Aromatic compounds analysis

In the case of alkenes and aromatic and heteroaromatic compounds, analysis of a single multiplet will often clarify the complete substitution pattern. A few examples will illustrate the procedure. 

Figure 6.6 SPE-SFE-HRGC(PID) cliromatograms obtained for (a) a mixture of analytical standards of selected aromatic compounds in water, and (b) the analysis of a water sample contaminated with various aromatic compounds.

Another interesting, but rather complex system, which couples flow injection analysis, EC and GC has been recently reported (47). This system allows the determination of the total amount of potentially carcinogenic polycyclic aromatic compounds (PACs) in bitumen and bitumen fumes. This system could also be used for the analysis of specific PACs in other residual products. 

R. B. Gaines, E. B. Ledford-Jr and J. D. Stuait, Analysis of water samples for ti ace levels of oxygenated and aromatic compounds using headspace solid-phase microexti action and comprehensive two-dimensional gas clnomatography , ]. Microcolumn Sep. 10 597-604(1998). 

Selecting the naphtha type can be an important processing procedure. For example, a paraffinic-base naphtha is a better feedstock for steam cracking units because paraffins are cracked at relatively lower temperatures than cycloparaffins. Alternately, a naphtha rich in cycloparaffins would be a better feedstock to catalytic reforming units because cyclo-paraffins are easily dehydrogenated to aromatic compounds. Table 2-5 is a typical analysis of naphtha from two crude oil types. 

In some sulfur extrusions from 2,7-di-/ Tt-butylthiepins a byproduct containing two sulfur atoms is obtained, along with the aromatic compound. The byproduct has been characterized as a thienothiophene by single crystal X-ray analysis.92... 

The chlorine content of the fly ash is 4.9 %, the bromine content 0.065 %. A series of brominated aromatic compounds has been adsorbed on this fly ash and treated for 1 h. with air at 300°C. The extraction and analysis yield mixed brominated/chlorinated as well as completely chlorinated products. This is shown for 5 aromatic bromine compounds in Table 2. 

Vol. 101. Chemical Analysis of Polycyclic Aromatic Compounds. Edited by Tuan Vo-Dinh... 

The analysis of experimental results by simple linear regression provide an equation from which the estimation is straightforward. Nevertheless, to obtain an accurate model, an equation for each structural type is needed. Thus, for hydrocarbons, which are one of the best examples for this approach, an equation for linear saturated hydrocarbons is required, one for the branched ones, and one for the cyclic compounds. The same is needed for unsaturated, then aromatic compounds etc. The more the study is based on a precise structural type, the better the linear adjustment and the better the forecast standard deviation but at the same time there will be fewer points with which to calculate the model and the forecast standard deviation will be higher. It is not simple to find a compromise and it was decided to give up on this approach as soon as the relevance of the Hass model was noted. 

Stabilisers are usually determined by a time-consuming extraction from the polymer, followed by an IR or UV spectrophotometric measurement on the extract. Most stabilisers are complex aromatic compounds which exhibit intense UV absorption and therefore should show luminescence in many cases. The fluorescence emission spectra of Irgafos 168 and its phosphate degradation product, recorded in hexane at an excitation wavelength of 270 nm, are not spectrally distinct. However, the fluorescence quantum yield of the phosphate greatly exceeds that of the phosphite and this difference may enable quantitation of the phosphate concentration [150]. The application of emission spectroscopy to additive analysis was illustrated for Nonox Cl (/V./V -di-/i-naphthyl-p-phcnylene-diamine) [149] with fluorescence ex/em peaks at 392/490 nm and phosphorescence ex/em at 382/516 nm. Parker and Barnes [151] have reported the use of fluorescence for the determination of V-phenyl-l-naphthylamine and N-phenyl-2-naphthylamine in extracted vulcanised rubber. While pine tar and other additives in the rubber seriously interfered with the absorption spectrophotometric method this was not the case with the fluoromet-ric method. 

The isomeric 1- and 2-fluoronaphthalenes have fluorine chemical shifts of -124 and -116 ppm, respectively. A full analysis of the proton and carbon spectra of 1-fluoronaphthalene is given in Scheme 3.56. NMR data for a number of other fluoropolycyclic aromatic compounds are available.7... 

Now and then, projectiles from outer space cause excitement and surprises, as in January 2000, when a meteorite impacted the frozen surface of Lake Targish in Canada. It was a new type of C-chondrite with a carbon concentration of 4-5%, and probably came from a D-type asteroid (Hiroi et al., 2001). More exact analysis of the Targish meteorite showed the presence of a series of mono- and dicarboxylic acids as well as aliphatic and aromatic hydrocarbons (Pizzarello et al., 2001). Aromatic compounds and fullerenes were detected in the insoluble fraction from the extraction this contained planetary helium and argon, i.e., the 3He/36Ar ratio was... 

Nakagawa, Y., Izumi, K., Oikawa, N., Sotomatsu, T., Shigemura, M., Fujita, T., Analysis and prediction of hydrophobicity parameters of substituted acetanilides, benzamides and related aromatic-compounds, Environ. Toxicol. Chem. 1992, 3 3, 901-916. 

One of the most commonly studied systems involves the adsorption of polynuclear aromatic compounds on amorphous or certain crystalline silica-alumina catalysts. The aromatic compounds such as anthracene, perylene, and naphthalene are characterized by low ionization potentials, and upon adsorption they form paramagnetic species which are generally attributed to the appropriate cation radical (69, 70). An analysis of the well-resolved spectrum of perylene on silica-alumina shows that the proton hyperfine coupling constants are shifted by about four percent from the corresponding values obtained when the radical cation is prepared in H2SO4 (71). The linewidth and symmetry require that the motion is appreciable and that the correlation times are comparable to those found in solution. 

---