Assemblies and Components

The manufacturer will have carried out a full mathematical investigation into the system vibration response. One quality control requirement will be to establish whether the correct assumptions have been made Rotor assembly and component weights should be obtained during man ufacture and verified against mathematical data used. 

Calandrias Calandrias, calandria tubes, pressure tubes and other fuel channel assemblies and components. 

Black, A., An Industrial Strategy for the Motor Vehicle Assembly and Component Sectors, UCT Press, Rondebosch, RSA. 

The interim examination and maintenance cell is a shielded hot-cell complex that conducts nondestructive examinations of test assemblies and core components under controlled argon-atmosphere conditions. (Its location is shown in Fig. A.l). The hot cell can also be used to perform limited maintenance of plant equipment or to prepare plant equipment for transfer to other maintenance facilities. The cell contains equipment necessary for disassembly, reassembly, and requalification of test assemblies and components. Nondestructive examinations that can be performed include dimensional checks, weighing, gamma scanning, visual inspections, and photography. Sodium removal facilities are also included. 

Within the cell renewal area, components may be handled in many different ways. Building cranes are available in some cases. In others, jib cranes move assemblies over short distances. Smaller assemblies and components are moved by monorail, cart, or hand. 

Organizations can use cost information in other ways to help achieve safety. For example, accident claim rates provide a source of costs for some products. So do returns and failures of products. The data may help when selecting supphers of parts, assemblies and components. Accident records, insurance rates, and claim records can help when selecting contractors. Cost of product failures, complaints, accidents, compliance with standards and other claims can help when setting performance incentives for suppliers and contractors. 

At room temperature, a good conventional anaerobic adhesive begins to harden within a few minutes of assembly and components can often be handled quite satisfactorily after 10-20 minutes. However, without an accelerator or elevated temperature, full adhesive strength will not develop for one to two hours. Hence normal batch testing is usually carried out after three hours but for full standardisation and type testing a 24-hour cure time is allowed. 

HAZOP and FMECA techniques systematically assess the sub-systems down to assembly and component parts down to lowest replaceable unit (LRU)... 

During rigging up or down, employees are constantly exposed to falling objects. As the derrick is assembled and components are added to it rig hands are working above other... 

Minimize the handling of electronic assemblies and components to prevent damage. 

Mutual impediments among pipe assembly, construction assembly and component assembly during the prefabrication phase can be excluded. 

Evaluation of Sn-Zn Solder Paste, Proceedings of IPC/JEDEC 2004 International Conference on Lead-Free Electronic Assemblies and Components, March 2004... 

M. Arra, D. Shangguan, J. Sundelin, T. Lepistd, and E. Ristolainen, Aging Mechanisms of Immersion Tin and Silver PCB Surface Finishes in Lead-Free Solder Applications, Proceedings of the 3rd IPC/JEDEC Annual Conference on Lead-Free Electronic Assemblies and Components,... 

The purpose of a manufacturability study would have been to determine the feasibility of acquiring and assembling the hot leg piping. Manufacturability issues for the internally insulated nickel superalloy hot leg piping include material availability, piping assembly, and component interfaces which include insulation containment and issues associated with joining the hot leg piping to both the turbine inlet and reactor pressure vessel outlet. 

Assemblies and components provide a means of grouping other entities together in a structured way. This structure is a tree which represents the consists of relationship. Although there is a clear correspondence with terms used in the mechanical products environment, the mechanism is intended to be more general. In this specification the components represent the objects to which geometric shapes are associated. 

On this level, no entities of type ASSEMBLY and COMPONENT are available. 

FIG. P-66 Clutch assembly and components. (Source MAAG Gear Company.)... 

---