Turbo test

Figure 33.5. Turbo test setup. Copyright by Holland Enviroment. AU rights reserved.

A turbo test lasts 2-A weeks. The time can be shortened to 1 week if high current densities are used. Each container is sampled once at the end of the test. Rve samples for analysis are taken from each soil compartment anode side, anode middle, middle, cathode middle, and cathode side. Precipitates are prepared from both the cathode and anode compartments and are analyzed. 

Standard Test In the standard test, all soil material is treated in one laboratory setup. This setup is used when the client has supplied ample data on the origin of the sample and its contaminants. This kind of test gives accurate data on energy requirements and remediation time. The most reliable results are obtained when the two tests are combined a turbo test followed by a standard test run using the electrolyte solutions that came out best during the turbo test. 

The laboratory experiments generally consist of one standard test or turbo test. Again, the amount of soil subjected to the laboratory tests is but a tiny fraction of the total volume of soil that has to be remediated. When taking one or more... 

Eddy Current Testing of Turbo Generators Rotors. 

Design Methods for Turbo-Tray Dryers The heat- and mass-transfer mechanisms are similar to those in batch tray diyers, except that constant turning over and mixing of the solids significantly improves diying rates. Design must usually be based on previous installations or pilot tests by the manufacturer apparent heat-transfer... 

XIC of +MRM (4 pairs) 327.2/275.1 amu from Sample 11 (MCX Blank) of05 04 04Ion Suppression Tests.wiff (Turbo Spray) Max. 1.0e5 cps... 

TFC was used to measure 11 pesticides in water (Asperger et al. 2002). Five TFC columns (50 x 1 mm inner diameter) were tested. The columns were the silica-based Turbo C18 and Turbo... 

Shelton M., Celik I., Liese E., Tucker D., Lawson L. (2005) A transient model of a hybrid fuel cell, gas turbine test facility using simulink. In Proceedings of the ASME Turbo Expo, Reno-Tahoe, NV, 2005-GT-68467. 

Liese E.A., Smith T.P., Haynes C., Gemmen R.S. (2006) A dynamic bulk SOFC model used in a hybrid turbine controls test facility. In Proceedings of the ASME Turbo Expo, Barcelona, Spain, GT2006-90383. 

Design, plant testing and industrial trials of the ACEC turbo expander... 

The Turbo Stove has been satisfactorily operated on dozens of fuels. The behavior of six hiels tested more extensively is shown in Table 3. In addition to many biomass forms, coal was also found to be very a satisfactory fuel for the Turbo Stove. 

National Swedish Testing Institute (Sweden) Tests on downdraft gasifier. Test with turbo charged diesel engine. 

Test data for a 72,000-lb (gross combination weight) tractor-trailer illustrate this point. The tractor is powered by a 676 in. turbo-charged and intercooled Mack diesel. When driven over a standard test route (NAPCA Control Route), the engine output as a percentage of time is that given in Table II. 

Inhalation exposure of jet fuel A induced chromosomal aberrations in bone marrow of rats exposure to turbo fuel A and C10-C14 normal paraffins by gavage did not induce MNs in CD-I mouse bone marrow test exposure of hydrodesulfurized kerosene by gavage induced chromosomal aberrations in bone marrow of mice MD API 81-07 did not induce chromosomal aberrations in rat bone marrow but induced SCEs in B6C3Fj mice... 

---