield of benzoic acid (colourless crystals), m.p. 121°, is 18g. 

Sodium hydroxide solution cannot be used at this stage since it may produce benzoic acid by the Cannizzaro reaction (Section IV,123) from any unchanged benzaldehyde. If, however, the reaction mixture is diluted with 3-4 volumes of water, steam distilled to remove the unreacted benzaldehyde, the residue may then be rendered alkaline with sodium hydroxide solution. A few grams of decolourising carbon are added, the mixture boiled for several minutes, and filtered through a fluted filter paper. Upon acidifying carefully with concentrated hydrochloric acid, cinnamic acid is precipitated. This is collected, washed and purified as above. 

Stir a mixture of 2-4 g. of powdered hydrazine sulphate, 18 ml. of water and 2-4 ml. of concentrated aqueous ammonia (sp. gr. 0-88), and add 4-6 g. (4 4 ml.) of benzaldehyde (free from benzoic acid) dropwise, with stirring, over a period of 30-60 minutes. Stir the mixture for a further hour, collect the solid by suction filtration and wash it with water. RecrystalUse from 8 ml. of rectified spirit. The 3 ield of benzalazine (yellow needles), m.p. 92-93°, is 3-6 g. 

Dinitrobenzoic acid. This acid may be prepared by the nitration of benzoic acid with a mixture of concentrated sulphuric acid and fuming nitric acid under special conditions (see also Section VII,22) ... 

Ethyl benzoate sulphuric acid as a catalyst). Use 30 g. of benzoic acid, 115 g. (146 ml.) of absolute ethyl alcohol and 5 g. (2 7 ml.) of concentrated sulphuric acid. Reflux the mixture for 4 hours and work up as for Methyl Benzoate. The yield of ethyl benzoate, b.p. 212-214°, is 32 g. 

Place 150 g. of benzoic acid, 150 g. (139 ml.) of acetic anhydride and 0-2 ml. of syrupy phosphoric acid in a 500 ml. bolt-head flask. Fit the latter with a two-holed stopper carrying a dropping funnel and an efficient fractionating column (compare Fig. 7/7, 61, 1) it is advisable to lag the latter with asbestos cloth. Set up the flask in an oil bath or in a fusible metal bath. Distil the mixture very slowly and at such a rate that the temperature of the vapour at the head of the column does... 

The hydrolysis by alkali is illustrated by the following experimental details for benzamido. Place 3 g. of benzamide and 50 ml. of 10 per cent, sodium hydroxide solution in a 150 ml. conical or round-bottomed flask equipped with a reflux condenser. Boil the mixture gently for 30 minutes ammonia is freely evolved. Detach the condenser and continue the boiling in the open flask for 3-4 minutes to expel the residual ammonia. Cool the solution in ice, and add concentrated hydrochloric acid until the mixture is strongly acidic benzoic acid separates immediately. Leave the mixture in ice until cold, filter at the pump, wash with a little cold water and drain well. RecrystaUise the benzoic acid from hot water. Determine the m.p., and confirm its identity by a mixed m.p. test. 

The benzoic acid may be separated by steam distillation or by saturating the aqueous mixture of sodium salts with sulphur dioxide whilst maintaining the temperature below 40° the benzoic acid precipitates and can be separated by filtration or extraction with ether. Acidification of the filtrate with hydrochloric acid liberates the pyruvic acid. The pjTuvic acid may be oxidised < lth hydrogen peroxide to the arylacetic acid, for example ... 

Separations based upon differences in the chemical properties of the components. Thus a mixture of toluene and anihne may be separated by extraction with dilute hydrochloric acid the aniline passes into the aqueous layer in the form of the salt, anihne hydrochloride, and may be recovered by neutralisation. Similarly, a mixture of phenol and toluene may be separated by treatment with dilute sodium hydroxide. The above examples are, of comse, simple apphcations of the fact that the various components fah into different solubihty groups (compare Section XI,5). Another example is the separation of a mixture of di-n-butyl ether and chlorobenzene concentrated sulphuric acid dissolves only the w-butyl other and it may be recovered from solution by dilution with water. With some classes of compounds, e.g., unsaturated compounds, concentrated sulphuric acid leads to polymerisation, sulphona-tion, etc., so that the original component cannot be recovered unchanged this solvent, therefore, possesses hmited apphcation. Phenols may be separated from acids (for example, o-cresol from benzoic acid) by a dilute solution of sodium bicarbonate the weakly acidic phenols (and also enols) are not converted into salts by this reagent and may be removed by ether extraction or by other means the acids pass into solution as the sodium salts and may be recovered after acidification. Aldehydes, e.g., benzaldehyde, may be separated from liquid hydrocarbons and other neutral, water-insoluble hquid compounds by shaking with a solution of sodium bisulphite the aldehyde forms a sohd bisulphite compound, which may be filtered off and decomposed with dilute acid or with sodium bicarbonate solution in order to recover the aldehyde. 

Suppose that you are to separate a mixture of benzoic acid, aspartame, and caffeine in a diet soda. The following information is available to you. 

---