Solutions metal complexes

Nancollas, G. H. "Interactions in Electrolyte Solutions (Metal Complex and Ion Pair Formation in Solution)" Elsevier Publishing Co., Amsterdam, 1966. 

Since Y is the total ionization yield (in no. of charges/photon), it takes into account yields resulting from all the components, (Y for the solute metal complex and Yj for the solvent) in solution, and... 

Virtually no metal extraction system involves only one reaction. In aqueous metal salt solutions there occur homogeneous association and complexation reactions that make true species concentrations differ Aom the analytical concentrations that are measured and that enter into material balances. In sulfate solutions bisuifate formation occurs at low pH, and metai-sulfate ion pairing may take place. In chloride and amnaonia solutions metal complexation is common. Dimerization and other association reactions often occur in the organic phases. And two-phase extraction reactions of acids or other species may take place simultaneously with metal extraction or stripping. The equilibria of these reactions must be modeled concurrently with the... 

NMMO N-methylmorpholine-N-oxide monohydrate Aqueous solutions metal complexes... 

Ultrasonic absorption is used in the investigation of fast reactions in solution. If a system is at equilibrium and the equilibrium is disturbed in a very short time (of the order of 10"seconds) then it takes a finite time for the system to recover its equilibrium condition. This is called a relaxation process. When a system in solution is caused to relax using ultrasonics, the relaxation lime of the equilibrium can be related to the attenuation of the sound wave. Relaxation times of 10" to 10 seconds have been measured using this method and the rates of formation of many mono-, di-and tripositive metal complexes with a range of anions have been determined. 

Martell, A. E. Hancock, R. D. Metal Complexes in Aqueous Solution, Plenum Press New York, 1996... 

All the early literature concerning thiazoles mentions numerous metallic complex-salts formed by addition to the thiazole of the aqueous solution of the metal salt and that could be used for identification purposes. The most usual complexes so obtained are platinum double salts, for example, (4-methylthiazole HC1)2 PtCU (m.p. deep 204°C) (25), or mercuric chloride derivatives, for example, 2,4-dimethyl-thiazole 2 HgCl (m.p. deep 176-177°C) (458). 

In Section 8, the material on solubility constants has been doubled to 550 entries. Sections on proton transfer reactions, including some at various temperatures, formation constants of metal complexes with organic and inorganic ligands, buffer solutions of all types, reference electrodes, indicators, and electrode potentials are retained with some revisions. The material on conductances has been revised and expanded, particularly in the table on limiting equivalent ionic conductances. 

The most common oxidation state of niobium is +5, although many anhydrous compounds have been made with lower oxidation states, notably +4 and +3, and Nb can be reduced in aqueous solution to Nb by zinc. The aqueous chemistry primarily involves halo- and organic acid anionic complexes. Virtually no cationic chemistry exists because of the irreversible hydrolysis of the cation in dilute solutions. Metal—metal bonding is common. Extensive polymeric anions form. Niobium resembles tantalum and titanium in its chemistry, and separation from these elements is difficult. In the soHd state, niobium has the same atomic radius as tantalum and essentially the same ionic radius as well, ie, Nb Ta = 68 pm. This is the same size as Ti ... 

A method suitable for analysis of sulfur dioxide in ambient air and sensitive to 0.003—5 ppm involves aspirating a measured air sample through a solution of potassium or sodium tetrachloromercurate, with the resultant formation of a dichlorosulfitomercurate. Ethylenediaminetetraacetic acid (EDTA) disodium salt is added to this solution to complex heavy metals which can interfere by oxidation of the sulfur dioxide. The sample is also treated with 0.6 wt % sulfamic acid to destroy any nitrite anions. Then the sample is treated with formaldehyde and specially purified acid-bleached rosaniline containing phosphoric acid to control pH. This reacts with the dichlorosulfitomercurate to form an intensely colored rosaniline—methanesulfonic acid. The pH of the solution is adjusted to 1.6 0.1 with phosphoric acid, and the absorbance is read spectrophotometricaHy at 548 nm (273). 

Arsonium salts have found considerable use in analytical chemistry. One such use involves the extraction of a metal complex in aqueous solution with tetraphenyiarsonium chloride in an organic solvent. Titanium(IV) thiocyanate [35787-79-2] (157) and copper(II) thiocyanate [15192-76-4] (158) in hydrochloric acid solution have been extracted using tetraphenyiarsonium chloride in chloroform solution in this manner, and the Ti(IV) and Cu(II) thiocyanates deterrnined spectrophotometricaHy. Cobalt, palladium, tungsten, niobium, and molybdenum have been deterrnined in a similar manner. In addition to their use for the deterrnination of metals, anions such as perchlorate and perrhenate have been deterrnined as arsonium salts. Tetraphenyiarsonium permanganate is the only known insoluble salt of this anion. 

There are only a few weU-documented examples of catalysis by metal clusters, and not many are to be expected as most metal clusters are fragile and fragment to give metal complexes or aggregate to give metal under reaction conditions (39). However, the metal carbonyl clusters are conceptually important because they form a bridge between catalysts commonly used in solution, ie, transition-metal complexes with single metal atoms, and catalysts commonly used on surfaces, ie, small metal particles or clusters. 

These siUca-supported catalysts demonstrate the close connections between catalysis in solutions and catalysis on surfaces, but they are not industrial catalysts. However, siUca is used as a support for chromium complexes, formed either from chromocene or chromium salts, that are industrial catalysts for polymerization of a-olefins (64,65). Supported chromium complex catalysts are used on an enormous scale in the manufacture of linear polyethylene in the Unipol and Phillips processes (see Olefin polymers). The exact stmctures of the surface species are still not known, but it is evident that there is a close analogy linking soluble and supported metal complex catalysts for olefin polymerization. 

In this case the efficiency of metal complex modifiers is controlled not only by their thermal stability, the nature of the metal and the ligand used, but depends considerably on the reactions in the solution, mainly on exchange reaction like Me,L -i- Me = MeU + Me L, which variously affect the... 

The electron transfer rates in biological systems differ from those between small transition metal complexes in solution because the electron transfer is generally long-range, often greater than 10 A [1]. For long-range transfer (the nonadiabatic limit), the rate constant is... 

Metal salts in alkaline solution Cuprammonium complex Nickel and cobalt ammonia complex Cyanides (q.v.) Copper pyrophosphates Plumbites Zincates... 

Cyanoacrylate adhesives cure by anionic polymerization. This reaction is catalyzed by weak bases (such as water), so the adhesives are generally stabilized by the inclusion of a weak acid in the formulation. While adhesion of cyanoacrylates to bare metals and many polymers is excellent, bonding to polyolefins requires a surface modifying primer. Solutions of chlorinated polyolefin oligomers, fran-sition metal complexes, and organic bases such as tertiary amines can greatly enhance cyanoacrylate adhesion to these surfaces [72]. The solvent is a critical component of these primers, as solvent swelling of the surface facilitates inter-... 

The solvated sulfenamides [Li2( BuNSC6H4Me-4)2(THF)n] (n = 2,4) have dimeric structures with a central Li2N2 ring. The coordination mode is determined by the extent of solvation of the Li" ions monosolvation allows for rj -N,S coordination whereas disolvation restricts the coordination mode to // -M Variable temperature NMR studies indicated that a dynamic exchange between these two structural types occurs in THF solution (Scheme 10.10). The dihapto coordination mode is observed exclusively in transition-metal complexes and the... 

---