Sulfur, analysis

It may be recalled that in the initial analysis sulfuric acid was used as a purge species. It is obvious that this is not possible anymore since one of the dangerous components, namely formaldehyde, cannot be brought into contact with sulfuric acid. Thus the computer must generate new piping and source and sink structure to allow the computer to find a purge route. 

Microanalytical techiuques such as laser microprobe (Kelley and Fallick 1990 Crowe et al. 1990 Hu et al. 2003 Ono et al. 2006) and ion microprobe (Chaussidon et al. 1987, 1989 Eldridge et al. 1988, 1993) have become promising tools for determining sulfur isotope ratios. These techniques have several advantages over conventional techniques such as high spatial resolution and the capability for in-situ spot analysis. Sulfur isotopes are fractionated during ion or laser bombardment, but fractionation effects are mineral specific and reproducible. 

Sulfur is found in many industrial wastes, marine algae, and sediment samples. Sulfur may mask the region of chromatogram, overlapping with peaks of interest. For example, in pesticides analysis, sulfur can mask over many pesticides such as lindane, aldrin, and heptachlor. Sulfur has a solubility similar to the organochlorine and organophosphorus pesticides and it cannot be separated by Florisil cleanup method. 

In addition to the methods based on instrumental analysis, sulfur mustard exposure can be detected using immunoassays. Antibodies that can recognize DNA adducts have been raised. In an immunoslotblot assay exposures to sulfur mustard could be verified in DNA that is obtained from blood or skin (Benschop et al 1997 Van der Schans et al, 2004b). 

According to ESCA and SIMS analysis sulfur on the catalyst surfaces was, on the basis of binding energies (161-162 eV for sulfides) in the form of sulfides. No elemental sulfur was detected by ESCA measurements when the analyzed sample was cooled to liquid nitrogen temperature before analysis, to avoid the loss of easily volatized sulfur from the sample. 

Table 1. Chemical analysis of the as-extruded alloys. Concentrations (in atomic percent) were determined by inductively coupled plasma analysis. Sulfur, oxygen and nitrogen contents were determined by combustion analysis.

Pneumatic Sulfur-Spraying System. Sulfur-Coated Urea with Sealant. Figure 3 is a flow diagram of the pneumatic sulfur-spraying system. This system provides better atomization than the hydraulic system, which is discussed later. With the pneumatic system less sulfur is required, producing a higher analysis sulfur-coated urea fertilizer. 

Sulfate Filter - Water Extraction and colorimetric analysis Sulfur gas oxidation product... 

Instrumental methods are now becoming accepted as alternative techniques, provided they are shown to give equivalent results to the conventional test. These methods can allow a greater throughput of samples, with less operator dependence than conventional techniques, and often generate useful data that were not previously available. In fact, there are some instrumental companies, i.e., LECO Corporation, devoted almost exclusively to the development and sale of apparatus for chemical analysis - immediate analysis, elemental analysis, sulfur determination -calorific value, ash fusibility, and other technical tests of coals. 

Size of Coal, Designating from its Screen Analysis Sulfur in Coal Ash Sulfur, Forms of, in Coal Tumbler Test for Coal... 

The HgCljSOj complex stabilizes the readily oxidized sulfur dioxide from the reaction with oxidants such as ozone and nitrogen oxides. For analysis, sulfur dioxide in the scrubbing medium is reacted with formaldehyde ... 

Trofimov, B.A., N.M. Vitkovskaya, V.B. Kobychev et al. 2001. Addition of pyrrole anions to carbon disulfide. Theoretical analysis. Sulfur Lett 24 (4) 181-190. 

---