Method, valence bond

There is an equivalent way of generating solutions to the electronic Schrodinger equation that conceptually is much closer to the experimentalist s language, known as Valence Bond (VB) theory. We will start by illustrating the concepts for the H2 molecule, and note how it differs from MO methods. 

Introduction to Computational Chemistry, Second Edition. Frank Jensen. 2007 John Wiley Sons, Ltd 

---

Ionova I V and Carter E A 1995 Crbital-based direct inversion in the iterative subspace for the generalized valence bond method J. Chem. Phys. 102 1251... 

The first point to remark is that methods that are to be incorporated in MD, and thus require frequent updates, must be both accurate and efficient. It is likely that only semi-empirical and density functional (DFT) methods are suitable for embedding. Semi-empirical methods include MO (molecular orbital) [90] and valence-bond methods [89], both being dependent on suitable parametrizations that can be validated by high-level ab initio QM. The quality of DFT has improved recently by refinements of the exchange density functional to such an extent that its accuracy rivals that of the best ab initio calculations [91]. DFT is quite suitable for embedding into a classical environment [92]. Therefore DFT is expected to have the best potential for future incorporation in embedded QM/MD. 

This chapter presents the implementaiton and applicable of a QM-MM method for studying enzyme-catalyzed reactions. The application of QM-MM methods to study solution-phase reactions has been reviewed elsewhere [44]. Similiarly, empirical valence bond methods, which have been successfully applied to studying enzymatic reactions by Warshel and coworkers [19,45], are not covered in this chapter. 

For a molecule as simple as Fl2, it is hard to see much difference between the valence bond and molecular orbital methods. The most important differences appear- in molecules with more than two atoms. In those cases, the valence bond method continues to view a molecule as a collection of bonds between connected atoms. The molecular- orbital method, however, leads to a picture in which the sane electron can be associated with many, or even all, of the atoms in a molecule. We ll have more to say about the similarities and differences in valence bond and molecular- orbital theory as we continue to develop their principles, beginning with the simplest alkanes methane, ethane, and propane. 

Since the time of the quantum-mechanical calculations by Longuet-Higgins, many attempts have been made to calculate tt-electron densities, resonance energies, dipole moments, and optical transitions both by the LCAO-MO and the valence bond method.However, no agreement has been reached on the importance of pd-hybridization of the sulfur atom. This is considered by some workers an essential... 

There are two principal methods available for the quantum mechanical treatment of molecular structure, the valence bond method and the molecular orbital method. In this paper we shall make use of the latter, since it is simpler in form and is more easily adapted to quantitative calculations.3 We accordingly consider each electron... 

As far as the molecular calculation is concerned, the use of an ab initio method is necessary for an adequate representation of the open-shell metastable N (ls2s) + He system with four outer electrons. The CIPSI configuration interaction method used in this calculations leads to the same rate of accuracy as the spin-coupled valence bond method (cf. the work on by Cooper et al. [19] or on NH" + by Zygelman et al. [37]). 

Resonance theory [15] contains essentially three assumptions beyond those of the valence bond method. Perhaps the most serious assumption is the contention that only unexcited canonical forms, non-polar valence bond structures or classical structures need be considered. Less serious, but no more than intuitive, is the proposition that the molecular geometry will take on that expected for the average of the classical structures. This is extended to the measurement of stability being greater the greater the number of classical structures. These concepts are still widely used in chemistry in very qualitative ways. 

Table 2.4 shows a comparison of the experimental and PPP-MO calculated electronic spectral data for azobenzene and the three isomeric monoamino derivatives. It is noteworthy that the ortho isomer is observed to be most bathochromic, while the para isomer is least bathoch-romic. From a consideration of the principles of the application of the valence-bond approach to colour described in the previous section, it might have been expected that the ortho and para isomers would be most bathochromic with the meta isomer least bathochromic. In contrast, the data contained in Table 2.4 demonstrate that the PPP-MO method is capable of correctly accounting for the relative bathochromicities of the amino isomers. It is clear, at least in this case, that the valence-bond method is inferior to the molecular orbital approach. An explanation for the failure of the valence-bond method to predict the order of bathochromicities of the o-, m- and p-aminoazobenzenes emerges from a consideration of the changes in 7r-electron charge densities on excitation calculated by the PPP-MO method, as illustrated in Figure 2.14. 

Although the complexity increases rapidly there is no reason that Walsh diagrams cannot be constructed for XY3 pyramidal, XY4 tetrahedral, XYS octahedral, and other molecules. In fact, they have been prepared, but their applications will not be described here. Insofar as these diagrams are amenable to quantitative interpretation, the predictions are in accord with what we know from experimental evidence and valence bond methods. 

Most of the commonly used electronic-structure methods are based upon Hartree-Fock theory, with electron correlation sometimes included in various ways (Slater, 1974). Typically one begins with a many-electron wave function comprised of one or several Slater determinants and takes the one-electron wave functions to be molecular orbitals (MO s) in the form of linear combinations of atomic orbitals (LCAO s) (An alternative approach, the generalized valence-bond method (see, for example, Schultz and Messmer, 1986), has been used in a few cases but has not been widely applied to defect problems.)... 

With either Lewis structures or the valence bond method, two structures must be drawn (and averaged ) to explain the n bonding in C6H6. The cr bonding is well explained by... 

Hiickel s application of this approach to the aromatic compounds gave new confidence to those physicists and chemists following up on the Hund-Mulliken analysis. It was regarded by many people as the simplest of the quantum mechanical valence-bond methods based on the Schrodinger equation. 66 Hiickel s was part of a series of applications of the method of linear combination of atom wave functions (atomic orbitals), a method that Felix Bloch had extended from H2+ to metals in 1928 and that Fowler s student, Lennard-Jones, had further developed for diatomic molecules in 1929. Now Hiickel extended the method to polyatomic molecules.67... 

Quantum-chemical cluster models, 34 131-202 computer programs, 34 134 methods, 34 135-138 for chemisorption, 34 135 the local approach, 34 132 molecular orbital methods, 34 135 for surface structures, 34 135 valence bond method, 34 135 Quantum chemistry, heat of chemisorption determination, 37 151-154 Quantum conversion, in chloroplasts, 14 1 Quantum mechanical simulations bond activation, 42 2, 84—107 Quasi-elastic neutron scattering benzene... 

---