Acid chloride hydrolysis

The method of hydrolysis depends on the nature of the product. It is usually sufficient to add dilute sulphuric acid to the ethereal solution and to shake thoroughly, when the magnesium enters the aqueous solution, whilst the organic compound remains in the ether. Alternatively, however, the ethereal solution may be poured on to ice and water, and then treated with dilute sulphuric acid. Should the product be affected by this acid, the hydrolysis can be carried out with an aqueous solution of ammonium chloride. In the following examples the hydrolysis is usually shown as a simple double decomposition... 

The acid chloride is available commercially, but it is more economical to prepare it from the acid as and when required. Furthermore, 3 5-dini-trobenzoyl chloride tends to undergo hydrolysis if kept for long periods, particularly if the stock bottle is frequently opened. The substance may, however, be stored under light petroleum. 

Dichloroacetic acid is produced in the laboratory by the reaction of chloral hydrate [302-17-0] with sodium cyanide (31). It has been manufactured by the chlorination of acetic and chloroacetic acids (32), reduction of trichloroacetic acid (33), hydrolysis of pentachloroethane [76-01-7] (34), and hydrolysis of dichloroacetyl chloride. Due to similar boiling points, the separation of dichloroacetic acid from chloroacetic acid is not practical by conventional distillation. However, this separation has been accompHshed by the addition of a eotropeforming hydrocarbons such as bromoben2ene (35) or by distillation of the methyl or ethyl ester. 

Preparation of Arylcarboxylic Acids and Derivatives. The general Friedel-Crafts acylation principle can be successfully appHed to the preparation of aromatic carboxyUc acids. Carbonyl haUdes (phosgene, carbonyl chloride fluoride, or carbonyl fluoride) [353-50-4] are diacyl haUdes of carbonic acid. Phosgene [75-44-5] or oxalyl chloride [79-37-8] react with aromatic hydrocarbons to give aroyl chlorides that yield acids on hydrolysis (133) ... 

Phosphonic (phosphorous) acid, produced by hydrolysis of PCl, is for the most part consumed captively. It has also been offered as a flaked product and a 70 wt % solution by Rhc ne-Poulenc. Phosphonic acid is a by-product from manufacturing carboxyHc acid chlorides and alkaH peroxides. Additional by-product phosphonic acid is recovered in the manufacture of phosphinic acid. 

Sulfosahcyhc acid is prepared by heating 10 parts of sahcyhc acid with 50 parts of concentrated sulfuric acid, by chlorosulfonation of sahcyhc acid and subsequent hydrolysis of the acid chloride, or by sulfonation with hquid sulfur trioxide in tetrachloroethylene. It is used as an intermediate in the production of dyestuffs, grease additives, catalysts, and surfactants. It is also useful as a colorimetric reagent for ferric iron and as a reagent for albumin. Table 9 shows the physical properties of sahcyhc acid derivatives. 

Health nd Safety Factors. Thionyl chloride is a reactive acid chloride which can cause severe bums to the skin and eyes and acute respiratory tract injury upon vapor inhalation. The hydrolysis products, ie, hydrogen chloride and sulfur dioxide, are beheved to be the primary irritants. Depending on the extent of inhalation exposure, symptoms can range from coughing to pulmonary edema (182). The LC q (rat, inhalation) is 500 ppm (1 h), the DOT label is Corrosive, Poison, and the OSHA PEL is 1 ppm (183). The safety aspects of lithium batteries (qv) containing thionyl chloride have been reviewed (184,185). 

Acylated Protein Hydrolysates. These surfactants are prepared by acylation of proteia hydrolysates with fatty acids or acid chlorides. The hydrolysates are variable ia composition, depending on the degree of hydrolysis. CoUagen from leather (qv) processiag is a common proteia source. Acylated proteia hydrolysates (Maypoa, by laotex Chemical Company) are mild surfactants recommended for personal-care products (see Cosmetics). 

Pyridazinecarboxamides are prepared from the corresponding esters or acid chlorides with ammonia or amines or by partial hydrolysis of cyanopyridazines. Pyridazinecarboxamides with a variety of substituents are easily dehydrated to nitriles with phosphorus oxychloride and are converted into the corresponding acids by acid or alkaline hydrolysis. They undergo Hofmann degradation to give the corresponding amines, while in the case of two ortho carboxamide groups pyrimidopyridazines are formed. 

The first, and still widely used, polymer-supported ester is formed from an amino acid and a chloromethylated copolymer of styrene-divinylbenzene. Originally it was cleaved by basic hydrolysis (2 N NaOH, FtOH, 25°, 1 h). Subsequently, it has been cleaved by hydrogenolysis (H2/Pd-C, DMF, 40°, 60 psi, 24 h, 71% yield), and by HF, which concurrently removes many amine protective groups. Monoesterification of a symmetrical dicarboxylic acid chloride can be effected by reaction with a hydroxymethyl copolymer of styrene-divinylbenzene to give an ester a mono salt of a diacid was converted into a dibenzyl polymer. ... 

Caibamates ate formed from an amine with a wide variety of reagents, of which the chloroformate is the most common amides are formed from the acid chloride. -Alkyl caibamates are cleaved by acid-catalyzed hydrolysis A/-alkylamides are cleaved by acidic or basic hydrolysis at teflux. conditions that cleave peptide bonds. 

Chlorophenylacetic acid has been prepared from mandeloni-trile and hydrochloric acid in a sealed tube, from mandelic acid and hydrochloric acid in a sealed tube/ from a-nitrostyrene and hydrochloric acid in a sealed tube, from phenylglycine, hydrochloric acid, and sodium nitrite, from mandelic acid and phosphorus pentachloride (to give the acid chloride which is then hydrolyzed), and, in poor yield, from mandelic acid and thionyl chloride. In the method described, ethyl mandelate is prepared according to Fischer and Speier. The conversion to the chloroester and the acid hydrolysis step are modifications of a preparation described by McKenzie and Barrow. ... 

At one time these were the only commercially important non-silane coupling agents. Supplied by du Pont under the Volan tradename, they are coordination complexes of carboxylic acids with chromium(III) chlorides. Hydrolysis of the... 

A rather special procedure for the preparation of 21-hydroxy-20-ketopreg-nanes starts with the 17a-ethoxyethynyl-17 -hydroxy steroids described earlier. Free radical addition of ethanethiol to the triple bond, followed by acid-catalyzed hydrolysis and dehydration gives the 20-thioenol ether 21-aldehyde. This can be reduced with lithium aluminum hydride to the C-21 alcohol and then hydrolyzed to the C-20 ketone in the presence of mercuric chloride. The overall yield, without isolation of intermediates, is in the order of 50% ... 

Selective hydroxylation with osmium tetroxide (one equivalent in ether-pyridine at 0 ) converts (27) to a solid mixture of stereoisomeric diols (28a) which can be converted to the corresponding secondary monotoluene-sulfonate (28b) by treatment with /7-toluenesulfonyl chloride in methylene dichloride-pyridine and then by pinacol rearrangement in tetrahydrofuran-lithium perchlorate -calcium carbonate into the unconjugated cyclohepte-none (29) in 41-48 % over-all yield from (27). Mild acid-catalyzed hydrolysis of the ketal-ketone (29) removes the ketal more drastic conditions by heating at 100° in 2 hydrochloric acid for 24 hr gives the conjugated diketone (30). 

Carboxylic acid derivative (Section 20.1) Compound that yields a carboxylic acid on hydrolysis. Carboxylic acid derivatives include acyl chlorides, acid anhydrides, esters, and amides. 

In their original communication on the alkylation and acylation of enamines, Stork et al. (3) had reported that the pyrrolidine enamine of cyclohexanone underwent monoacylation with acid chlorides. For example, the acylation with benzoyl chloride led to monobenzoylcyclohexanone. However, Hunig and Lendle (33) found that treatment of the morpholine enamine of cyclopentanone with 2 moles of propionyl chloride followed by acid hydrolysis gave the enol ester (56), which was proposed to have arisen from the intermediate (55). 

More recently the acylation of aldehyde enamines has been reinvestigated (75) and shown to proceed normally when the enamine is added to the acid chloride. The morpholine enamine of isobutyraldehyde (98), on being added to an ether solution of acetyl chloride, afforded the iminium salt (99), from which the ketoaldehyde (100) was obtained in 66% yield by hydrolysis (75). 

Acylation of the enamine (113) with a,/9-unsaturated acid chlorides has been shown (57) to give bicyclo(3.3.1)nonan-2,9-diones. Acryloyl ehloride on reaction with the enamine (113) and subsequent hydrolysis gave bicyelo-(3.3.1)nonan-2,9-dione (123). Mechanistic studies suggest that C alkylation by the olefin precedes acylation (87). 

The acylation of enamino ketones can take place on oxygen or on carbon. While reaction at nitrogen is a possibility, the N-acylated products are themselves acylating agents, and further reaction normally takes place. The first reported acylation of enamino ketones (72) was that of 129, prepared by acylation of the enamine (113), which was shown to have undergone O acylation because on mild hydrolysis the enol ester (130) could be isolated. A similar reaction took place with other aliphatic acid chlorides (80) and with dibasic acid chlorides [e.g., with succinyl chloride to give 118 above]. 

An acid-catalyzed substitution of a 6-oxo group on 2-aminopteridine-4,6-dione with hydrogen chloride in alcohols (65-100°, 3 hr, 80% yield) represents a convenient synthesis of the 6-alkoxy analogs. The reaction proceeds also with pteridine-2,4,6-trione and its 1-methyl and 1,3-dimethyl derivatives. While methoxylation of 2,4,7-trichloro-quinoline gives about equal amounts of 2- and 4-substitution, acid-catalyzed hydrolysis gives specific reaction at the 2-position only. ... 

---