Alkenes rate constants

The chemically activated molecules are fonned by reaction of with the appropriate fliiorinated alkene. In all these cases apparent non-RRKM behaviour was observed. As displayed in figure A3.12.11 the measured imimolecular rate constants are strongly dependent on pressure. The large rate constant at high pressure reflects an mitial excitation of only a fraction of the total number of vibrational modes, i.e. initially the molecule behaves smaller than its total size. However, as the pressure is decreased, there is time for IVR to compete with dissociation and energy is distributed between a larger fraction of the vibrational modes and the rate constant decreases. At low pressures each rate constant approaches the RRKM value. 

Heberger K and Fischer H 1993 Rate constants for the addition of the 2-cyano-2-propyl radical to alkenes in solution Int. J. Chem. Kin. 25 249-63... 

In laser-impulse experiments with chlorophenyldiazirine the carbene could be observed by UV spectroscopy. On addition of defined amounts of alkene the rate of cyclopropanation was measured directly. The rate constants with various alkenes were (lO moF s ) 1-hexene, 1.3 ( )-2-pentene, 34 2-methyl-2-butene, 77 2,3-dimethyl-2-butene, 130 (80JA7576>. 

The N+ relationship, as discussed above, is a systematization of experimental facts. The equation of Scheme 7-4 has been applied to nearly 800 rate constants of over 30 electrophiles with about 80 anionic, neutral, and even cationic nucleophiles covering a range of measured rate constants between 10-8 and 109s 1 (Ritchie, 1978). Only about a dozen rate constants deviated from the predicted values by more than a factor of 10, and about fifty by factors in the range 5-10. It is therefore, very likely that this correlation is not purely accidental. Other workers have shown it to be valid for other systems, e.g., for ferrocenyl-stabilized cations (Bunton et al., 1980), for coordinated cyclic 7r-hydrocarbons (Alovosus and Sweigart, 1985), and for selectivities of diarylcarbenes towards alkenes (Mayr, 1990 Mayr et al., 1990). On the other hand, McClelland et al. (1986) found that the N+ relationship is not applicable to additions of less stable triphenylmethyl cations. 

Explicit mechanisms attempt to include all nonmethane hydrocarbons believed present in the system with an explicit representation of their known chemical reactions. Atmospheric simulation experiments with controlled NMHC concentrations can be used to develop explicit mechanisms. Examples of these are Leone and Seinfeld (164), Hough (165) and Atkinson et al (169). Rate constants for homogeneous (gas-phase) reactions and photolytic processes are fairly well established for many NMHC. Most of the lower alkanes and alkenes have been extensively studied, and the reactions of the higher family members, although little studied, should be comparable to the lower members of the family. Terpenes and aromatic hydrocarbons, on the other hand, are still inadequately understood, in spite of considerable experimental effort. Parameterization of NMHC chemistry results when NMHC s known to be present in the atmosphere are not explicitly incorporated into the mechanism, but rather are assigned to augment the concentration of NMHC s of similar chemical nature which the... 

Vrbaski and Cvetanovic (107) have found linear relationships between the logarithm of the rate constant for the reaction of various alkenes with electrophiles and the corresponding ionization potential. 

Addition of phosphonyl radicals onto alkenes or alkynes has been known since the sixties [14]. Nevertheless, because of the interest in organic synthesis and in the initiation of free radical polymerizations [15], the modes of generation of phosphonyl radicals [16] and their addition rate constants onto alkenes [9,12,17] has continued to be intensively studied over the last decade. Narasaka et al. [18] and Romakhin et al. [19] showed that phosphonyl radicals, generated either in the presence of manganese salts or anodically, add to alkenes with good yields. 

The rate constants for the 02 reaction do not vary significantly with different ligands (X = F, Cl, Br). The reaction of trans-[ r(CO)(CH3CN)(PPh3)2]1 with 102 is slightly slower than for the halide analogues.621 The peroxo compounds do not react with alkenes. 

Partition rate constant ratios from kinetic analyses of alkene hydration 77... 

The determination of large values of the rate constant ratio ks/kpfrom the low yields of alkene product that forms by partitioning of carbocations in nucleophilic solvents. These rate constant ratios may then be combined with absolute rate constants for the overall decay of the carbocation to give absolute values of kp (s ).14 16 For example, the reaction of the l-(4-methylphenyl)ethyl carbocation in 50/50 (v/v) trifluoroethanol/water gives mainly the solvent adducts and a 0.07% yield of 4-methylstyrene from proton transfer to solvent, which corresponds to kjkp = 1400. This can be combined with ks = 6 x 109 s V4 to give kp = 4.2 x 106 s l (Table 1). 

The quantitation of products that form in low yields requires special care with HPLC analyses. In cases where the product yield is <1%, it is generally not feasible to obtain sufficient material for a detailed physical characterization of the product. Therefore, the product identification is restricted to a comparison of the UV-vis spectrum and HPLC retention time with those for an authentic standard. However, if a minor reaction product forms with a UV spectrum and HPLC chromatographic properties similar to those for the putative substitution or elimination reaction, this may lead to errors in structural assignments. Our practice is to treat rate constant ratios determined from very low product yields as limits, until additional evidence can be obtained that our experimental value for this ratio provides a chemically reasonable description of the partitioning of the carbocation intermediate. For example, verification of the structure of an alkene that is proposed to form in low yields by deprotonation of the carbocation by solvent can be obtained from a detailed analysis of the increase in the yield of this product due to general base catalysis of carbocation deprotonation.14,16... 

Fig. 1 Free energy reaction coordinate profiles for hydration and isomerization of the alkene [2] through the simple tertiary carbocation [1+], The rate constants for partitioning of [1 ] to form [l]-OSolv and [3] are limited by solvent reorganization (ks = kteorg) and proton transfer (kp), respectively. For simplicity, the solvent reorganization step is not shown for the conversion of [1+] to [3], but the barrier for this step is smaller than the chemical barrier to deprotonation of [1 ] (kTtOTg > kp).

Values of the rate constant ratios ks/kp for partitioning of carbocations between nucleophilic addition of solvent and deprotonation. These rate constant ratios were determined by analysis of the yields of the solvent adduct and alkene that form by partitioning of the carbocation (equation ) ... 

The partitioning of ferrocenyl-stabilized carbocations [30] between nucleophile addition and deprotonation (Scheme 18) has been studied by Bunton and coworkers. In some cases the rate constants for deprotonation and nucleophile addition are comparable, but in others they favor formation of the nucleophile adduct. However, the alkene product of deprotonation of [30] is always the thermodynamically favored product.120. In other words, the addition of water to [30] gives an alcohol that is thermodynamically less stable than the alkene that forms by deprotonation of [30], but the reaction passes over an activation barrier whose height is equal to, or smaller than, the barrier for deprotonation of [30], These data require that the intrinsic barrier for thermoneutral addition of water to [30] (As) be smaller than the intrinsic barrier for deprotonation of [30] (Ap). It is not known whether the magnitude of (Ap — As) for the reactions of [30] is similar to the values of (Ap - As) = 4-6 kcal mol 1 reported here for the partitioning of a-methyl benzyl carbocations. 

The incorporation of the alkene product of carbocation deprotonation into an aromatic system results in the expected changes in the absolute rate constant kp and the product rate constant ratio kjkp for reaction of the carbocation. 

Adeniji, S.A., Kerr, J.A., Williams, M.R. (1981) Rate constants for ozone-alkene reactions under atmospheric conditions. Int. J. Chem. Kinet. 13, 209-217. 

Lloyd, A.C., Darnall, K.R., Winer, A.M., Pitts, Jr., J.N. (1976) Relative rate constants for reaction of the hydroxyl radical with a series of alkanes, alkenes, and aromatic hydrocarbons. J. Phys. Chem. 80, 189-794. 

There are several guidelines that should be followed in order to increase the chemoselectivity of the monoadduct. Firstly, radical concentration must be low in order to suppress radical termination reactions (rate constant of activation [fcal and fca2] < < rate constant of deactivation kd t andfcd2]). Secondly, further activation of the monoadduct should be avoided ( al> >kd2). Lastly, formation of oligomers should be suppressed, indicating that the rate of deactivation (kd 2[Cu"LmX]) should be much larger than the rate of propagation ( [alkene]). Alkyl halides for copper-catalyzed ATRA are typically chosen such that if addition occurs, then the newly... 

---