Ruthenium Ru3

Since this discovery, a whole range of transition metals have been exploited, with ruthenium (Ru3(CO)12), rhodium ([RhCl(CO)2]2), iridium ([Ir(COD)Cl]2), molybdenum (Mo(CO)6) and iron (Fe(CO)4(NMe3)) all having been successfully employed as catalysts for the reaction.28,29,36,63 65... 

The structure and electrochemistry of the l,l -bis(diphenylphosphino)ferrocene (dppf) derivartives of ruthenium Ru3(GO)io(dppf), Ru3(GO)8(dppf)2 and the bridged system Ru3(GO)n 2(/x-dppf) have been investigated. 

Mercaptobenzothiazole with [Ru3(CO)i2l gives the cluster 41 (76TMC186, C192, 78IC2103). Two ruthenium atoms are bonded to the exocyclic sulfur site, while the third one is coordinated via the nitrogen heteroatom. 

The ruthenium analogue of 47 Ru(ri5-C5Ph5)(CO)2Br (48) is also available, when Fe(CO)5 is replaced by Ru3(CO)12 [68]. A wide range of substitution products were obtained through replacement of both carbonyl and bromide ligand against two-electron ligands L such as phosphines, phosphites, and ethylene. Electrochemistry of these derivatives were studied in some detail. 

A good example is the excited state of the tris(bipyridine)ruthenium(2+) ion, Ru(bpy)5+. This species results from the transfer of an electron from the metal to a ligand. In the language of localized valences, it is a ruthenium(3+) ion, coordinated to two bipyridines and to one bipyridyl radical anion in other words, [Ru3+(bpy)2(bpy )]2+. This excited state is a powerful electron donor and acceptor.17 The following equations show an example of each quenching mode ... 

To select the metal to be incorporated into the substrate porphyrin unit, the following basic properties of metalloporphyrins should be considered. The stability constant of MgPor is too small to achieve the usual oligomeric reactions and purification by silica gel chromatography. The starting material (Ru3(CO)i2) for Ru (CO)Por is expensive and the yield of the corresponding metalation reaction is low. Furthermore, the removal of rutheniirm is difficult, and it is likewise difficult to remove the template from the obtained ruthenium CPOs. Therefore, ZnPor is frequently used as a substrate in this template reaction, because of the low prices of zinc sources (zinc acetate and/or zinc chloride), the high yield in the metalation reaction, the sufficient chemical stability of the ZnPor under con-... 

Since activation of the N-H bond of PhNHj by Ru3(CO)i2 has been reported to take place under similar conditions [306], it has been proposed that the reaction mechanism involves (i) generation of an anUido ruthenium hydride, (ii) coordination of the alkyne, (iii) intramolecular nucleophilic attack of the nitrogen lone pair on the coordinated triple bond, and (iv) reductive ehmination of the enamine with regeneration of the active Ru(0) center [305]. 

Physical properties of binary or ternary Ru/Ir based mixed oxides with valve metal additions is still a field which deserves further research. The complexity of this matter has been demonstrated by Triggs [49] on (Ru,Ti)Ox who has shown, using XPS and other techniques (UPS, Mossbauer, Absorption, Conductivity), that Ru in TiOz (Ti rich phase) adopts different valence states depending on the environment. Possible donors or acceptors are compensated by Ru in the respective valence state. Trivalent donors are compensated by Ru5+, pentavalent acceptors will be compensated by Ru3+ or even Ru2+. In pure TiOz ruthenium adopts the tetravalent state. The surface composition of the titanium rich phase (2% Ru) was found to be identical to the nominal composition. 

Any proposed mechanism for the unprecedented transformation described by Equation 18 must account for the promotion of this photoisomerization by CO, although CO is not required by the stoichiometry. A possible initial step would be similar to that for the Ru3(CO)i2 fragmentation (Scheme 1). In this a Ru-Ru bond is broken concomitant with the movement of a CO from a terminal to a bridging site to form an unsaturated intermediate analogous to I. A speculative proposal along these lines is presented in Figure 5. The key feature of this proposal would be the formation of III with one unsaturated ruthenium, which could be captured by CO to promote the subsequent steps leading from the /1-methylidyne to the acyl... 

The dominant role of copper catalysts has been challenged by the introduction of powerful group VIII metal catalysts. From a systematic screening, palladium(II) and rhodium(II) derivatives, especially the respective carboxylates62)63)64-, have emerged as catalysts of choice. In addition, rhodium and ruthenium carbonyl clusters, Rh COJjg 65> and Ru3(CO)12 e6), seem to work well. Tables 3 and 4 present a comparison of the efficiency of different catalysts in cyclopropanation reactions with ethyl diazoacetate under standardized conditions. 

Ruthenium cluster compounds (143) and (144) have been identified that may play a role in the catalysis when Ru3(CO)12 was used as the precursor.540-543 The use of [(dppe)Ru(CO)3] as a catalyst including the intermediates (145) and (146) in the catalytic cycles, have been studied in detail by Gladfelter and co-workers.544-550... 

It has been several decades since oxo-centered triruthenium-carboxylate complexes with triangular cluster frameworks of Ru3(p3-0)(p-00CR)6 (R = alkyl or aryl) were first isolated [1,2]. In the early 1970s, the first oxo-centered triruthenium complex was structurally characterized by Cotton through X-ray crystal structural determination [3]. Since then, oxo-centered trinuclear ruthenium-carboxylate cluster complexes with general formula [Ru30(00CR)6(L)2L ]n+ (R = aryl or alkyl, L and... 

In 1977 Ford and co-workers showed that Ru3(CO)12 in the presence of a ca. fiftyfold excess of KOH catalyzes the shift reaction at 100°C/1 bar CO (79). The effectiveness of the system increased markedly as temperature was increased (rate of hydrogen formation approximately quadrupled on raising the temperature from 100° to 110°C), and over a 30-day period catalyst turnovers of 150 and 3 were found for Ru3(CO)12 and KOH, respectively. Neither methane nor methanol was detected in the reaction products. Although the nature of the active ruthenium species could not be unambiguously established, infrared data indicated that it is not Ru3(CO)12, and the complexity of the infrared spectrum in the... 

---