Hydrocarbons aromatic, nitration

For soybean-based biodiesel at this concentration, the estimated emission impacts for percent change in emissions of NO,, particular matter (PM), HC, and CO were +20%, -10.1%, -21.1%, and -11.0%, respectively (EPA, 2002). The use of blends of biodiesel and diesel oil are preferred in engines in order to avoid some problems related to the decrease of power and torque, and to the increase of NO, emissions (a contributing factor in the localized formation of smog and ozone) that occurs with an increase in the content of pure biodiesel in a blend. Emissions of all pollutants except NO appear to decrease when biodiesel is used. The use of biodiesel in a conventional diesel engine dramatically reduces the emissions of unbumed hydrocarbons, carbon dioxide, carbon monoxide, sulfates, polycyclic aromatic hydrocarbons, nitrated polycyclic aromatic hydrocarbons, ozone-forming hydrocarbons, and particulate matter. The net contribution of carbon dioxide from biomass combustion is small. 

Since aliphatic hydrocarbons (unlike aromatic hydrocarbons, p. 155) can be directly nitrated only under very special conditions, indirect methods are usually employed for the preparation of compounds such as nitroethane, CjHsNO. When ethyl iodide is heated with silver nitrite, two isomeric compounds are formed, and can be easily separated by fractional distillation. The first is the true ester, ethyl nitrite, C,HiONO, of b.p. 17° its identity is shown by the action of hot sodium hydroxide solution, which hydrolyses it, giving ethanol and... 

Aliphatic mono-halides, and aromatic hydrocarbons with halogen in side-chain, precipitate silver hdide on treatment with cold aqueous silver nitrate solution. 

Unlike aliphatic hydrocarbons, aromatic hydrocarbons can be sul-phonated and nitrated they also form characteristic molecular compounds with picric acid, styphnic acid and 1 3 5-trinitrobenzene. Many of the reactions of aromatic hydrocarbons will be evident from the following discussion of crystalline derivatives suitable for their characterisation. 

NITRATION OF AROMATIC HYDROCARBONS Aromatic hydrocarbons may be nitrated, i.e., the hydrogen atoms replaced by nitro (NOj) groups, with concentrated nitric acid in the presence of concentrated sulpliuric acid, for example ... 

Reactivity numbers of the most reactive positions have been used to correlate the reactivities in nitration (see below) and other substitutions of a series of polycyclic aromatic hydrocarbons, and they give somewhat better correlations than any of the other commonly used indices of reactivity. The relationship shown below, which was discussed earlier ( 7.1.1),... 

Mechanism. The NO2 mechanism has been accepted since about 1950 for the nitration of most aromatic hydrocarbons, glycerol, glycols, and numerous other hydrocarbons in which mixed acids or highly concentrated nitric acid are used. The mechanism has been discussed in detail and critically analy2ed (1). NO2 attacks an aromatic compound (ArH) as follows ... 

Nitrous acid or nitrite salts may be used to catalyze the nitration of easily nitratable aromatic hydrocarbons, eg, phenol or phenoHc ethers. It has been suggested that a nitrosonium ion (NO + ) attacks the aromatic, resulting initially in the formation of a nitro so aromatic compound (13). Oxidation of the nitro so aromatic then occurs ... 

The y -phenylenediamiaes are easily obtained by dinitrating, followed by catalyticaHy hydrogenating, an aromatic hydrocarbon. Thus, the toluenediamiaes are manufactured by nitrating toluene with a mixture of sulfuric acid, nitric acid, and 23% water at 330°C which first produces a mixture (60 40) of the ortho and para mononitrotoluenes. Further nitration produces the 80 20 mixture of 2,4- and 2,6-dinitrotoluene. Catalytic hydrogenation produces the commercial mixture of diamiaes which, when converted to diisocyanates, are widely used ia the production of polyurethanes (see Amines, aromatic, DIAMINOTOLUENES) (22). 

Impurities can sometimes be removed by conversion to derivatives under conditions where the major component does not react or reacts much more slowly. For example, normal (straight-chain) paraffins can be freed from unsaturated and branched-chain components by taking advantage of the greater reactivity of the latter with chlorosulfonic acid or bromine. Similarly, the preferential nitration of aromatic hydrocarbons can be used to remove e.g. benzene or toluene from cyclohexane by shaking for several hours with a mixture of concentrated nitric acid (25%), sulfuric acid (58%), and water (17%). 

The rate of this exchange process was identical with the rate of nitration of several reactive aromatic hydrocarbons. Discuss how this result is consistent with mechanism B on p. 196, but not with mechanisms A or C. 

Polycyclic aromatic hydrocarbons (PAH) Apply sample solution and dry. Place TLX2 plate for 20 min in a twin-trough chamber containing phosphorus pentoxide to which 2 to 3 ml cone, nitric acid have been added. PAH nitrated by nitrous fumes. [20]... 

The reaction with HNO3 is quantitative, and the presence of large concentrations of the nitronium ion, NOi ", in solutions of HNO3, MNO3 and N2O5 in H2SO4 enable a detailed interpretation to be given of the nitration of aromatic hydrocarbons by these solutions. 

Nitration of benzofuroxans (Section VII, A) and decomposition of polynitrophenyl azides, provide generally satisfactory routes to nitrobenzofuroxans. The nitro groups render the ring susceptible to nucleophilic attack (see Section VII,B). 4,6-Dinitrobenzofuroxan, 5,6-dinitrobenzofuroxan, and nitrobenzodifuroxan (34) act as acceptors in change-transfer complex formation with aromatic hydrocarbons. Nitrobenzofuroxans have not been reduced to the... 

Cellulose nitrate Air drying Solvent evaporation Blends of esters, alcohols and aromatic hydrocarbons Fairly good Bad Good Poor Very good Fire hazard Statutory regulations governing use... 

Titov and co-workers, although conceding the validity of the ionic nitration mechanism for liq phase nitrations with coned acids, believe that many nitrations occur via a free-radical mechanism involving the free radicals (at any rate molecules having an unpaired electron) N02, N03, and NO. For vapor phase nitration of hydrocarbons, nitration of side chains of aromatic compds in... 

C-Nitration does not involve the hydroxyl group but is a reaction with an aliphatic or aromatic hydrocarbon or a substituted derivative to produce such compounds as the nitroparaffins and the nitrotoluenes ... 

Pure N204 forms nitrocompds readily at elevated temps with either aliphatic or aromatic hydrocarbons in the gaseous or vapor state. It therefore finds extensive use in the commercial prepn of nitrocompds in both the expls and dye industries (Ref 24). Nitrations can be conducted in either the liq or vapor phase (Ref 8), and the N204 can be used as such or dissolved in an inert solvent such as CC14. Recently, Castorina et al (Refs 19 36) have shown that gamma... 

Mononitrophenols. OjN.CgH4.OH,mw 139.11, N 10.07%, OB to C02 —133.17%. Three isomers are possible but only two (o- and p-) are obtained by direct nitration. The nitration of phenol is much easier than that of aromatic hydrocarbons such as benz or toluene... 

There is a synthesis, which is supposed to be safe and consists in using very small quantities of reagents and closely monitoring the temperature. However, the thermai control of the aromatic hydrocarbons/nitric acid reaction usually proves to be very difficult. Indeed, the temperature is either too high and the reaction is out of controi and can lead to detonation, or too low and the nitration or oxidation takes place too slowly causing the compounds to accumulate and the reaction to be delayed. The consequences are the same as before. 

Another nitration procedure uses ozone and nitrogen dioxide.11 With aromatic hydrocarbons and activated derivatives, this nitration is believed to involve the radical cation of the aromatic reactant. 

Because process mixtures are complex, specialized detectors may substitute for separation efficiency. One specialized detector is the array amperometric detector, which allows selective detection of electrochemically active compounds.23 Electrochemical array detectors are discussed in greater detail in Chapter 5. Many pharmaceutical compounds are chiral, so a detector capable of determining optical purity would be extremely useful in monitoring synthetic reactions. A double-beam circular dichroism detector using a laser as the source was used for the selective detection of chiral cobalt compounds.24 The double-beam, single-source construction reduces the limitations of flicker noise. Chemiluminescence of an ozonized mixture was used as the principle for a sulfur-selective detector used to analyze pesticides, proteins, and blood thiols from rat plasma.25 Chemiluminescence using bis (2,4, 6-trichlorophenyl) oxalate was used for the selective detection of catalytically reduced nitrated polycyclic aromatic hydrocarbons from diesel exhaust.26... 

Unlike methane and the other alkanes, aromatic hydrocarbons have absorptions in the UV part of the spectrum, and thus may be detected through UV spectrometry using silica fibers. This scheme is useful for "aromatic" water pollutants such as toluenes and xylenes with their absorption bands between 250 and 300 nm. Similarly, nitrate anion can be monitored (albeit with low sensitivity) in water via its UV absorption at 250 nm. 

---