Reversed phase system

As has previously been stated, the majority of HPLC analyses which are carried out employ reversed-phase systems. 

The extraction of colorless catabolites from samples is usually performed by homogenizing the ground tissue in 20 to 100 mM K3PO4 buffer (pH 7.0) and methanol (1 1, v/v) - or 0.1 M Tris-HCl, pH 8.0 and methanol (1 4 v/v) followed by centrifugation and analysis by RP-HPLC, either directly or after concentration on a C18 SepPak cartridge. A reversed phase system with a C18 Hypersil ODS... 

The correlation of Snyder s solvent strength e° with molecular dipolarity and polarizability (7t ) and the hydrogen-bond acidity (a) and the hydrogen-bond basicity ((3) solvatochromic parameters for adsorption chromatography can be achieved, although most papers on solvatochromic parameters deal with reversed-phase systems [18]. 

The choice of the chromatographic system depends on the chemical character of the extracts being separated. The mobile phase should accomplish all requirements for PLC determined by volatility and low viscosity, because nonvolatile components (e.g., ion association reagents and most buffers) should be avoided. It means that, for PLC of plant extracts, normal phase chromatography is much more preferable than reversed-phase systems. In the latter situation, mixtures such as methanol-ace-tonitrile-water are mostly used. If buffers and acids have to be added to either the... 

Eluent components should be volatile. Solvents such as ethyl acetate, isopropyl ether, diethylketone, chloroform, dichloromethane, and toluene as modifiers and n-hexane as diluent are recommended for normal phase chromatography. For reversed-phase systems, methanol or acetonitrile are used as modifiers. Such components as acetic acid or buffers, as well as ion association reagents, should be avoided. 

Snyder, L. R., Dolan, J. W., and Gant, J. R., Gradient elution in high-performance liquid chromatography. I. Theoretical basis for reversed-phase systems, /. Chromatogr., 165, 3, 1979. 

Jandera, P., Holcapek, M., Theodoridis, G. (1998). Investigation of chromatographic behavior of alcohol ethoxylate surfactants in normal-phase and reversed-phase systems using high-performance liquid chromatography-mass spectrometry. J. Chromatogr. A 813(2), 299-311. 

Reverse-phase HPLC (RP-HPLC) separates proteins on the basis of differences in their surface hydophobicity. The stationary phase in the HPLC column normally consists of silica or a polymeric support to which hydrophobic arms (usually alkyl chains, such as butyl, octyl or octadecyl groups) have been attached. Reverse-phase systems have proven themselves to be a particularly powerful analytical technique, capable of separating very similar molecules displaying only minor differences in hydrophobicity. In some instances a single amino acid substitution or the removal of a single amino acid from the end of a polypeptide chain can be detected by RP-HPLC. In most instances, modifications such as deamidation will also cause peak shifts. Such systems, therefore, may be used to detect impurities, be they related or unrelated to the protein product. RP-HPLC finds extensive application in, for example, the analysis of insulin preparations. Modified forms, or insulin polymers, are easily distinguishable from native insulin on reverse-phase columns. 

Although RP-HPLC has proven its analytical usefulness, its routine application to analysis of specific protein preparations should be undertaken only after extensive validation studies. HPLC in general can have a denaturing influence on many proteins (especially larger, complex proteins). Reverse-phase systems can be particularly harsh, as interaction with the highly hydrophobic stationary phase can induce irreversible protein denaturation. Denaturation would result in the generation of artifactual peaks on the chromatogram. 

There is a very wide choice of pairs of liquids to act as stationary and mobile phases. It is not necessary for them to be totally immiscible, but a low mutual solubility is desirable. A hydrophilic liquid may be used as the stationary phase with a hydrophobic mobile phase or vice versa. The latter situation is sometimes referred to as a reversed phase system as it was developed later. Water, aqueous buffers and alcohols are suitable mobile phases for the separation of very polar mixtures, whilst hydrocarbons in combination with ethers, esters and chlorinated solvents would be chosen for less polar materials. 

There are two commonly used ways to elute a given compound in HPLC the normal-phase mode (t)s><5m) and the reversed-phase mode (<5m><5s). Reversed-phase systems offer superior general selectivity. Solutes are eluted in ascending order of polarity in normal-phase systems and in descending order of polarity in reversed-phase systems. 

Filter and degas a part of the sample. Prepare the instrument as you have done before, choosing a particular stationary and mobile phase system (such as a reverse phase system using a methanol-water mixture for the mobile phase and a nonpolar stationary phase) and flow rate that you will use as a first trial. 

Separation of APEO has been attempted using both normal-phase and reversed-phase systems combined with absorption or fluorescence detection. 

Shang et al. [7] studied the effect of different additives (NaAc, NaOH, NaCl, NH4Ac) on analyte signal intensity and they found that the relative intensity of NPEO adduct ions may be enhanced by all additives, but NaAc produced the most abundant adduct ions for the entire ethoxylate series with good reproducibility. Additionally, the intensity of adducts, especially for mono- and diethoxylates was found to depend on reaction time prior to LC-ESI-MS analysis and concentration of NaAc. They recommended 0.5 mM NaAc for normal-phase separation with solvent system toluene-MeOH-water. In reversed-phase systems the highest abundance of sodium adducts for NPEOs ( iEO = 1-10) was observed at concentrations higher than 10 xM, while any further increase in concentration had very low influence on signal intensity [10,11],... 

The concurrent development of analytical techniques for the isolation, detection, and quantitation of indole alkaloids in small amounts of cellular material has been addressed by Hdfle and co-workers 134), who developed a reversed-phase system using either methanol-water-triethylamine or acetonitrile-triethylammonium formate buffer as the eluept. Two prepacked cartridge systems were found to be very effective, for the rapid preparation of the alkaloid mixture from the cell contents. ... 

---