Silver addition initiated

We conclude that we are observing reaction at the polymer-silver interface that results in reflectance loss. This interface reaction could result from degradation of the bulk polymer or its additives, initiation at the polymer/mirror interface, or reaction with the ambient atmosphere. 

Since MVK is completely miscible with water, an emulsion-type polymerization without additional emulsifiers is possible. For the oxodisulfate-silver nitrate initiator, the following mechanism is suggested ... 

The manufacture of silver nitrate for the preparation of photographic emulsions requires silver of very high purity. At the Eastman Kodak Company, the principal U.S. producer of silver nitrate, 99.95% pure silver bars are dissolved in 67% nitric acid in three tanks coimected in parallel. Excess nitric acid is removed from the resulting solution, which contains 60—65% silver nitrate, and the solution is filtered. This solution is evaporated until its silver nitrate concentration is 84%. It is then cooled to prepare the first crop of crystals. The mother Hquor is purified by the addition of silver oxide and returned to the initial stages of the process. The cmde silver nitrate is centrifuged and recrystallized from hot, demineralized water. Equipment used in this process is made of ANSI 310 stainless steel (16). 

During preparation of an oxidising agent on a larger scale than described [1], addition of warm sodium hydroxide solution to warm ammoniacal silver nitrate with stirring caused immediate precipitation of black silver nitride which exploded [2], Similar incidents had been reported previously [3], including one where explosion appeared to be initiated by addition of Devarda s alloy (Al—Cu—Zn) [4], The explosive species separates at pH values above 12.9, only produced when alkali is added to ammoniacal silver solutions, or when silver oxide is dissolved with ammonia [5], The Sommer Market reagent mixture used to identify cellulose derivatives led to a severe explosion [6],... 

Anderson and Kemball (35) examined the reaction between gaseous deuterium and benzene catalyzed by evaporated films of iron, nickel, palladium, silver, tungsten, and platinum. The order of reactivity (estimated from the temperature at which the addition reaction achieved an initial rate of 1% per minute for a 10 mg film at certain specified reactant... 

Bradford reagent contains the dye Coomassie blue G-250 in an acidic solution. The dye binds to protein, yielding a blue colour that absorbs maximally at 595 nm Copper-containing reagent that, when reduced by protein, reacts with bicinchonic acid yielding a complex that displays an absorbance maximum at 562 nm Essentially involves initial precipitation of protein out of solution by addition of trichloroacetic acid. The protein precipitate is redissolved in NaOH and the Lowry method of protein determination is then performed Interaction of silver with protein - very sensitive method... 

The glycals are easily converted into the 1,2-dihalo-derivatives, which in principle can act as glycosyl donors. However, these derivatives have not found wide application in glycoside synthesis, mainly because of the low facial selectivity in the initial addition of the electrophilic species [143-145]. In an example of a successful application, 2-deoxy-2-bromo-a-D-glucopyranosyl bromide [146] has been shown to give predominantly the 2-deoxy-P-D-glucopyranosides in silver-triflate-promoted reactions with alcohols. 

The concept of dynamic silver clusters capable to transfer between molecules was also pointed out recently by Ras et al. for silver clusters prepared by photoactivation using PM A A as scaffold [20], Every specific initial ratio of silver ions to methacrylate unit, Ag+ MAA, results in distinct spectral bands (Fig. 12a, b). Thus, an initial ratio 0.5 1 gives an absorption band at 503 nm, whereas a ratio 3 1 gives a band at 530 nm. The shuttle effect was proven when for a given silver cluster solution with ratio 3 1 and absorption at 530 nm, a blue shift was achieved by the addition of pure PMAA. For instance if the added amount of polymer decreases the ratio Ag+ MAA from 3 1 to 0.5 1, the new optical band will match exactly with the band corresponding to a solution with initial ratio 0.5 1, that is 503 nm (Fig. 12c). The explanation given for this blue shift was the redistribution of the existent silver clusters in PMAA chains over the newly available PMAA chains, in other words that the clusters shuttle from partly clusters-filled chains to empty ones. 

---