Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

A-Halo alcohols

To now solve the problem posed at the beginning of this section, it s possible to use a halo alcohol in a Grignard reaction by employing a protection sequence. For example, we can add 3-bromo-l-propanol to acetaldehyde by the route shown in Figure 17.9. [Pg.628]

The addition of HX to an aldehyde or ketone gives a-halo alcohols, which are usually unstable, though exceptions are known, especially with perfluoro and perchloro species.231 Unstable a-halo alcohols may be quite stable in the dimeric form 2XCR2OH — XCR2OCR2X. [Pg.908]

It often happens, particularly during the synthesis of complex molecules, that one functional group in a molecule interferes with an intended reaction on a second functional group elsewhere in the same molecule. For example, we saw earlier in this chapter that a Grignard reagent can t be prepared from a halo alcohol because the C-Mg bond is not compatible witb i the presence of an acidic -OH group in the same molecule. [Pg.682]

When the halogenation of an aikene is carried out in aqueous solution, rather than in a non-nucleophiUc solvent, the major product is a halohydrin (also called a halo alcohol) instead of a w c-dihalide. [Pg.364]

It is frequently advisable in the routine examination of an ester, and before any derivatives are considered, to determine the saponification equivalent of the ester. In order to ensure that complete hydrolysis takes place in a comparatively short time, the quantitative saponi fication is conducted with a standardised alcoholic solution of caustic alkali—preferably potassium hydroxide since the potassium salts of organic acids are usuaUy more soluble than the sodium salts. A knowledge of the b.p. and the saponification equivalent of the unknown ester would provide the basis for a fairly accurate approximation of the size of the ester molecule. It must, however, be borne in mind that certain structures may effect the values of the equivalent thus aliphatic halo genated esters may consume alkali because of hydrolysis of part of the halogen during the determination, nitro esters may be reduced by the alkaline hydrolysis medium, etc. [Pg.392]

The reductive elimination of halohydrins provides a means of introduction of double bonds in specific locations, particularly as the halohydrin may be obtained from the corresponding a-halo ketone. This route is one way of converting a ketone into an olefin. (The elimination of alcohols obtainable by reduction has been covered above, and other routes will be discussed in sections IX and X.) An advantage of this method is that it is unnecessary to separate the epimeric alcohols obtained on reduction of the a-bromo ketone, since both cis- and tran -bromohydrins give olefins (ref. 185, p. 251, 271 cf. ref. 272). Many examples of this approach have been recorded. (For recent examples, see ref. 176, 227, 228, 242, 273.) The preparation of an-drost-16-ene (123) is illustrative, although there are better routes to this compound. [Pg.341]

Borohydrides reduce a-substituted ketones to the corresponding a-substituted alcohols, and such products can be further reduced to olefins (see section VIII). Other reagents serve, through participation of the carbonyl group, to remove the substituent while leaving the ketone intact. The zinc or chromous ion reduction of a-halo ketones is an example of this second type, which is not normally useful for double bond introduction. However, when the derivative being reduced is an a,jS-epoxy ketone, the primary product is a -hydroxy ketone which readily dehydrates to the a,jS-unsaturated ketone. Since... [Pg.348]

The rearrangement with ring contraction probably is the most important synthetic application of the Favorskii reaction it is for example used in the synthesis of steroids. Yields can vary from good to moderate. As solvents diethyl ether or alcohols are often used. With acyclic a-halo ketones bearing voluminous substituents in a -position, yields can be low a tcrt-butyl substituent will prevent the rearrangement. [Pg.112]

Corey used a chiral bromoborane 75 (1.1 equiv.) to promote the addition of tert-butyl bromoacetate (76) to aromatic, aliphatic, and a,P-unsaturated aldehydes to give the halo alcohols 77 with high enantio- and diastereoselectivities (Table 1.10) [35]. [Pg.20]

The imidazole nucleus is often found in biologically active molecules,3 and a large variety of methods have been employed for their synthesis.4 We recently needed to develop a more viable process for the preparation of kilogram quantities of 2,4-disubstituted imidazoles. The condensation of amidines, which are readily accessible from nitriles,5 with a-halo ketones has become a widely used method for the synthesis of 2,4-disubstituted imidazoles. A literature survey indicated that chloroform was the most commonly used solvent for this reaction.6 In addition to the use of a toxic solvent, yields of the reaction varied from poor to moderate, and column chromatography was often required for product isolation. Use of other solvents such as alcohols,7 DMF,8 and acetonitrile9 have also been utilized in this reaction, but yields are also frequently been reported as poor. [Pg.55]

The tosylatc must come from alcohol (44), Disconnection Lo an epoxide (45) is no good as the amine will attack the wrong atom. Change of oxidation level to (46) is more hopeful as the a-halo acid (47) is easily made. Another possibility is to use naturally occurring a 1 an ine ( 48),... [Pg.267]

The method is not restricted to secondary aryl alcohols and very good results were also obtained for secondary diols [39], a- and S-hydroxyalkylphosphonates [40], 2-hydroxyalkyl sulfones [41], allylic alcohols [42], S-halo alcohols [43], aromatic chlorohydrins [44], functionalized y-hydroxy amides [45], 1,2-diarylethanols [46], and primary amines [47]. Recently, the synthetic potential of this method was expanded by application of an air-stable and recyclable racemization catalyst that is applicable to alcohol DKR at room temperature [48]. The catalyst type is not limited to organometallic ruthenium compounds. Recent report indicates that the in situ racemization of amines with thiyl radicals can also be combined with enzymatic acylation of amines [49]. It is clear that, in the future, other types of catalytic racemization processes will be used together with enzymatic processes. [Pg.105]


See other pages where A-Halo alcohols is mentioned: [Pg.626]    [Pg.183]    [Pg.680]    [Pg.626]    [Pg.183]    [Pg.680]    [Pg.312]    [Pg.266]    [Pg.371]    [Pg.20]    [Pg.22]    [Pg.1014]    [Pg.1213]    [Pg.1232]    [Pg.74]    [Pg.167]    [Pg.168]    [Pg.95]    [Pg.447]    [Pg.526]   
See also in sourсe #XX -- [ Pg.908 ]




SEARCH



A-halo

© 2024 chempedia.info