Sulfate, atmospheric

Chemical composition data for CPM and FPM for a variety of locations are summarized in Table 5. These data illustrate several important points. First, the distributions of the PM q between CPM and FPM vary from about 0.4 to 0.7. Second, the ratio of PM q to TSP varies from 0.58 to 0.79. In general, both this ratio and the ratio of FPM to PM q tend to be higher at mral sites, but Bermuda, because of the large influence of sea salt in the CPM, is an exception. Sulfate (SO ), carbon (as organic carbon, OC, and elemental carbon, EC), and nitrate (NO3 ) compounds generally account for 70—80% of the FPM. In the eastern United States, compounds are the dominant species, although very Httie is emitted directiy into the atmosphere. Thus... 

Acid Deposition. Acid deposition, the deposition of acids from the atmosphere to the surface of the earth, can be dry or wet. Dry deposition involves acid gases or their precursors or acid particles coming in contact with the earth s surface and thence being retained. The principal species associated with dry acid deposition are S02(g), acid sulfate particles, ie, H2SO4 and NH HSO, and HN02(g). Measurements of dry deposition are quite sparse, however, and usually only speciated as total and total NO3. In general, dry acid deposition is estimated to be a small fraction of the total... 

Formates. lron(Il) formate dihydrate [13266-734], Fe(HC02)2 2H20, is a green salt which can be prepared from iron(Il) sulfate and sodium formate in an inert atmosphere. The compound is slightly soluble in water and fairly resistant to air oxidation. The anhydrous salt [3047-594] is known. 

The oxidant preheater, positioned in the convective section and designed to preheat the oxygen-enriched air for the MHD combustor to 922 K, is located after the finishing superheat and reheat sections. Seed is removed from the stack gas by electrostatic precipitation before the gas is emitted to the atmosphere. The recovered seed is recycled by use of the formate process. Alkali carbonates ate separated from potassium sulfate before conversion of potassium sulfate to potassium formate. Sodium carbonate and potassium carbonate are further separated to avoid buildup of sodium in the system by recycling of seed. The slag and fly-ash removed from the HRSR system is assumed to contain 15—17% of potassium as K2O, dissolved in ash and not recoverable. 

Ma.nufa.cture. Nickel carbonyl can be prepared by the direct combination of carbon monoxide and metallic nickel (77). The presence of sulfur, the surface area, and the surface activity of the nickel affect the formation of nickel carbonyl (78). The thermodynamics of formation and reaction are documented (79). Two commercial processes are used for large-scale production (80). An atmospheric method, whereby carbon monoxide is passed over nickel sulfide and freshly reduced nickel metal, is used in the United Kingdom to produce pure nickel carbonyl (81). The second method, used in Canada, involves high pressure CO in the formation of iron and nickel carbonyls the two are separated by distillation (81). Very high pressure CO is required for the formation of cobalt carbonyl and a method has been described where the mixed carbonyls are scmbbed with ammonia or an amine and the cobalt is extracted as the ammine carbonyl (82). A discontinued commercial process in the United States involved the reaction of carbon monoxide with nickel sulfate solution. 

A smaller factor in ozone depletion is the rising levels of N2O in the atmosphere from combustion and the use of nitrogen-rich fertilizers, since they ate the sources of NO in the stratosphere that can destroy ozone catalyticaHy. Another concern in the depletion of ozone layer, under study by the National Aeronautics and Space Administration (NASA), is a proposed fleet of supersonic aircraft that can inject additional nitrogen oxides, as weU as sulfur dioxide and moisture, into the stratosphere via their exhaust gases (155). Although sulfate aerosols can suppress the amount of nitrogen oxides in the stratosphere... 

The cmde phthaUc anhydride is subjected to a thermal pretreatment or heat soak at atmospheric pressure to complete dehydration of traces of phthahc acid and to convert color bodies to higher boiling compounds that can be removed by distillation. The addition of chemicals during the heat soak promotes condensation reactions and shortens the time required for them. Use of potassium hydroxide and sodium nitrate, carbonate, bicarbonate, sulfate, or borate has been patented (30). Purification is by continuous vacuum distillation, as shown by two columns in Figure 1. The most troublesome impurity is phthahde (l(3)-isobenzofuranone), which is stmcturaHy similar to phthahc anhydride. Reactor and recovery conditions must be carefully chosen to minimize phthahde contamination (31). Phthahde [87-41-2] is also reduced by adding potassium hydroxide during the heat soak (30). 

The chemical properties of phthalocyanines depend mosdy on the nature of the central atom. Phthalocyanines are stable to atmospheric oxygen up to approximately 100°C. Mild oxidation may lead to the formation of oxidation iatermediates that can be reduced to the original products (29). In aqueous solutions of strong oxidants, the phthalocyanine ring is completely destroyed and oxidized to phthalimide. Oxidation ia the presence of ceric sulfate can be used to determine the amount of copper phthalocyanine quantitatively (30). 

Transparent yeUow pigment is composed of needle particles of EeO(OH) having a thickness of 2—5 nm, a width of 10—20 nm, and a length of 50—100 nm. They are prepared by the precipitation process from a very diluted solution of ferrous salt, eg, 6 wt % ferrous sulfate, foUowed by the oxidation of the precipitate with atmospheric oxygen at a temperature of less than 25°C. The precipitate is left to mature for about one day, then filtered, dried, and milled. 

Titanium Sulfates. Solutions of titanous sulfate [10343-61-0] ate readily made by reduction of titanium(IV) sulfate ia sulfuric acid solutioa by electrolytic or chemical means, eg, by reduction with ziac, ziac amalgam, or chromium (IT) chloride. The reaction is the basis of the most used titrimetric procedure for the determination of titanium. Titanous sulfate solutions are violet and, unless protected, can slowly oxidize ia coatact with the atmosphere. If all the titanium has been reduced to the trivalent form and the solution is then evaporated, crystals of an acid sulfate 3 Ti2(S0 2 [10343-61-0] ate produced. This purple salt, stable ia air at aormal temperatures, dissolves ia water to give a stable violet solutioa. Whea heated ia air, it decomposes to Ti02, water, sulfuric acid, and sulfur dioxide. 

Lateritic Ores. The process used at the Nicaro plant in Cuba requires that the dried ore be roasted in a reducing atmosphere of carbon monoxide at 760°C for 90 minutes. The reduced ore is cooled and discharged into an ammoniacal leaching solution. Nickel and cobalt are held in solution until the soflds are precipitated. The solution is then thickened, filtered, and steam heated to eliminate the ammonia. Nickel and cobalt are precipitated from solution as carbonates and sulfates. This method (8) has several disadvantages (/) a relatively high reduction temperature and a long reaction time (2) formation of nickel oxides (J) a low recovery of nickel and the contamination of nickel with cobalt and (4) low cobalt recovery. Modifications to this process have been proposed but all include the undesirable high 760°C reduction temperature (9). 

---