Redox catalytic activity

Sensors The ceria NPs could also be used in biosensors as well as the gas sensors. The redox catalytic activity and the semiconductivity of ceria allow it to be used as gas sensors for the reductive and oxidative gases such as CO, NO2,02, and alcohols by the resistivity or catalumines-cence measurements. The noble metals or metal oxides which could activate the catalytic process of ceria could also help to increase the sensitivity of ceria for gas sensing. 

Numerous efforts have been spent on doping silica with other elements, most of which are transition metal elements. In many cases, the goal of these syntheses is to introduce or enhance acidic or redox catalytic activity into mesoporous silica. Depending on the individual element and synthetic procedures, the doping level spans a wide range of values from about 5 to over 3000 for the Si/dopant molar ratio. ... 

Figure 11.3 Number of exposed redox catalytic active sites for supported V2O5/AI2O3 catalysts as a function of vanadium oxide loading. Monolayer coverage corresponds to the 20% V2O5/AI2O3 (-7.9V atoms/nm ) catalyst sample.

The common means of introducing redox catalytic activity in zeolites is by the substitution of framework atoms such as Si, A1 or P with redox-active metal cations. This has been accomplished by two different methods (1) hydrothermal synthesis and (2) post-synthesis modification. Irrespective of the method of preparation, with the notable exception of titanium silicalites, these redox metals in the framework are susceptible to leaching due to the solvolysis of M-O bonds [77]. Even the Ti silicalites suffer from leaching under basic conditions [76a]. 

The larger A cations, usually alkaline or rare earth elements, with inert d" or f electronic structure, act as structural stabilizers and do not offer much to the redox catalytic activity. The smaller B cations can be 3d, 4d, or 5d transition metal elements and are the main catalytic sites/centers in such solids due to their ability to undergo reversed redox cycles without destruction of the structure. In the vast majority of catalytic studies, 3d cations are employed due to obvious economic reasons. Nevertheless, almost 95% of the elements of the periodic table can participate in perovskites and these many possible combinations result in a plethora of diverse, and sometimes imexpected, properties of such solids, which have been nick-named chemical chameleons. 

High oxidation state transition-metal oxide ions isolated and sparsely distributed within the Al + sublattice of open-structure metal microporous alumino-phosphate (MAlPOs) solids (M = Co +, Mn +, Fe +) function as powerful redox, catalytically active centers in the selective oxyfunctionalization of alkanes. Important chemical commodities are also conveniently prepared by using such microporous catalysts in solvent free conditions, and using oxygen or air as oxidants [179,180]. 

PMo220 4q, is analytically usehil, being formed in the molybdenum test for phosphate ion. Poly- and heteropolymolybdate ions are used in the precipitation of dyes. The protonated forms of the ions are strongly acidic and many poly- and heteropolymolybdate compounds have catalytic activity that is attributable to their acid—base or redox properties. 

A.uxilia driers do not show catalytic activity themselves, but appear to enhance the activity of the active drier metals. It has been suggested that the auxihary metals improve the solubiUty of the active drier metal, can alter the redox potential of the metal, or function through the formation of complexes with the primary drier. Auxihary driers include barium, zirconium, calcium, bismuth, zinc, potassium, strontium, andhthium. 

Oxidation of P-nicotinamide adenine dinucleotide (NADH) to NAD+ has attracted much interest from the viewpoint of its role in biosensors reactions. It has been reported that several quinone derivatives and polymerized redox dyes, such as phenoxazine and phenothiazine derivatives, possess catalytic activities for the oxidation of NADH and have been used for dehydrogenase biosensors development [1, 2]. Flavins (contain in chemical structure isoalloxazine ring) are the prosthetic groups responsible for NAD+/NADH conversion in the active sites of some dehydrogenase enzymes. Upon the electropolymerization of flavin derivatives, the effective catalysts of NAD+/NADH regeneration, which mimic the NADH-dehydrogenase activity, would be synthesized [3]. 

Figure 1.9 Examples of functionally important intrinsic metal atoms in proteins, (a) The di-iron center of the enzyme ribonucleotide reductase. Two iron atoms form a redox center that produces a free radical in a nearby tyrosine side chain. The iron atoms are bridged by a glutamic acid residue and a negatively charged oxygen atom called a p-oxo bridge. The coordination of the iron atoms is completed by histidine, aspartic acid, and glutamic acid side chains as well as water molecules, (b) The catalytically active zinc atom in the enzyme alcohol dehydrogenase. The zinc atom is coordinated to the protein by one histidine and two cysteine side chains. During catalysis zinc binds an alcohol molecule in a suitable position for hydride transfer to the coenzyme moiety, a nicotinamide, [(a) Adapted from P. Nordlund et al., Nature 345 593-598, 1990.)...

It is so universally applied that it may be found in combination with metal oxide cathodes (e.g., HgO, AgO, NiOOH, Mn02), with catalytically active oxygen electrodes, and with inert cathodes using aqueous halide or ferricyanide solutions as active materials ("zinc-flow" or "redox" batteries). The cell (battery) sizes vary from small button cells for hearing aids or watches up to kilowatt-hour modules for electric vehicles (electrotraction). Primary and storage batteries exist in all categories except that of flow-batteries, where only storage types are found. Acidic, neutral, and alkaline electrolytes are used as well. The (simplified) half-cell reaction for the zinc electrode is the same in all electrolytes ... 

Due to its electronic conductivity, polypyrrole can be grown to considerable thickness. It also constitutes, by itself, as a film on platinum or gold, a new type of electrode surface that exhibits catalytic activity in the electrochemical oxidation of ascorbic acid and dopamine in the reversible redox reactions of hydroquinones and the reduction of molecular oxygen iV-substituted pyrroles are excellent... 

A general theory based on the quantitative treatment of the reaction layer profile exists for pure redox catalysis where the crucial function of the redox mediator is solely electron transfer and where the catalytic activity largely depends only on the redox potential and not on the structure of the catalyst This theory is consistent... 

The many redox reactions that take place within a cell make use of metalloproteins with a wide range of electron transfer potentials. To name just a few of their functions, these proteins play key roles in respiration, photosynthesis, and nitrogen fixation. Some of them simply shuttle electrons to or from enzymes that require electron transfer as part of their catalytic activity. In many other cases, a complex enzyme may incorporate its own electron transfer centers. There are three general categories of transition metal redox centers cytochromes, blue copper proteins, and iron-sulfur proteins. 

The difference in catalytic activity between the La- and the Ba-based hexa-aluminates results from the following reasons the first difference is the valence of cation in the mirror pleuie between tri-valent lanthanum ion and di-valent barium ion. The second is the crystal structure between magnetoplumbite and P-alumina, which are different in the coordination of ions and concentration of Frenkel-type defect in mirror plane. The redox cycle of transition metal in hexa-aluminate lattice, which closely related with catalytic activity, is affected sensitively with these two factors. 

Reasonable NO conversion can be achieved using n-decane as reductant. In the absence of sulfur dioxide, the catalytic activity is roughly related to the r ucibility of the Cu phase of Cu ions in zeolites the reaction temperature needed to reach 20% NO conversion parallels that of the TPR peak (Table 7). This relation also practically holds for Cu on simple oxides, therefore a redox mechanism in which reduction of Cu + cations is the slow step could account for the results. 

The presence of V V on the surface before catalysis is unessential for catalytic activity. We cannot however rule out an SCR redox mechanism involving VV-V V. ESR and IR results show that the oxidation state of surface vanadium at the reaction temperature is controlled mainly by the composition of the reactant mixture. 

Figure 29.4 shows an example, the energy diagram of a cell where n-type cadmium sulfide CdS is used as a photoanode, a metal that is corrosion resistant and catalytically active is used as the (dark) cathode, and an alkaline solution with S and S2 ions between which the redox equilibrium S + 2e 2S exists is used as the electrolyte. In this system, equilibrium is practically established, not only at the metal-solution interface but also at the semiconductor-solution interface. Hence, in the dark, the electrochemical potentials of the electrons in all three phases are identical. 

The high catalytic activity of enzymes has a number of sources. Every enzyme has a particular active site configured so as to secure intimate contact with the substrate molecule (a strictly defined mutual orientation in space, a coordination of the electronic states, etc.). This results in the formation of highly reactive substrate-enzyme complexes. The influence of tfie individual enzymes also rests on the fact that they act as electron shuttles between adjacent redox systems. In biological systems one often sees multienzyme systems for chains of consecutive steps. These systems are usually built into the membranes, which secures geometric proximity of any two neighboring active sites and transfer of the product of one step to the enzyme catalyzing the next step. 

The Na/K ATPase has been extensively purified and characterized, and consists of a catalytic a subunit of around 95 kDa and a glycoprotein 0 subunit of approximately 45 kDa (Skou, 1992). The functional transporter exists as a dimer with each monomer consisting of an a and /3 subunit. Hiatt aal. (1984) have su ested that the non-catalytic jS subunit may be involved in the cottect insertion of the a subunit into the lipid bilayer and, therefore, it is conceivable that a modification of the 0 subunit structure may be reflected by changes in the catalytic activity of the a subunit. Therefore, in studies involving the manipulation of tissue glutathione levels, alterations of intracellular redox state may have an effect on substrate binding at an extracellular site on this ion-translocating protein. 

---