Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Aromatic compound oxygen

Solvents are introduced into the paint formulation to dissolve the binder and to provide adequate fluidity of the paint to allow it to be applied. The most important characteristics of solvents are their capacity to dissolve the resins and their volatility, which controls the speed of evaporation. Solvents employed in solvent-based products are hydrocarbons (both aliphatic and aromatic compounds), oxygenated solvents (frequently alcohols, esters, ethers, or ketones), and terpenic solvents in general, mixtures of solvents are used in paint manufacture. [Pg.3537]

The operation of the nitronium ion in these media was later proved conclusively. "- The rates of nitration of 2-phenylethanesulphonate anion ([Aromatic] < c. 0-5 mol l i), toluene-(U-sulphonate anion, p-nitrophenol, A(-methyl-2,4-dinitroaniline and A(-methyl-iV,2,4-trinitro-aniline in aqueous solutions of nitric acid depend on the first power of the concentration of the aromatic. The dependence on acidity of the rate of 0-exchange between nitric acid and water was measured, " and formal first-order rate constants for oxygen exchange were defined by dividing the rates of exchange by the concentration of water. Comparison of these constants with the corresponding results for the reactions of the aromatic compounds yielded the scale of relative reactivities sho-wn in table 2.1. [Pg.10]

Nitration at a rate independent of the concentration of the compound being nitrated had previously been observed in reactions in organic solvents ( 3.2.1). Such kinetics would be observed if the bulk reactivity of the aromatic towards the nitrating species exceeded that of water, and the measured rate would then be the rate of production of the nitrating species. The identification of the slow reaction with the formation of the nitronium ion followed from the fact that the initial rate under zeroth-order conditions was the same, to within experimental error, as the rate of 0-exchange in a similar solution. It was inferred that the exchange of oxygen occurred via heterolysis to the nitronium ion, and that it was the rate of this heterolysis which limited the rates of nitration of reactive aromatic compounds. [Pg.11]

The octane numbers of many pure compounds have been measured and reported in the Hterature. Probably the most comprehensive project was carried out under the auspices of the American Petroleum Institute (18). Table 2 Hsts RON and MON values for a number of representative compounds. Some aromatic compounds cannot be tested neat in the knock engine, so these are evaluated at levels of 20%, and the equivalent octane number is calculated. The values for oxygenates in Table 2 have been reported elsewhere (19). [Pg.181]

The endoperoxides of polynuclear aromatic compounds are crystalline soHds that extmde singlet oxygen when heated, thus forming the patent aromatic hydrocarbon (44,66,80,81). Thus 9,10-diphenyl-9,10-epidioxyanthrancene [15257-17-7] yields singlet oxygen and 9,10-diphenylanthracene. [Pg.108]

Usually best choice for desiccation of gases (<3% water) such as argon, helium, hydrogen, chlorine, hydrogen chloride, sulfur dioxide, ammonia, air, and chemical classes such as aliphatics, aromatics, halogenated compounds, oxygenated compounds (siUca gel, zeoHtes, activated alumina all alternatives some regenerable, some not). [Pg.458]

Styrene undergoes many reactions of an unsaturated compound, such as addition, and of an aromatic compound, such as substitution (2,8). It reacts with various oxidising agents to form styrene oxide, ben2aldehyde, benzoic acid, and other oxygenated compounds. It reacts with benzene on an acidic catalyst to form diphenylethane. Further dehydrogenation of styrene to phenylacetylene is unfavorable even at the high temperature of 600°C, but a concentration of about 50 ppm of phenylacetylene is usually seen in the commercial styrene product. [Pg.477]

Coke-oven tar is an extremely complex mixture, the main components of which are aromatic hydrocarbons ranging from the monocyclics benzene and alkylbenzenes to polycycHc compounds containing as many as twenty or more rings. HeterocycHc compounds containing oxygen, nitrogen, and sulfur, but usually only one heteroatom per ring system are present. Small amounts of paraffinic, olefinic, and partly saturated aromatic compounds also occur. [Pg.343]

One example of normal-phase liquid chromatography coupled to gas chromatography is the determination of alkylated, oxygenated and nitrated polycyclic aromatic compounds (PACs) in urban air particulate extracts (97). Since such extracts are very complex, LC-GC is the best possible separation technique. A quartz microfibre filter retains the particulate material and supercritical fluid extraction (SPE) with CO2 and a toluene modifier extracts the organic components from the dust particles. The final extract is then dissolved in -hexane and analysed by NPLC. The transfer at 100 p.1 min of different fractions to the GC system by an on-column interface enabled many PACs to be detected by an ion-trap detector. A flame ionization detector (PID) and a 350 p.1 loop interface was used to quantify the identified compounds. The experimental conditions employed are shown in Table 13.2. [Pg.362]

Alkylated, oxygenated and nitrated polycyclic aromatic compounds... [Pg.363]

Figure 13.16 LC separation of urban air particulate exrtact (a), along with the GC/FID cliro-matogram (b) of an oxy-PAC fraction (transfeired via a loop-type interface). Reprinted from Environmental Science and Technology, 29, A. C. Lewis et al., On-line coupled LC-GC-ITD/MS for the identification of alkylated, oxygenated and nirtated polycyclic aromatic compounds in urban air particulate exti acts , pp. 1977-1981, copyright 1995, with permission from the American Chemical Society. Figure 13.16 LC separation of urban air particulate exrtact (a), along with the GC/FID cliro-matogram (b) of an oxy-PAC fraction (transfeired via a loop-type interface). Reprinted from Environmental Science and Technology, 29, A. C. Lewis et al., On-line coupled LC-GC-ITD/MS for the identification of alkylated, oxygenated and nirtated polycyclic aromatic compounds in urban air particulate exti acts , pp. 1977-1981, copyright 1995, with permission from the American Chemical Society.
A. C. Eewis, R. E. Robinson, K. D. Bartle and M. J. Pilling, On-line coupled EC-GC-ITD/MS for the identification of alkylated, oxygenated and nitr-ated polycyclic aromatic compounds in urban ah particulate extr acts . Environ. Sci. Technol. 29 1977-1981 (1995). [Pg.376]

R. B. Gaines, E. B. Ledford-Jr and J. D. Stuait, Analysis of water samples for ti ace levels of oxygenated and aromatic compounds using headspace solid-phase microexti action and comprehensive two-dimensional gas clnomatography , ]. Microcolumn Sep. 10 597-604(1998). [Pg.432]

Aromatic compounds with a functional group containing oxygen ortho to a group containing hydrogen Diamino compounds (loss of NH3)... [Pg.129]

Application of NMR has been made to a restricted range of chlorinated aromatic compounds (Kolehmainen et al. 1992), and has been used to establish the source of oxygen in the metabolites produced from acetate and 02 by Aspergillus melleus (Staunton and Sutkowski 1991). [Pg.287]

Several pathways are used for the aerobic degradation of aromatic compounds with an oxygenated C2 or C3 side chain. These include acetophenones and reduced compounds that may be oxidized to acetophenones, and compounds including tropic acid, styrene, and phenylethylamine that can be metabolized to phenylacetate, which has already been discussed. [Pg.433]

In the absence of molecular oxygen, a nnmber of alternative electron acceptors may be used these include nitrate, sulfate, selenate, carbonate, chlorate, Fe(III), Cr(VI), and U(VI), and have already been discussed in Chapter 3, Part 2. In Chapter 14, which deals with applications, attention is directed primarily to the role of nitrate, sulfate, and Fe(III)— with only parenthetical remarks on Cr(VI) and U(VI). The role of nitrate and sulfate as electron acceptors for the degradation of monocyclic aromatic compounds is discnssed, and the particularly broad metabolic versatility of sulfate-reducing bacteria is worthy of notice. [Pg.611]

With aromatic compounds that have benzylic sites, the peroxidation is easy. An apparatus in which tetrahydronaphthalene was distilled detonated. It was assumed that this accident was linked to the concentration of peroxide formed in contact with oxygen. When using phenols as inhibitors of oxidation (and polymerisation too) for all these compounds, this avoids these riste. [Pg.242]


See other pages where Aromatic compound oxygen is mentioned: [Pg.414]    [Pg.106]    [Pg.414]    [Pg.106]    [Pg.321]    [Pg.27]    [Pg.101]    [Pg.77]    [Pg.69]    [Pg.98]    [Pg.525]    [Pg.61]    [Pg.150]    [Pg.163]    [Pg.517]    [Pg.3]    [Pg.847]    [Pg.319]    [Pg.164]    [Pg.170]    [Pg.62]    [Pg.97]    [Pg.389]    [Pg.427]    [Pg.174]    [Pg.1567]    [Pg.248]    [Pg.39]    [Pg.145]    [Pg.554]    [Pg.106]    [Pg.118]    [Pg.385]    [Pg.435]   
See also in sourсe #XX -- [ Pg.90 ]

See also in sourсe #XX -- [ Pg.90 ]




SEARCH



Aromatic Compounds Containing Benzyl-Oxygen Linkages

Aromatic oxygenates

Aromatics oxygenated

Compounds oxygenated

Of oxygenated aromatic compounds

Oxygen compounds

Oxygenate compounds

Oxygenous compound

© 2024 chempedia.info