Potassium leaching

Ehrenberg, S.N. (1991) Kaolinized, potassium-leached zones in the contacts of the Gam Formation, Halten-... 

The results for potassium show that the mechanism is different than for other parameters. In fact potassium leaching was decreased in all cases by wet preconditioning. These results indicate that potassium is leached from the cement in contact with water whatever the water characteristics are. The same potassium concentrations were observed with soft and medium mineralized migration waters. (Note that potassium leaching will tend to increase the pH as it is leached from the cement as KOH). 

Transesterification of oil from waste oilseed fiuits with methanol was studied in both homogeneous and heterogeneous catalyzed systems. Potassium loaded on lTQ-6 (Delaminated zeolite lTQ-6) by ionic exchange was found to be an efficient base catalyst, which produced 87% biodiesel. The optimum conditions were found to be 1 20 ratio of oil to MeOH at 180° C with 5% catalyst with reaction time of 48 h. Though potassium leaching was observed, which led to deactivation of the catalyst, its regeneration and reusability were easy to perform [82], The catalyst was also reported to be active in the conversion of oil containing free fatty acids (5.58%) without any soap formation and functions as acid ase catalyst. 

Alonso, D. M., Mariscal, R., Moreno-Tost, R., Zafra Poves, M.D., Lopez Granados, M. Potassium leaching during triglyceride transesterification using K/A1203 catalysts. Catal Comm 8,2074—2080 (2007). 

In the United States the analytical methods approved by most states are ones developed under the auspices of the Association of Official Analytical Chemists (AOAC) (3). Penalties for analytical deviation from guaranteed analyses vary, even from state to state within the United States (4). The legally accepted analytical procedures, in general, detect the solubiUty of nitrogen and potassium in water and the solubiUty of phosphoms in a specified citrate solution. Some very slowly soluble nutrient sources, particularly of nitrogen, are included in some specialty fertilizers such as turf fertilizers. The slow solubihty extends the period of effectiveness and reduces leaching losses. In these cases, the proportion and nature of the specialty source must be detailed on the labeling. 

The fused product is cooled, cmshed, and leached with acidified hot water. The resulting hot solution of potassium hexafiuoto2irconate—hafnate is filtered to remove siUca, then cooled to allow crystaUi2ation of the potassium hexafiuoto2irconate—hafnate. Many of the impurity metals remain in solution. 

Use of excess sodium drives the reaction, usually done under an argon or helium blanket, to completion. After cooling, the excess sodium is leached with alcohol and the sodium and potassium fluorides are extracted with water, leaving a mass of metal powder. The metal powder is leached with hydrochloric acid to remove iron contamination from the cmcible. 

Potassium nitrate, essential in the manufacture of black gun powder, was produced by the Chinese, who had developed gun powder by the tenth century AD. The process involved the leaching of soil in which nitrogen from urine had combined with mineral potassium. By the early 1800s, potassium nitrate had become a strategic military chemical and was stiU produced, primarily in India, by using the ancient Chinese method. The caUche deposits in Chile are the only natural source of potassium nitrate (2). These deposits are not a rich source of potassium nitrate, purifying only to about 14% as K O. 

Potassium Carbonate. Except for small amounts produced by obsolete processes, eg, the leaching of wood ashes and the Engel-Precht process, potassium carbonate is produced by the carbonation, ie, via reaction with carbon dioxide, of potassium hydroxide. Potassium carbonate is available commercially as a concentrated solution containing ca 47 wt % K CO or in granular crystalline form containing 99.5 wt % K CO. Impurities are small amounts of sodium and chloride plus trace amounts (<2 ppm) of heavy metals such as lead. Heavy metals are a concern because potassium carbonate is used in the production of chocolate intended for human consumption. 

Potassium alum is manufactured by treating bauxite with sulfuric acid and then potassium sulfate. Alternatively, aluminum sulfate is reacted with potassium sulfate, or the mineral alum stone, alunite, can be calciaed and leached with sulfuric acid. Alunite is a basic potassium aluminum sulfate... 

Tin ores and concentrates can be brought into solution by fusing at red heat in a nickel cmcible with sodium carbonate and sodium peroxide, leaching in water, acidifying with hydrochloric acid, and digesting with nickel sheet. The solution is cooled in carbon dioxide, and titrated with a standard potassium iodate—iodide solution using starch as an indicator. 

Soluble Sta.nna.tes, Many metal staimates of formula M Sn(OH) are known. The two main commercial products are the soluble sodium and potassium salts, which are usually obtained by recovery from the alkaline detinning process. They are also produced by the fusion of stannic oxide with sodium hydroxide or potassium carbonate, respectively, followed by leaching and by direct electrolysis of tin metal in the respective caustic solutions in cells using cation-exchange membranes (27). Another route is the recovery from plating sludges. 

The use of potassium hexafluorosihcate is preferred over sodium hexafluorosihcate because of the lower tendency of the potassium compound to dissociate the lose sihcon tetrafluoride by sublimation. The addition of potassium carbonate or chloride to the fusion mix further reduces this tendency and promotes completion of the reaction. The reaction is conducted in a rotary furnace operating at 700°C. The product is cmshed prior to leaching with acidified hot water. The hot slurry is filtered to remove the sihca, and potassium hexafluorozirconate crystallizes as the solution cools. 

The reaction mixture is filtered. The soHds containing K MnO are leached, filtered, and the filtrate composition adjusted for electrolysis. The soHds are gangue. The Cams Chemical Co. electrolyzes a solution containing 120—150 g/L KOH and 50—60 g/L K MnO. The cells are bipolar (68). The anode side is monel and the cathode mild steel. The cathode consists of small protmsions from the bipolar unit. The base of the cathode is coated with a corrosion-resistant plastic such that the ratio of active cathode area to anode area is about 1 to 140. Cells operate at 1.2—1.4 kA. Anode and cathode current densities are about 85—100 A/m and 13—15 kA/m, respectively. The small cathode areas and large anode areas are used to minimize the reduction of permanganate at the cathode (69). Potassium permanganate is continuously crystallized from cell Hquors. The caustic mother Hquors are evaporated and returned to the cell feed preparation system. 

Consider a lake with a smaU watershed in a forest ecosystem. The forest and vegetation can be considered as an acid concentrator. SO2, NO2, and acid aerosol are deposited on vegetation surfaces during dry periods and rainfalls they are washed to the soil floor by low-pH rainwater. Much of the acidity is neutralized by dissolving and mobilizing minerals in the soil. Aluminum, calcium, magnesium, sodium, and potassium are leached from the soil into surface waters. The ability of soils to tolerate acidic deposition is very dependent on the alkalinity of the soil. The soil structure in the... 

However, the fertilizing effect of nitrates (and sulfates) may be counterbalanced by the leaching of potassium, magnesium, calcium, and other nutrients from forest soils. There is little evidence that agricultural crops are being injured by exposures to nitrates in precipitation. The amount of nitrates in rainwater is almost always... 

Acylglycerols can be hydrolyzed by heating with acid or base or by treatment with lipases. Hydrolysis with alkali is called saponification and yields salts of free fatty acids and glycerol. This is how soap (a metal salt of an acid derived from fat) was made by our ancestors. One method used potassium hydroxide potash) leached from wood ashes to hydrolyze animal fat (mostly triacylglycerols). (The tendency of such soaps to be precipitated by Mg and Ca ions in hard water makes them less useful than modern detergents.) When the fatty acids esterified at the first and third carbons of glycerol are different, the sec-... 

The optimal temperature range for the fluorination process was found to be about 230-290°C. The resulting cake was leached with water. The prepared solution was separated from the precipitate by regular filtration and the separated insoluble precipitate was identified as lithium fluoride, LiF. The solution contained up to 90 g/1 Ta205. Solution acidity was relatively low, with a typical pH = 3-4, and was suitable for the precipitation of potassium heptafluorotantalate, K2TaF7, tantalum hydroxide or further purification by liquid-liquid extraction after appropriate adjustment of the solution acidity [113]. 

---