Bearings radial

Radial Bearings Antifriction bearings are largely unsuitable for these applications, chiefly because of the special attention and maintenance which they demand. 

Figure 2-11 illustrates the potential severity of three problems that tend to eorrelate turboexpander inlet pressure thrust bearings, erosion of rotor and nozzles, and radial bearings. 

Two non-eontaeting proximity probes positioned at 90° shall be supplied at eaeh radial bearing. The probes shall be supplied eomplete with proximitors and intereonneeting wires. 

Operating Principles and Design Features Radial Bearings... 

An active magnetic axial bearing consists of two stators and a rotor disk (Figure 6-4). A sensor located at the end of the shaft monitors and maintains the rotor position between the two stators. The principle of operation is the same for both axial and radial bearings any deviation from the normal position of the rotor is communicated to the electronic control system, which adjusts the electric current going to the electromagnets to correct the rotor position. 

In a eompressor with a vaned diffuser followed by a typieal easing, the non-uniform, eireumferential flow resistanee aeross the diffuser walls induees an asymmetrie gas pressure around the wheel. Non-uniform peripheral gas pressure results in unbalaneed loading on the wheel and, henee, a radial bearing load. 

The double amplitude of unfiltered vibration in any plane measured on the shaft adjacent to each radial bearing is not to exceed 2.0 mils (0.05 mm) or the value given by... 

There are many roller bearing types. They are differentiated aeeording to the direetion of the main radial loads (radial bearings) or axial loads (thrust... 

Proeess flow measurement at inlet or diseharge of maehine Radial-bearing temperature thermoeouple or resistanee temperature element embedded in eaeh bearing, or temperature at lube oil diseharge of eaeh bearing. 

Bearing failures are one of the major eauses of failures in turbomaehinery. The ehanging of various types of radial bearings from eylindrieal and/or... 

The liquid film seal uses metallic sealing rings and is liquid buffered to maintain a fluid film in the clearance area and thereby preclude gas leakage. It is not unusual in the screw compressor to find the radial bearing and seal combined. 

Radial bearings or journal bearings are usually pressure-lubricated. Most compressors use two bearings on opposite ends of the rotor assembly or on... 

The magnetic bearing is made up of a series of electromagnets located circumferentially around the shaft to form the radial bearing. The electromagnets (Figure 5-42) are laminated to limit the eddy current losses. The shaft must be fitted with a laminated sleeve (see Figure 5-43) for the... 

Figure 8-27. Typical radial bearing temperature sensor installation.

Figure B-29. Radial bearing with a temperature sensor installed. Courtesy of A-C Compressor Corporation)...

In general, the downhole positive displacement motor constructed on the Moineau principle is composed of four sections (1) the dump valve section, (2) the multistage motor section, (3) the connecting rod section and (4) the thrust and radial-bearing section. These sections are shown in Figure 4-202. Usually the positive displacement motor has multichambers, however, the number of chambers in a positive displacement motor is much less than the number of stages in a turbine motor. A typical positive displacement motor has from two to seven chambers. 

The rotors are eccentric in their rotation at the bottom of the motor section. Thus, the connecting rod section provides a flexible coupling between the rotor and the main drive shaft located in the thrust and radial bearing section. The main drive shaft has the drill bit connected to its bottom end. 

---