Alkenes palladium chloride catalysts

The reaction is highly exothermic as one might expect for an oxidation reaction. The mechanism is shown in Figure 15.1. Palladium chloride is the catalyst, which occurs as the tetrachloropalladate in solution, the resting state of the catalyst. Two chloride ions are replaced by water and ethene. Then the key-step occurs, the attack of a second water molecule (or hydroxide) to the ethene molecule activated towards a nucleophilic attack by co-ordination to the electrophilic palladium ion. The nucleophilic attack of a nucleophile on an alkene coordinated to palladium is typical of Wacker type reactions. 

While hydrosilylation of 1-alkenes and HSiCl3 with platinum catalysts provides linear products (1-trichlorosilylalkanes), palladium chloride modified with phosphines gives products carrying the trichlorosilyl group at the secondary carbon. This is highly remarkable because all other metal complexes studied so far lead to 1-substituted products. This regioselectivity leads to the possibility to carry out asymmetric hydrosilylation. 

Palladium catalysts are more often modified for special selectivities than platinum catalysts. Palladium prepared by reduction of palladium chloride with sodium borohydride Procedure 4, p. 205) is suitable for the reduction of unsaturated aldehydes to saturated aldehydes [i7]. Palladimn on barium sulfate deactivated with sulfur compounds, most frequently the so-called quinoline-5 obtained by boiling quinoline with sulfur [34], is suitable for the Rosenmund reduction [i5] (p. 144). Palladium on calcium carbonate deactivated by lead acetate Lindlar s catalyst) is used for partial hydrogenation of acetylenes to cw-alkenes [36] (p. 44). 

The effect of the nature of the electrophile on the stereoselectivity of reactions with substrates containing a terminal alkene and an allylic substituent is dramatically illustrated by some recent results with palladium electrophiles.124 Cyclizations of 3-methyl- or 3-phenyl-5-hydroxyalkenes with palladium catalysts proceed with high selectivity (>9 1) for the 2,3-trans isomer (equation 41).50-124 It is suggested that the steric interactions of the palladium-alkene complex affects the stereochemistry of these cyclizations. In some related cyclizations to form tetrahydropyran products (equation 42 and Table 10), reaction with iodine in the presence of sodium bicarbonate gives a different major diastereomer from cyclization with mercury(II) trifluoroacetate or palladium chloride.123... 

One of the earliest uses of palladium(II) salts to activate alkenes towards additions with oxygen nucleophiles is the industrially important Wacker process, wherein ethylene is oxidized to acetaldehyde using a palladium(II) chloride catalyst system in aqueous solution under an oxygen atmosphere with cop-per(II) chloride as a co-oxidant.1,2 The key step in this process is nucleophilic addition of water to the palladium(II)-complexed ethylene. As expected from the regioselectivity of palladium(II)-assisted addition of nucleophiles to alkenes, simple terminal alkenes are efficiently converted to methyl ketones rather than aldehydes under Wacker conditions. 

Arylsulfonyl chlorides react similarly with palladium(0) catalysts, producing sulfur dioxide and arylpaUadium chlorides. In the presence of activated alkenes, the combination forms arylated alkenes in modest yields (equation 49).110... 

When either an alcohol or an amine function is present in the alkene, the possibility for lactone or lactam formation exists. Cobalt or rhodium catalysts convert 2,2-dimethyl-3-buten-l-ol to 2,3,3-trimethyl- y-butyrolactone, with minor amounts of the 8-lactone being formed (equation 51).2 In this case, isomerization of the double bond is not possible. The reaction of allyl alcohols catalyzed by cobalt or rhodium is carried out under reaction conditions that are severe, so isomerization to propanal occurs rapidly. Running the reaction in acetonitrile provides a 60% yield of lactone, while a rhodium carbonyl catalyst in the presence of an amine gives butane-1,4-diol in 60-70% (equation 52).8 A mild method of converting allyl and homoallyl alcohols to lactones utilizes the palladium chloride/copper chloride catalyst system (Table 6).79,82 83... 

Dicarboxylation reactions of alkenes can be carried out such that predominately 1,2-addition of the two ester functions occurs (equation 61). The reaction takes place under mild conditions (1-3 bar, 25 C) in alcohol. It is stoichiometric in palladium, since the palladium(II) catalyst is reduced to palladium(O) in the process, but by use of an oxidant (stoichiometric copper chloride or catalytic copper chloride plus oxygen equation 62 and 63) the reaction becomes catalytic in palladium. In the reoxidation process, water is generated and the build-up of water increases the water gas shift reaction at the expense of the carboxylation. Thus a water scavenger such as triethyl orthoformate is necessary for a smooth reaction. 

The rhodium(II) catalysts and the chelated copper catalysts are considered to coordinate only to the carbenoid, while copper triflate and tetrafluoioborate coordinate to both the carbenoid and alkene and thus enhance cyclopropanation reactions through a template effect.14 Palladium-based catalysts, such as palladium(II) acetate and bis(benzonitrile)palladium(II) chloride,l6e are also believed to be able to coordinate with the alkene. Some chiral complexes based on cobalt have also been developed,21 but these have not been extensively used. 

To overcome the problems encountered in the homogeneous Wacker oxidation of higher alkenes several attempts have been undertaken to develop a gas-phase version of the process. The first heterogeneous catalysts were prepared by the deposition of palladium chloride and copper chloride on support materials, such as zeolite Y [2,3] or active carbon [4]. However, these catalysts all suffered from rapid deactivation. Other authors applied other redox components such as vanadium pentoxide [5,6] or p-benzoquinone [7]. The best results have been achieved with catalysts based on palladium salts deposited on a monolayer of vanadium oxide spread out over a high surface area support material, such as y-alumina [8]. Van der Heide showed that with catalysts consisting of H2PdCU deposited on a monolayer vanadium oxide supported on y-alumina, ethene as well as 1-butene and styrene... 

In combination with the incremental advances concerning reaction conditions in recent years, especially for low-pressure carbonylations, there is a trend toward increasing use of this chemistry to synthesize advanced building blocks. In this respect carboxylation of alkenes with an appropriate alcohol or amine function leads to the formation of lactones or lactams. Thus, cobalt, rhodium, or palladium chloride/copper chloride catalysts convert allyl and homoallyl alcohols or amines to the corresponding butyrolactones or butyrolactams, respectively [15]. 

Photochemical decomposition of diazo(trimethylsilyl)methane (1) in the presence of alkenes has not been thoroughly investigated (see Houben-Weyl Vol. E19b, p 1415). The available experimental data [trimethylsilylcyclopropane (17% yield) and la,2a,3j8-2,3-dimethyl-l-trimethylsilylcyclopropane (23% yield)] indicate that cyclopropanation occurs only in low yield with ethene and ( )-but-2-ene. In both cases the formal carbene dimer is the main product. In reactions with other alkenes, such as 2,3-dimethylbut-2-ene, tetrafluoroethene or hexafluoro-propene, no cyclopropanes could be detected.The transition-metal-catalyzed decomposition of diazo(trimethylsilyl)methane (1) has been applied to the synthesis of many different silicon-substituted cyclopropanes (see Table 3 and Houben-Weyl Vol.E19b, p 1415) 3.20a,b,2i.25 ( iQp. per(I) chloride has been most commonly used for carbene transfer to ethyl-substituted alkenes, cycloalkenes, styrene, and related arylalkenes. For the cyclopropanation of acyl-substituted alkenes, palladium(II) chloride is the catalyst of choice, while palladium(II) acetate was less efficient, and copper(I) chloride, copper(II) sulfate and rhodium(II) acetate dimer were totally unproductive. The cyclopropanation of ( )-but-2-ene represents a unique... 

The selectivity of palladium and gold for alkene oxidation to aldehydes 28,29,170) was attributed initially to adsorption strength. However, electrooxidation in the presence of palladium ions indicates possible homogeneous alkene insertion, similar to the Wacker process 304). Homogeneous reaction is also involved in redox oxidations of hydrocarbons. In this case, the nature of the metal ions is expected to control selectivity. Indeed, toluene yields 20% benzaldehyde in electrolytes containing Ce salts, while oxidation proceeds to benzoic acid with Cr redox catalysts 311). In addition, the concentration of redox catalysts appears to affect yields in nonelectrochemical oxidation of ethylene large amounts of palladium chloride promote butene formation at the expense of acetaldehyde 312). Finally, the role of the electrolyte and solvent should not be ignored. For instance, electrooxidation of ethylene on carbon, in aqueous solution of acetic acid yields acetaldehyde 313) in the... 

The best reagent for selective reduction of alkynes to the cis alkene is the Lindlar catalyst.3 1 Palladium chloride (PdCl2) was precipitated on calcium carbonate (CaCOs) in acidic media and deactivated with lead tetraacetate [Pb(OAc)4] to give the named Pd-CaC03-Pb0 catalyst. Reduction of alkynes will stop at the cis alkene with little or no cis-trans isomerization. A variation uses quinoline as a poison, and this catalyst was used by Overman and co-workers to convert alkyne 378 to cis-alkene 379 as part of a synthesis of... 

The oxidation of ethylene to acetaldehyde employing palladium chloride and cupric chloride as catalysts and molecular oxygen as oxidant. The reaction has been extensively developed for the oxidation of terminal alkenes to methyl ketones ... 

Homooligomerization of alkynes using palladium chloride as catalyst has been studied extensivelyHowever, few examples are known of cooligomerization of alkynes and monoolefins probably because of the difficulty due to the large difference in coordinalion ability between alkynes and alkenes to the metal center alkynes are more reactive to metals than alkenes are, which results in exclusive polymerization of the alkynes. Therefore, in order to accomplish the cooligomerization of alkynes and alkenes, it is very important to select suitable alkynic or alkenic compounds with similar orders of coordination ability to a metal, or to devise reactive conditions in which extensive alkyne polymerization is prevented. 

The groups R2N and Cl can be added directly to alkenes, allenes, conjugated dienes, and alkynes, by treatment with dialkyl-V-chloroamines and acids. " These are free-radical additions, with initial attack by the R2NH- radical ion. " N-Halo amides (RCONHX) add RCONH and X to double bonds under the influence of UV light or chromous chloride. " Amines add to allenes in the presence of a palladium catalyst. ... 

Chlorostannate ionic liquids have been used in hydroformylation reactions [23], Acidic [bmimjCl-SnCb and [l-butyl-4-methylpyridinium]Cl-SnCl2 were prepared from mixing the respective [cation]+ Cl with tin(II)chloride in a ratio of 100 104, much in the same way that the chloroaluminates are made (see Chapter 4). Both these chlorostannate ionic liquids melt below 25 °C. Addition of Pd(PPh3)2Cl2 to these chlorostannate ionic liquids leads to a reaction medium that catalyses the hydroformylation of alkenes such as methyl-3-pentenoate as shown in Scheme 8.9. The ionic liquid-palladium catalyst solution is more effective than the corresponding homogeneous dichloromethane-palladium catalyst solution. The product was readily separated from the ionic liquid by distillation under vacuum. This is an important reaction as it provides a clean route to adipic acid. 

The metal-catalysed autoxidation of alkenes to produce ketones (Wacker reaction) is promoted by the presence of quaternary ammonium salts [14]. For example, using copper(II) chloride and palladium(II) chloride in benzene in the presence of cetyltrimethylammonium bromide, 1-decene is converted into 2-decanone (73%), 1,7-octadiene into 2,7-octadione (77%) and vinylcyclohexane into cyclo-hexylethanone (22%). Benzyltriethylammonium chloride and tetra-n-butylammo-nium hydrogen sulphate are ineffective catalysts. It has been suggested that the process is not micellar, although the catalysts have the characteristics of those which produce micelles. The Wacker reaction is also catalysed by rhodium and ruthenium salts in the presence of a quaternary ammonium salt. Generally, however, the yields are lower than those obtained using the palladium catalyst and, frequently, several oxidation products are obtained from each reaction [15]. 

In new studies heteropoly acids as cocatalysts were found to be very effective in combination with oxygen in the oxidation of ethylene.1311 Addition of phosphomo-lybdic acid to a chloride ion-free Pd(II)-Cu(II) catalyst system results in a great increase in catalytic activity and selectivity.1312 Aerobic oxidation of terminal alkenes to methy ketones can be performed with Pd(OAc)21313 or soluble palladium complexes. Modified cyclodextrins accelerates reaction rates and enhance selectivities in two-phase systems under mild conditions.1315 1316... 

---