Vapour phase methods

Methyl metacrylates, alcohols, aromatic and aliphatic carbohydrates, acetic ester acids are detected using he vapour-phase method. 

There has been eonsiderable interest in the synthesis, characterization and properties of nanowires of various inorganic materials [2, 99, 100]. Nanowires have been prepared using vapour phase methods such as vapour-liquid-solid (VLS) growth, vapour-solid... 

A vapour-phase method using reverse isotope exchange (since the sample itself is labelled) has been reported for the determination of Hg in urine. The dissolve sample is labelled with carrier-free Hg, cysteine is added and the acidity adjusted to pH 7.4. Mercury vapour in a carrier stream of nitrogen is passed through the sample solution and the exhaust vapour collected by adsorption on Hopcalite. Under standard conditions, the activity of the adsorbent can then be related to the Hg concentration in the urine sample. The limit of detection is 0.025 /g, but the method is of most value for concentrations above 0.01 p.p.m. 

The breaking up of azeotropic mixtures. The behaviour of constant boiling point mixtures simulates that of a pure compound, because the composition of the liquid phase is identical with that of the vapour phase. The composition, however, depends upon the pressure at which the distillation is conducted and also rarely corresponds to stoichiometric proportions. The methods adopted in practice will of necessity depend upon the nature of the components of the binary azeotropic mixture, and include —... 

The main problem in this technique is getting the atoms into the vapour phase, bearing in mind the typically low volatility of many materials to be analysed. The method used is to spray, in a very fine mist, a liquid molecular sample containing the atom concerned into a high-temperature flame. Air mixed with coal gas, propane or acetylene, or nitrous oxide mixed with acetylene, produce flames in the temperature range 2100 K to 3200 K, the higher temperature being necessary for such refractory elements as Al, Si, V, Ti and Be. 

Diels-Alder reactions, 4, 842 flash vapour phase pyrolysis, 4, 846 reactions with 6-dimethylaminofuKenov, 4, 844 reactions with JV,n-diphenylnitrone, 4, 841 reactions with mesitonitrile oxide, 4, 841 structure, 4, 715, 725 synthesis, 4, 725, 767-769, 930 theoretical methods, 4, 3 tricarbonyl iron complexes, 4, 847 dipole moments, 4, 716 n-directing effect, 4, 44 2,5-disubstituted synthesis, 4, 116-117 from l,3-dithiolylium-4-olates, 6, 826 electrocyclization, 4, 748-750 electron bombardment, 4, 739 electronic deformation, 4, 722-723 electronic structure, 4, 715 electrophilic substitution, 4, 43, 44, 717-719, 751 directing effects, 4, 752-753 fluorescence spectra, 4, 735-736 fluorinated derivatives, 4, 679 H NMR, 4, 731 Friedel-Crafts acylation, 4, 777 with fused six-membered heterocyclic rings, 4, 973-1036 fused small rings structure, 4, 720-721 gas phase UV spectrum, 4, 734 H NMR, 4, 7, 728-731, 939 solvent effects, 4, 730 substituent constants, 4, 731 halo... 

The ethylene oxidation process can be carried out in either a liquid or a vapour phase but the latter method is often preferred because it avoids corrosion problems and the use of solvents. 

Electron ionization An ionization method employed in mass spectrometry in which analytes, in the vapour phase, are bombarded with high-energy electrons. 

In cases of quite volatile compounds, vapour-phase chromatography gives excellent specificity, although the usefulness of the method is limited because of the low vapour pressures and poor heat resistance of many organometallic compounds. 

It should be noted that in a vapour phase the liquid layer on the surface of a sensitive element of the sensor (zinc oxide) must be sufficiently thin, so that it would not produce any influence on the diffusion flux of oxygen through this layer. Possible lack of the film continuity (the presence of voids) does not prevent determination of concentration of oxygen in the bulk of the cell by the vapour - gas method. In this case, one deals with a semi-dry method. On the contrary, the presence of a thick liquid layer causes considerable errors in measuring t, because of different distribution of oxygen in a system gas - liquid layer -semiconductor film (this distribution is close to that in the system semiconductor film - liquid), in addition to substantial slowing down of oxygen diffusion in such systems. 

In static headspace sampling [301,302] the polymer is heated in a septum-capped vial for a time sufficient for the solid and vapour phases to reach equilibrium (typically 2 hours). The headspace is then sampled (either manually or automatically) for GC analysis, often followed by FID or NPD detection. Headspace sampling is a very effective method for maintaining a clean chromatographic system. Changing equilibrium temperature and time, and the volumes present in the headspace vial can influence the sensitivity of the static headspace system. SHS-GC-MS is capable of analysing volatile compounds in full scan with ppb level... 

---