Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Infusion molding

Resin transfer molding With vacuum assisted RTM, this process can be called infusion molding. RTM usually uses liquid TS plastics that is transferred or injected into an enclosed mold usually at low pressures of about 60 psi (410 kPa) in which reinforcement... [Pg.517]

RTM can also incorporate vacuum to assist plastic melt flow. With vacuum-assisted RTM the process is called infusion molding.300 This process could be identified as a take-off to the Marco process.3... [Pg.489]

SCRIMP Seemann composite resin infusion molding process... [Pg.895]

SCRIMP Seemann Composite Resin Infusion Molding Process. [Pg.1057]

Love, C. K., Investigation of RE cnring parameters in resin infusion molding . Master s Thesis, Brigham Young University, 2010. [Pg.480]

Fig. 1. Very large parts can be produced by the patented Seaman Composites Resin Infusion Molding Process (SCRIMP), in which dry reinforcements are vacuum bagged before thermoset resin is introduced into the lay-up. Courtesy Hardcore Composites, New Castle, Del. Fig. 1. Very large parts can be produced by the patented Seaman Composites Resin Infusion Molding Process (SCRIMP), in which dry reinforcements are vacuum bagged before thermoset resin is introduced into the lay-up. Courtesy Hardcore Composites, New Castle, Del.
The vacuum-assisted resin infusion molding (VARIM) process was used for fabricating E- glass/epoxy composites. The VARIM process uses vacuum pressure to remove air from the fabric lay-up before and while the matrix resin is introduced to the fabric reinforcement. The pressure difference between the atmosphere and the vacuum is the driving force for infusion of the resin into the lay-up. Once the setup was laid up and completely vacuumed as... [Pg.784]


See other pages where Infusion molding is mentioned: [Pg.119]    [Pg.73]    [Pg.427]    [Pg.134]    [Pg.489]    [Pg.529]    [Pg.265]    [Pg.308]    [Pg.598]    [Pg.99]    [Pg.285]    [Pg.303]    [Pg.305]    [Pg.320]    [Pg.320]    [Pg.321]    [Pg.323]    [Pg.528]    [Pg.1098]    [Pg.1]    [Pg.246]    [Pg.99]    [Pg.285]    [Pg.303]    [Pg.305]    [Pg.320]    [Pg.320]    [Pg.323]    [Pg.528]    [Pg.1112]    [Pg.378]    [Pg.462]   
See also in sourсe #XX -- [ Pg.489 ]

See also in sourсe #XX -- [ Pg.598 ]




SEARCH



Infusible

Infusion

SCRIMP infusion molding process

Seemann Composite Resin Infusion Molding Process (SCRIMP)

Seemann composite resin infusion molding, SCRIMP

Seemann composites resin infusion molding

Seemann composites resin infusion molding process

© 2024 chempedia.info