Racemic amines kinetic resolution

Acyl transferase enzymes have been widely used to synthesize chiral esters, amides, alcohols, and amines. In many cases, these conversions involve kinetic resolutions of alcohols, adds, esters, amines, and amides. Of course, since each enantiomer makes up half of the racemic mixture, kinetic resolutions can provide a maximum 50% yield. This limitation can be overcome by racemizing or inverting the configuration of the unreacted substrate during the enzymatic reaction. Such a scheme is referred to as a dynamic kinetic resolution and theoretically allows complete substrate conversion to product along with 100% chemical yield of a single product enantiomer. 

A very interesting approach to optically active sulphoxides, based on a kinetic resolution in a Pummerer-type reaction with optically active a-phenylbutyric acid chloride 269 in the presence of /V,A -dimethyIaniline, was reported by Juge and Kagan332 (equation 149). In contrast to the asymmetric reductions discussed above, this procedure afforded the recovered sulphoxides in optical yields up to 70%. Chiral a, /1-unsaturated sulphoxides 270 were prepared via a kinetic resolution elaborated by Marchese and coworkers333. They found that elimination of HX from racemic /i-halogenosulphoxides 271 in the presence of chiral tertiary amines takes place in an asymmetric way leading to both sulphoxides 270 and 271, which are optically active (optical yields up to 20%) with opposite configurations at sulphur (equation 150). 

Table 1.3 Influence ofthe organic solvent on the enantioselectivity of the protease subtilisin in the kinetic resolution ofthe racemic amine (9) (expressed as the ratio ofthe initial rate of acylation of the pure enatiomers, Vs/vr).

The resolution of racemic ethyl 2-chloropropionate with aliphatic and aromatic amines using Candida cylindracea lipase (CCL) [28] was one of the first examples that showed the possibilities of this kind of processes for the resolution of racemic esters or the preparation of chiral amides in benign conditions. Normally, in these enzymatic aminolysis reactions the enzyme is selective toward the (S)-isomer of the ester. Recently, the resolution ofthis ester has been carried out through a dynamic kinetic resolution (DKR) via aminolysis catalyzed by encapsulated CCL in the presence of triphenylphosphonium chloride immobilized on Merrifield resin (Scheme 7.13). This process has allowed the preparation of (S)-amides with high isolated yields and good enantiomeric excesses [29]. 

Chiral Recognition. The use of chiral hosts to form diastereomeric inclusion compounds was mentioned above. But in some cases it is possible for a host to form an inclusion compound with one enantiomer of a racemic guest, but not the other. This is caUed chiral recognition. One enantiomer fits into the chiral host cavity, the other does not. More often, both diastereomers are formed, but one forms more rapidly than the other, so that if the guest is removed it is already partially resolved (this is a form of kinetic resolution, see category 6). An example is use of the chiral crown ether (53) partially to resolve the racemic amine salt (54). " When an aqueous solution of 54 was... 

Kinetic resolution of racemic allylic acetates has been accomplished via asymmetric dihydroxylation (p. 1051), and 2-oxoimidazolidine-4-carboxy-lates have been developed as new chiral auxiliaries for the kinetic resolution of amines. Reactions catalyzed by enzymes can be utilized for this kind of resolution. ... 

In the case of the ketone (12), a racemic mixture was converted to an optically active mixture (optical yield 46%) by treatment with the chiral base (13). This happened beeause 13 reacted with one enantiomer of 12 faster than with the other (an example of kinetic resolution). The enolate (14) must remain coordinated with the chiral amine, and it is the amine that reprotonates 14, not an added proton donor. 

This mechanism is the same as that of 19-23 the products differ only because tertiary amine oxides cannot be further oxidized. The mechanism with other peroxyacids is probably the same. Racemic (3-hydroxy tertiary amines have been resolved by oxidizing them with t-BuOOH and a chiral catalyst one enantiomer reacts faster than the other.This kinetic resolution gives products with enantiomeric excesses of > 90%. 

Mikolajczyk and coworkers have summarized other methods which lead to the desired sulfmate esters These are asymmetric oxidation of sulfenamides, kinetic resolution of racemic sulfmates in transesterification with chiral alcohols, kinetic resolution of racemic sulfinates upon treatment with chiral Grignard reagents, optical resolution via cyclodextrin complexes, and esterification of sulfinyl chlorides with chiral alcohols in the presence of optically active amines. None of these methods is very satisfactory since the esters produced are of low enantiomeric purity. However, the reaction of dialkyl sulfites (33) with t-butylmagnesium chloride in the presence of quinine gave the corresponding methyl, ethyl, n-propyl, isopropyl and n-butyl 2,2-dimethylpropane-l-yl sulfinates (34) of 43 to 73% enantiomeric purity in 50 to 84% yield. This made available sulfinate esters for the synthesis of t-butyl sulfoxides (35). 

The first reductive kinetic resolution of racemic sulphoxides was reported by Balenovic and Bregant. They found that L-cysteine reacted with racemic sulphoxides to produce a mixture of L-cystine, sulphide and non-reduced optically active starting sulphoxide (equation 147). Mikojajczyk and Para reported that the reaction of optically active phosphonothioic acid 268 with racemic sulphoxides used in a 1 2 ratio gave the non-reduced optically active sulphoxides, however, with a low optical purity (equation 148). It is interesting to note that a clear relationship was found between the chirality of the reducing P-thioacid 268 and the recovered sulphoxide. Partial asymmetric reduction of racemic sulphoxides also occurs when a complex of LiAlH with chiral alcohols , as well as a mixture of formamidine sulphinic acid with chiral amines, are used as chiral reducing systems. ... 

If, according to a modified Horeau method (partial kinetic resolution of a racemate), an optically active carboxylic acid is treated with an excess of racemic amine or alcohol, the configuration of the carboxylic acid can be inferred from the optical rotation of the residual amine or alcohol [48]... 

Chiral amines can also be produced using aminotransferases, either by kinetic resolution of the racemic amine or by asymmetric synthesis from the corresponding prochiral ketone. The reaction involves the transfer of an amino group, a proton and two electrons from a primary amine to a ketone, and proceeds via an intermediate imine adduct. A variety of chiral amines can be obtained with high to very high ee-values. Several transformations have been developed and can be carried out on a 100-kg scale [94]. 

Figure 5.19 Recycling experiments in the kinetic resolution of racemic amine using the sol-gel CaLB immobilizate prepared with 18-crown-6 as an additive. (Reproduced from ref. 30, with permission.)... 

The kinetic resolution of racemic trans ester 76a using catalytic amounts of chiral amine-borane 78 and di-f-butyl peroxide as initiator under pho-tolytic conditions at - 74 °C provided the enantioenriched (R,R) product in 74% ee after 52% consumption of the racemate [64-67]. For the ester 76b, (R,R) product in 97% ee was isolated after 75% consumption at -90°C (Scheme 20). 

A very interesting approach to chiral a unsaturated sulfoxides 39 based on a kinetic resolution was elaborated by Marchese (69), who found that asymmetric elimination of racemic j3-halogenosul-foxides 40 takes place in the presence of chiral tertiary amines. 

Recently, a similar reaction has been shown to affect the kinetic resolution of racemic secondary amines (Scheme 6) [15]. In this example, A7-oxyl radical (20) was utilized as the mediator. The rest of the reaction conditions remained the... 

Scheme 6 Kinetic resolution in the oxidation of a rac-sec amine with a non racemic nitroxyl mediator.

Dynamic Kinetic Resolution of Primary Amines with a Recyclable Palladium Nanocatalyst (Pd/A10(0H)) for Racemization... 

The complete transformation of a racemic mixture into a single enantiomer is one of the challenging goals in asymmetric synthesis. We have developed metal-enzyme combinations for the dynamic kinetic resolution (DKR) of racemic primary amines. This procedure employs a heterogeneous palladium catalyst, Pd/A10(0H), as the racemization catalyst, Candida antarctica lipase B immobilized on acrylic resin (CAL-B) as the resolution catalyst and ethyl acetate or methoxymethylacetate as the acyl donor. Benzylic and aliphatic primary amines and one amino acid amide have been efficiently resolved with good yields (85—99 %) and high optical purities (97—99 %). The racemization catalyst was recyclable and could be reused for the DKR without activity loss at least 10 times. 

Dynamic Kinetic Resolution of Amines Involving Biocatalysis and In Situ Free-radical-mediated Racemization... 

Dynamic kinetic resolution enables the limit of 50 % theoretical yield of kinetic resolution to be overcome. The application of lipase-catalyzed enzymatic resolution with in situ thiyl radical-mediated racemization enables the dynamic kinetic resolution of non-benzylic amines to be obtained. This protocol leads to (/f)-amides with high enantioselectivities. It can be applied either to the conversion of racemic mixtures or to the inversion of (5)-enantiomers. 

Gastaldi, S., Escoubet, S., Vanthuyne, N., Gil, G. and Bertrand, M.P., Dynamic kinetic resolution of amines involving biocatalysis and in situ free radical mediated racemization. Org. Lett., 2007, 9, 837-839. 

We have used a series of biocatalysts produced by site-directed mutations at the active site of L-phenylalanine dehydrogenase (PheDH) of Bacillus sphaericus, which expand the substrate specificity range beyond that of the wild-type enzyme, to catalyse oxidoreduc-tions involving various non-natural L-amino acids. These may be produced by enantiose-lective enzyme-catalysed reductive amination of the corresponding 2-oxoacid. Since the reaction is reversible, these biocatalysts may also be used to effect a kinetic resolution of a D,L racemic mixture. ... 

The vinyloxirane reaction was later extended to methylidene cyclohexene oxide and to related meso derivatives [53]. The effects of the diastereomeric ligands 42 and 43 (Fig. 8.5), derived from (S)-binaphthol and (S, S)- or (R, R)-feis-phenylethyl-amine respectively, were investigated. In the case of kinetic resolution of racemic methylidene cyclohexane epoxide 45 with Et2Zn, ligand 42 produced better yields, regioselectivity, and enantioselectivity than 43 (Scheme 8.27). 

The reversibility of hydrogen transfer reactions has been exploited for the racemi-zation of alcohols and amines. By coupling the racemization process with an enantioselective enzyme-catalyzed acylation reaction, it has been possible to achieve dynamic kinetic resolution reactions. The combination of lipases or... 

Scheme 32 Dynamic kinetic resolution of racemic aryloxy epoxides with amine using the catalysts 77...

In a different approach, fluorescence-based DNA microarrays are utilized (88). In a model study, chiral amino acids were used. Mixtures of a racemic amino acid are first subjected to acylation at the amino function with formation of A-Boc protected derivatives. The samples are then covalently attached to amine-functionalized glass slides in a spatially arrayed manner (Fig. 10). In a second step, the uncoupled surface amino functions are acylated exhaustively. The third step involves complete deprotection to afford the free amino function of the amino acid. Finally, in a fourth step, two pseudo-Qn nX. om.Qx c fluorescent probes are attached to the free amino groups on the surface of the array. An appreciable degree of kinetic resolution in the process of amide coupling is a requirement for the success of the ee assay (Horeau s principle). In the present case, the ee values are accessible by measuring the ratio of the relevant fluorescent intensities. About 8000 ee determinations are possible per day, precision amounting to +10% of the actual value ((S(S). Although it was not explicitly demonstrated that this ee assay can be used to evaluate enzymes (e.g., proteases), this should in fact be possible. So far this approach has not been extended to other types of substrates. 

A typical example that illustrates the method concerns the lipase- or esterase-catalyzed hydrolytic kinetic resolution of rac-1-phenyl ethyl acetate, derived from rac-1-phenyl ethanol (20). However, the acetate of any chiral alcohol or the acetamide of any chiral amine can be used. A 1 1 mixture of labeled and non-labeled compounds (S)- C-19 and (f )-19 is prepared, which simulates a racemate. It is used in the actual catalytic hydrolytic kinetic resolution, which affords a mixture of true enantiomers (5)-20 and (J )-20 as well as labeled and non-labeled acetic acid C-21 and 21, respectively, together with non-reacted starting esters 19. At 50% conversion (or at any other point of the kinetic resolution), the ratio of (5)- C-19 to (1 )-19 correlates with the enantiomeric purity of the non-reacted ester, and the ratio of C-21 to 21 reveals the relative amounts of (5)-20 and (J )-20 (98). 

List later reported the asymmetric reductive amination of a wide spectrum of aromatic and aliphatic a-branched aldehydes via dynamic kinetic resolution (Scheme 5.27) [49]. The initial imine condensation product is believed to undergo fast racemization in the presence of the acid catalyst Ih through an imine/enamine tautomerization pathway. Preferential reductive amination of one of the imine enantiomers furnishes the optically pure P-branched amine. 

---