Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Twins crossing

Error variance from a twin cross-over test... [Pg.838]

A twin cross-over test may also be interpreted by suitable entry into the treatments described. It may also be interpreted by considering the difference obtained by subtracting the response to test preparation from that obtained using the standard preparation for each animal = y and calculating for each cell the value, jg, y. ... [Pg.846]

Signal processing in mechanical impedance analysis (MIA) pulse flaw detectors by means of cross correlation function (CCF) is described. Calculations are carried out for two types of signals, used in operation with single contact and twin contact probes. It is shown that thi.s processing can increase the sensitivity and signal to noise ratio. [Pg.827]

Eig. 3. Cross sections of electronics devices used in ICs. (a) NMOS transistor (b) a twin-tub CMOS device on an n-ty e substrate. [Pg.345]

Fig. 5. Silver haUde grain morphologies for (a) cubic, precipitated in an environment having a silver ion concentration, [Ag" ], of ca 2.5 x 10 mol/L (b) octahedral, ca 6.0 x 10 mol/L and (c) tabular microcrystals, ca 1.0 x 10 ° mol/L. A cross section of a tabular grain revealing double parallel twin planes... Fig. 5. Silver haUde grain morphologies for (a) cubic, precipitated in an environment having a silver ion concentration, [Ag" ], of ca 2.5 x 10 mol/L (b) octahedral, ca 6.0 x 10 mol/L and (c) tabular microcrystals, ca 1.0 x 10 ° mol/L. A cross section of a tabular grain revealing double parallel twin planes...
In ordinary diamond (2inc-blende stmcture) the wrinkled sheets He in the (111) or octahedral face planes of the crystal and are stacked in an ABCABC sequence. In real crystals, this ABCABC sequence continues indefinitely, but deviations do occur. For example, two crystals may grow face-to-face as mirror images the mirror is called a twinning plane and the sequence of sheets crossing the mirror mns ABCABCCBACBA. Many unusual sequences may exist in real crystals, but they are not easy to study. [Pg.565]

Density. The difference in density between the two hquid phases in eqiiilibrium affects the countercurrent flow rates that can be achieved in extrac tion equipment as well as the coalescence rates. The density difference decreases to zero at a plait point, but in some systems it can become zero at an intermediate solute concentration (isopycnic, or twin-density tie line) and can invert the phases at higher concentrations. Differential types of extractors cannot cross such a solute concentration, but mixer-settlers can. [Pg.1460]

The functional requirement specification (FRS) and its nearly identical twin, the user requirement specification (URS), is a list of functions and features the device should process. If there are specific needs the customer (user) has then this is the place to include it. The level of specificity may be dependent on the experience the end-user has with dissolution. An experienced dissolution scientist will be sensitive to issues such as cross-contamination or the importance of timing etc. Critical specifications need to be clearly stated since the FRS serves as the starting point of the test plan (discussed in the next section). [Pg.387]

The constraint that the tip of one screw element wipe the flank of its mate in self-wiping, corotating twin-screw extruders leads to a unique relationship for the shape of the screw channel (Booy, 1978,1980). Figure 13 is an isometric view of this channel and Fig. 14 is a cross section of the channel in a plane that is perpendicular to the plane which defines the helix angle. Figure 14 shows the actual shape of the channel, which is described by the following expressions ... [Pg.81]

Schematic cross section of a burner, to be introduced into the reaction cell. A Threaded screw. B Cone to fit into the reaction cell opening. C Injector nozzle with two concentric tubes. D Twin valve for the inlet of two gases... Schematic cross section of a burner, to be introduced into the reaction cell. A Threaded screw. B Cone to fit into the reaction cell opening. C Injector nozzle with two concentric tubes. D Twin valve for the inlet of two gases...
Figure 1. Cross section of single and twin crystal of sucrose a) single crystal view along 001 direction b) single crystal view along 010 direction c) twin crystal view along I 001 I direction. Figure 1. Cross section of single and twin crystal of sucrose a) single crystal view along 001 direction b) single crystal view along 010 direction c) twin crystal view along I 001 I direction.
Akaganeite Somatoids, Rods Stars, crosses (twins), hexagons, prisms ... [Pg.64]

The twin goals of 58.47 are to prevent cross-contamination and mix-ups. Facility management must provide the necessary degree of separation to meet these goals. Separate rooms are not required for each of the described functions if adequate separation can be provided by spatial arrangements within a room, by special air-handhng techniques, and/or by strictly enforced procedural requirements. [Pg.71]

Operations with high cross-contamination potential (e.g., mixtures of test or control articles with animal diets) are often conducted in small, dedicated, individual cubicles equipped with special and separate air-handling systems or are conducted under a fume hood. Special mixing equipment (e.g., enclosed twin-shell blenders) can be used to reduce the chance of cross-contamination. [Pg.71]

Figure 18 Possible mechanism for arranging octahedral coordination around an impurity atom located on the interior of a grain, (a) Shifts of the atoms are indicated by the arrows, (b) Resulting structure. With this mechanism the oxygen stoichiometry becomes larger than 7. The twin walls move as a consequence of the rearrangement of the oxygen atoms and cross-twinning becomes possible. Figure 18 Possible mechanism for arranging octahedral coordination around an impurity atom located on the interior of a grain, (a) Shifts of the atoms are indicated by the arrows, (b) Resulting structure. With this mechanism the oxygen stoichiometry becomes larger than 7. The twin walls move as a consequence of the rearrangement of the oxygen atoms and cross-twinning becomes possible.
There are also cross-fostering studies of children of schizophrenic parents, adopted away by nonschizophrenic foster parents, who were compared with adopted children of normal parents raised by schizophrenic foster parents ( 53, 54). Invariably, those children whose biological parents had schizophrenia developed this disorder more frequently than the offspring of nonschizophrenic parents, even when the latter were reared by schizophrenic foster families. In addition, the concordance rate for the illness in schizophrenic monozygotic twins reared apart was comparable with monozygotic twins reared together. These findings leave little doubt of a hereditary factor in schizophrenia. [Pg.47]


See other pages where Twins crossing is mentioned: [Pg.671]    [Pg.95]    [Pg.671]    [Pg.95]    [Pg.393]    [Pg.146]    [Pg.160]    [Pg.1156]    [Pg.114]    [Pg.176]    [Pg.182]    [Pg.338]    [Pg.569]    [Pg.9]    [Pg.595]    [Pg.1255]    [Pg.136]    [Pg.355]    [Pg.499]    [Pg.324]    [Pg.421]    [Pg.131]    [Pg.204]    [Pg.183]    [Pg.79]    [Pg.82]    [Pg.528]    [Pg.66]    [Pg.117]    [Pg.178]    [Pg.182]    [Pg.187]    [Pg.137]    [Pg.195]   


SEARCH



© 2024 chempedia.info