Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Tris- salts

TO Technical Order (US Air Forces) Tri-Salt tri methyl am mo ni urn nitrate... [Pg.776]

The following procedure is based on the reaction of an aqueous solution of cobalt(II) chloride with the equivalent amount of (2-aminoethyl)carbamic acid, followed by oxidation with hydrogen peroxide and the subsequent formation of bis(ethylene-diamine)cobalt(III) ions. The bis(ethylenediamine)cobalt(lII) species are converted to the carbonato complex by reaction with lithium hydroxide and carbon dioxide. During the entire preparation a vigorous stream of carbon dioxide is bubbled through the reaction mixture. This procedure appears to be essential in order to minimize the formation of tris(ethylenediamine)cobalt(III) chloride as a by-product. However, the formation of a negligible amount of the tris salt cannot be avoided. The crude salts have a purity suitable for preparative purposes. The pure salts are obtained by recrystallization from aqueous solution. [Pg.65]

First of all, the substance to which I m reacting is removed or I remove myself from the source. In cases of acute reactions, tri-salts (see entry 302) or oxygen (see entry 252) — if I m very short of breath — have proven helpful. Reiki treatments, deep and long meditations... [Pg.54]

Be aware that every treatment from a dentist will involve chemical substances. If you have negative side effects from the treatment, take tri-salts to neutralize the reaction (see entry 302). Consider seeing a holistic dentist, as this may increase your chances of finding a practice without perfume and the like. See the dentist referral list of MCS America http //mcs-america.org/dentistlist.pdf. Be aware that not all the dentists on this list are familiar with MCS. Make sure you first talk with your potential new dentist about MCS and to see if he or she understands and respects your situation and can further help you. [Pg.134]

Bring tri-salts (see entry 302) in order to quickly neutralize any possible negative reactions. [Pg.173]

In order to neutralize a negative physical reaction, you can use tri-salts. This is a combination of calcium (carbonate), magnesium (carbonate) and potassium (bicarbonate). Tri-salts lower the acid content in the body so that chemical substances can be removed more effectively and the physical reaction to chemical substances will thus not last as long. [Pg.173]

Tri-salts for daily use half a teaspoon dissolved into a glass of water. Start with one-third or one-quarter teaspoon and gradually build up the dose. [Pg.174]

Tri-salts for acute reactions take the highest dose that you can tolerate in one go. Too high a dose leads to diarrhea If the reaction does not recede, repeat this process after two hours, up to five times in ten hours. [Pg.174]

Tri-salts for use with sauna therapy in all cases take tri-salts beforehand and, in case of a reaction, also after being in the sauna. [Pg.174]

The brand Ecological Formulas (trisalts 200 grams) does not contain the composite sodium bicarbonate (baking soda). If you use tri-salts products or recipes that include baking soda, discuss them with a doctor in case of kidney problems and heart diseases or high blood pressure. [Pg.174]

The frequent use of tri-salts as well as the process of detoxification depletes more vitamins than usual, thus it s advisable to take extra vitamins. Ask your therapist or doctor for advice. [Pg.174]

Using LTC4 as substrate, nitrocellulose filters (0.2 pm pore size, 25-mm diameter) are soaked in incubation buffer (0.25 mM sucrose, 10 mM Tris-HCl, pH 7.4). A rapid filtration apparatus from Millipore (Bedford, MA) is prepared. A final volume of 110 pi of transport assay mixture (4 mM ATP (potassium salt), 10 mM creatine phosphate (Tris salt), 10 mM MgCl2, 10 mM Tris/HCl (pH 7.4), 5 mM glutathione (reduced), 0.25 mM sucrose, 100 pg/ml creatine phosphokinase (2 units/110 pi), 50 nM 3H-LTC4 (50 nCi/110 pi) pH 7.4) is preincubated at 37 °C for 1 min. Blanks are prepared by replacing ATP by 5 -AMP. [Pg.536]

DINOPROST TROMETHAMINE (USDA) 583E LUTALYSE PGF2-a THAM PGF2-a TRIS SALT PGF2-a TROMETHAMINE PROSTAGLANDIN F2-a THAM SALT PROSTAGLANDIN F2a TROMETHAMINE... [Pg.1192]

Figure 1 Gel Filtration Prc e ( MHC Assonbly at 0 Hr (solid line) and 18 Hr (dashed line).Equal aliquots (50 pg) of incubation mixtures were separated on a Superdex-73. The elutkm times of individual components are identified MHC complex P,m GSSG, oxidized glutathione OSH, reduced glutathione VSV-8mer, RGYVYQGL Tris salt... Figure 1 Gel Filtration Prc e ( MHC Assonbly at 0 Hr (solid line) and 18 Hr (dashed line).Equal aliquots (50 pg) of incubation mixtures were separated on a Superdex-73. The elutkm times of individual components are identified MHC complex P,m GSSG, oxidized glutathione OSH, reduced glutathione VSV-8mer, RGYVYQGL Tris salt...
Try salting out for reversed phase. Add 5 to 10% sodium chloride to the matrix, if aqueous. Hydration of the salt increases the polarity of the solvent and drives the analyte onto the reversed-phase sorbent. Change the mechanism of sorption. For example, if reversed phase is being used, and the molecule can be made ionic, change the mechanism of isolation to ion exchange. [Pg.66]

In order to maximize the exposure and thus the viral spectrum of 12 in the clinic, the highly water soluble Tris salt (aqueous solubility >10 mg/mL) of prodrug 13 was selected for advancement. To reduce the relatively high peak to trough ratio observed after oral dosing with this class of molecules, a slow release formulation was developed and was shown to facilitate absorption from the entire GI tract [69],... [Pg.120]

Salt deposition occurred at the constricted area of the torch injector when the SDS solution was introduced in the ICP-MS, with the regular torch positioned horizontally. This produced a significant diminution of the analytical signal with time. After approximately one hour, the injector was completely blocked. Several torch modifications were attempted, including a 2-mm-i.d. injector with a reduced taper and an injector with the taper region moved close to the injector inlet. A straight-tube injector with a 1.5-mm i.d. was also tried. Salt deposition still occurred. Finally, the deposition was eliminated by using a Leeman torch with a removable injector. [Pg.450]

Janoff, A., Popescu, M., Weiner, A., Bolcsak, L., Tremblay, P., and Swenson, C., 1993, Compositions containing tris salt of cholesterol hemisuccinate and antifungal, U.S. Patent 5,231,112, July27,1993. [Pg.87]

Some sustained release of bovine somatotropin was demonstrated fror liposome delivery systems. Egg phosphatidylcholine, ethanolamine an otocopheryl hemisuccinate, and Tris salt vesicles released bovine somato ropin, giving hypophysectomized rat growth for over a week (Janoff et al,... [Pg.301]

There are abundant examples in the literature that demonstrate the direct relationship between dissolution rate and bioavailability. One such example is that of piroxicam (Figure 7.6), a potent non-steroidal anti-inflammatory drug that was launched in 1981 by Pfizer for multiple conditions such as arthritis (osteoarthritis and rheumatoid arthritis) and spondylitis. It is a zwitterionic drug (p ai = 1S6 and p a2 = 5.46) and is classified as a low solubility and high permeability drug (i.e., class II) based on the Biopharmaceutics Classification System (BCS). In an attempt to improve its bioavailability after oral administration, the authors prepared three different ethanolamine salt forms i.e., mono-, di- and triethanolamine salts). These salt forms were selected based on prior literature precedence where they enhanced the percutaneous absorption of piroxicam.PK studies of the ethanolamine salts revealed that both the exposure (AUC) and the C ax of piroxicam in plasma followed the same trend as the dissolution profile at pH 6.8, which varied in the order mono- > di- > tri-piroxicam. The monoethanolamine salt showed the highest exposure with the relative bioavailability increasing almost 1.9-fold, while the di- and tri- salts were 1.7 times better than piroxicam. The C ax values showed 2.14-, 1.6- and... [Pg.138]


See other pages where Tris- salts is mentioned: [Pg.176]    [Pg.743]    [Pg.744]    [Pg.89]    [Pg.126]    [Pg.127]    [Pg.173]    [Pg.174]    [Pg.174]    [Pg.206]    [Pg.206]    [Pg.743]    [Pg.776]    [Pg.1832]    [Pg.743]    [Pg.431]    [Pg.744]    [Pg.213]    [Pg.151]    [Pg.278]    [Pg.139]    [Pg.344]   
See also in sourсe #XX -- [ Pg.173 , Pg.224 ]

See also in sourсe #XX -- [ Pg.92 ]




SEARCH



1.4- Dihydrotriazine tris solvate lithium salt, formation

2.4.5- Tris -imidazolium salts

A Reaction of Pyrylium Salts with Tris-hydroxymethylphosphine

Amidinium salts tris alkane synthesis

B Reaction of Pyrylium Salts with Tris-(trimethylsilyl)-phosphine

Barium, tris titanium salt

Benzeneselenol, 2,4,6-tris salt

Benzenethiol, 2,4,6-tris cadmium salt

Benzenethiol, 2,4,6-tris salt

Cobalt tetracarbonyl hydride tris salt

Copper, tris salts

Copper, tris salts structure

Copper, tris salts sulfate

Guanidinium salts tris alkane synthesis

Magnesium, tris salts

Magnesium, tris salts amines

Magnesium, tris salts complexes

Magnesium, tris salts structure

Oxalato salts, tri

Sodium, salt of tris

Tri-alkyl ammonium salts

Tri-salts

Tri-salts

Tris aminium salts

Tris aminomethane salts

Tris methylammonium salts

Tris salt vesicles

Tris salts, structural

Tris salts, structural parameters

Tris(diamine)chromium(III) Salts

Tris(ethylenediamine)chromium(III) Salts

Tris-iodonium salt

© 2024 chempedia.info