Reduction cyanoborohydride

A variation of the classical reductive amination procedure uses sodium cyanoboro hydride (NaBH3CN) instead of hydrogen as the reducing agent and is better suited to amine syntheses m which only a few grams of material are needed All that is required IS to add sodium cyanoborohydride to an alcohol solution of the carbonyl compound and an amine... 

Sodium cyanoborohydride is remarkably chemoselective. Reduction of aldehydes and ketones are, unlike those with NaBH pH-dependent, and practical reduction rates are achieved at pH 3 to 4. At pH 5—7, imines (>C=N—) are reduced more rapidly than carbonyls. This reactivity permits reductive amination of aldehydes and ketones under very mild conditions (42). 

Sodium cyanoborohydride has become important in biochemical appHcations that require hydrolytic stabiHty of the reducing agent and chemoselectivity, in sensitive molecules. It is also a preferred reagent for oxime reductions. 

Reduction. Quinoline may be reduced rather selectively, depending on the reaction conditions. Raney nickel at 70—100°C and 6—7 MPa (60—70 atm) results in a 70% yield of 1,2,3,4-tetrahydroquinoline (32). Temperatures of 210—270°C produce only a slightly lower yield of decahydroquinoline [2051-28-7]. Catalytic reduction with platinum oxide in strongly acidic solution at ambient temperature and moderate pressure also gives a 70% yield of 5,6,7,8-tetrahydroquinoline [10500-57-9] (33). Further reduction of this material with sodium—ethanol produces 90% of /ra/ j -decahydroquinoline [767-92-0] (34). Reductions of the quinoline heterocycHc ring accompanied by alkylation have been reported (35). Yields vary widely sodium borohydride—acetic acid gives 17% of l,2,3,4-tetrahydro-l-(trifluoromethyl)quinoline [57928-03-7] and 79% of 1,2,3,4-tetrahydro-l-isopropylquinoline [21863-25-2]. This latter compound is obtained in the presence of acetone the use of cyanoborohydride reduces the pyridine ring without alkylation. 

Isoquinoline can be reduced quantitatively over platinum in acidic media to a mixture of i j -decahydroisoquinoline [2744-08-3] and /n j -decahydroisoquinoline [2744-09-4] (32). Hydrogenation with platinum oxide in strong acid, but under mild conditions, selectively reduces the benzene ring and leads to a 90% yield of 5,6,7,8-tetrahydroisoquinoline [36556-06-6] (32,33). Sodium hydride, in dipolar aprotic solvents like hexamethylphosphoric triamide, reduces isoquinoline in quantitative yield to the sodium adduct [81045-34-3] (25) (152). The adduct reacts with acid chlorides or anhydrides to give N-acyl derivatives which are converted to 4-substituted 1,2-dihydroisoquinolines. Sodium borohydride and carboxylic acids combine to provide a one-step reduction—alkylation (35). Sodium cyanoborohydride reduces isoquinoline under similar conditions without N-alkylation to give... 

The reduction of 3,5-diphenylisoxazoline with sodium cyanoborohydride produced a mixture of isomeric 3,5-diphenylisoxazolidines. The H and NMR spectra were utilized to distinguish the isomers SOLAIOI). Sodium borohydride reductions likewise reduce isoxazolines to isoxazolidines (equation 56) (80JA4265). 

Reductive amination ol aldehydes or ketones by cyanoborohydride (or tnacetoxyborohydride) anion Selective reduction of carbonyls to alcohol, oximes to N alkylhydroxylarmnes, enamines to amines... 

The first total synthesis of 87 was published in 1990 (90TL1523). 5-Hydroxyindole (88) was mesylated and then reduced with sodium cyanoborohydride to give an indoline which was brominated to afford the bromoindoline 89 in good yield (Scheme 33). Cross-coupling with ortho-formyl boronic acid under Suzuki conditions, followed by air oxidation of the resulting cyclized product, followed by reduction of the lactam formed with excess Red-Al gave the target compound 87. 

Sodium cyanoborohydride. reductive ami nation with, 931 Sodium cyclamate, LP50 of, 26 Sodium hydride, reaction with alcohols, 605... 

Reductive aziridine ring-opening with sodium cyanoborohydride has been described [74, 91]. In the presence of a catalytic amount of TsOH, compound 111 (Scheme 3.37) gave 112 in 68% yield on treatment with sodium cyanoborohydride [74, 91]. 

Reductive amination of AT-succinyl chitosan and lactose using sodium cyanoborohydride in a phosphate buffer (pH 6.0) for 6 days was suitable for the preparation of lactosaminated M-succinyl chitosan (Fig. 3). Over 10% of dose/g-tissue was distributed to the prostate and lymph nodes at 48 h postadministration in both chitosan and lactosaminated N-succinyl chitosan. The labeled lactosaminated M-succinyl chitosan was easily distributed into not only the liver but also prostate, intestine, preputial gland and lymph nodes [153]. 

The N-substituted aminoacids required could be prepared by microwave-assisted reductive amination of aminoacid methyl esters with aldehydes, and although in the Westman report soluble NaBH(OAc)3 was used to perform this step, other reports have shown how this transformation can be performed in using polymer-supported borohydrides (such as polymer-supported cyanoborohydride) under microwave irradiation [90]. An additional point of diversity could be inserted by use of a palladium-catalyzed reaction if suitably substituted aldehydes had been used. Again, these transformations might eventually be accomplished using supported palladium catalysts under microwave irradiation, as reported by several groups [91-93]. 

N,N-Dibenzyl (z -amino a-chloroketimines 202 can be prepared from the corresponding ketones, which in turn are available by the addition of chloromethyllithium to esters of natural cz-amino acids. Reduction of 202 with sodium cyanoborohydride directly afforded a-aminoalkyl-substituted aziridines 203 with high syn diastereoselectivity, which was only moderately affected by the size of the substituent [96] (Scheme 30). A complemen-... 

Rather than preforming the a-amino ketimines to be reduced, it is often advantageous to form in situ the more reactive iminium ions from a-aminoketones and primary amines or ammonium salts in the presence of the reducing agent, e.g., sodium cyanoborohydride. Use of this procedure (reductive amination) with the enantiopure a-aminoketone 214 and benzylamine allowed the preparation of the syn diamines 215 with high yields and (almost) complete diastereoselectivities [100] (Scheme 32). Then, the primary diamines 216 were obtained by routine N-debenzylation. Similarly, the diamine 217 was prepared using ammonium acetate. In... 

Scheme 32 Reductive amination of chiral a-aminoketones with sodium cyanoborohydride...

Sodium borohydride is sometimes used in conjunction with CeCl3 (Luche s reagent).70 The active reductants under these conditions are thought to be alkoxyborohydrides. Sodium cyanoborohydride is a useful derivative of sodium borohydride.71 The electron-attracting cyano substituent reduces reactivity and only iminium groups are rapidly reduced by this reagent. 

A valuable application of sodium cyanoborohydride is in the synthesis of amines by reductive amination. What combination of carbonyl and amine components would give the following amines by this method ... 

The 8-methyl-8,14-cycloberbine 364, derived from the protoberberine 324 via the betaine 363, was reduced with sodium borohydride or lithium aluminum tri-tert-butoxyhydride to give a diastereoisomeric mixture of cis-and trans-alcohols (7.8 1 or 1 7.8, respectively) (Scheme 64).t)n exposure to formaldehyde the mixture underwent N-hydroxymethylation and subsequent intramolecular substitution on the aziridine ring to give the oxazolidine 365. Removal of the hydroxyl group in 365 was accomplished by chlorination followed by hydrogenolysis with tributyltin hydride. Reductive opening of the oxazolidine 366 with sodium cyanoborohydride afforded ( )-raddeanamine (360), which has already been converted to ochotensimine (282) by dehydration. 

An interesting procedure has been proposed for the synthesis of amylose-b-PS block copolymers through the combination of anionic and enzymatic polymerization [131]. PS end-functionalized with primary amine or dimethylsilyl, -SiMe2H groups were prepared by anionic polymerization techniques, as shown in Scheme 56. The PS chains represented by the curved lines in Scheme 56 were further functionalized with maltoheptaose oligomer either through reductive amination (Scheme 57) or hydrosilyla-tion reactions (Scheme 58). In the first case sodium cyanoborohydride was used to couple the saccharide moiety with the PS primary amine group. 

Gheorghe et al. make use of sodium cyanoborohydride as a hydride source in the synthesis of 5-arylpiperidines <06OL1653>. Kellehar and Kelly report the formation of a spiro -lactam using sodium borohydride in the key reductive animation step <06TL3005>. 

Zemplen O-deacetylation followed by cleavage of the acetal protecting groups with aqueous TFA afforded G(0) dendron 451, whose reducing end was reductively animated with bismethylamino trisaccharide 452 using cyanoborohydride in 1 1 MeOH-H20 to furnish the G(l) dendron 435 in 48% yield. 

---