Thin film cathodes

The use of thin-film cathodes for battery application usually results in a better performance due to shorter diffusion path of intercalated cation through solid matrix. The thin film electrodes are used in manufacturing of rolled type batteries and thin film cells. [Pg.494]

Beckel D, Dubach A, Studart AR, and Gauckler LJ. Spray pyrolysis of Lao6Sr04 Co02Fe0gO3 8 thin film cathodes. J. Electroceram. 2006 16 221-228. [Pg.282]

W. Siripala, A. Ivanovskaya, T.F. Jaramillo, S.H. Baeck, E.W. McFarland, A CuzO/TiOz heterojunction thin film cathode for photoelectrocatalysis. Sol. Energy Mater. Sol. Cells 77, 229-237 (2003)... [Pg.42]

Fragnaud, R, Nagarajan, R., Schleich, D. M., and Vujic, D. [1995]. Thin-film cathodes for secondary lithium batteries, /. Power Sources, 54, pp. 362-366. [Pg.405]

M. C. Rao, O. M. Hussain, Synthesis and electrochemical properties of Tt doped liCo02 thin film cathodes, J. Alloys Compd. 2010,491, 503-506. [Pg.319]

Janssen, G. J. M. Sitters, E. F. (2006). Performance of thin-film cathodes for proton-exchange-membrane fuel cells based on high-surface-area carbon supports. J. Power Sources, , - . (in press)... [Pg.408]

Besides Debe s electrode, Tang et al. [61] produeed a carbon nanotube thin film with ultra-low Pt loading (Pt on multi-walled carbon nanotubes (MWNTs)) through a polycarbonate filtration membrane. Compared to the results presented by both Los Alamos National Lab (LANL) and 3M Corporation, as shown in Figure 19.12, this thin-film cathode catalyst layer with a loading of 6 pg Pt/cm could give a mass activity of 250 A/mg Pt, which is the highest activity reported so far. [Pg.906]

Siripala W, Ivanovskaya A, Jaramillo TF et al (2003) A Cu20/Ti02 heterojunction thin film cathode for photoelectrocatalysis. Sol Energy Mater Sol Cells 77 229-237... [Pg.303]

Dokko K, Mohamedi M, Anzue N, Itoh T, Uchida 1 (2002) In situ Raman spectroscopic studies of LtNixMn2-x04 thin film cathode materials for lithium ion secondary batteries. J Mater Chem 12 3688-3693... [Pg.501]

Thin-film V2O5 electrodes have been studied for lithium microbatteries by West et al. Thin-film cathode were prepared by three techniques RF-sputtering, physical vapor deposi-... [Pg.406]

Hoshina, K., Hoshina, K Yoshima, K Kotobuki, M., and Kanamura, K. (2013) Fabrication of LiNio.sMni 5O4 thin film cathode by PVP sol-gel process and its application in all-solid-state lithium ion batteries using Lii+ AKTij- JPOJa solid... [Pg.1115]

Ink-jet Printing Computer-controlled ink-jet printing is considered a convenient technique for low-cost fabrication of ultrathin films in various fields [94-96]. Recently, it has been used to fabricate a thin-film cathode for a Hthium-ion battery [34, 97, 98]. (A flowchart is shown in Figure 28.3 [34].) An aluminum foil substrate is initially cleaned to remove oil and other contaminants from its surface before it is attached to a piece of paper. A hot-roU press is employed to make soHd particles bind to carboxymethyl cellulose (CMC). The final press procedure increases the packing density of the electrode. [Pg.944]

Eigare 9.6 Cathode electrolyte interface structures (a) standard interface with smooth electrolyte surface and re.sirlcled numher of active reaction sites and (It) structured electrolyte surface with nanoporous MOD thin film cathode layer leading to an enhanced reaction zone with improved performance and duralhlity. [Pg.247]

Julien C, Camacho-Lopez MA, Escobar-Alarcon L, Haro-Poniatowski E (2001) Fabrication of LiCo02 thin film cathodes for rechargeable lithium microbatteries. Mater Chem Phys 68 210-216... [Pg.321]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...