Polyacrylate-coated fibers, solid-phase microextraction

In the 1990s, Pawliszyn [3] developed a rapid, simple, and solvent-free extraction technique termed solid-phase microextraction. In this technique, a fused-silica fiber is coated with a polymer that allows for fast mass transfer—both in the adsorption and desorption of analytes. SPME coupled with GC/MS has been used to detect explosive residues in seawater and sediments from Hawaii [33]. Various fibers coated with carbowax/divinylbenzene, polydimethylsiloxane/divinylbenzene, and polyacrylate are used. The SPME devices are simply immersed into the water samples. The sediment samples are first sonicated with acetonitrile, evaporated, and reconstituted in water, and then sampled by SPME. The device is then inserted into the injection port of the GC/MS system and the analytes thermally desorbed from the fiber. Various... 

GC combined with mass spectroscopic (MS) detection provides very accurate identification and quantification of FFAs. Pinho et al. (2003) monitored changes in the FFA content during the ripening of ewe cheese. Sampling was done by headspace solid-phase microextraction (SPME). An excellent correlation was observed between the initial concentration of the sample and the amount absorbed on the SPME fiber. SPME sampling was done at 65 °C with a fiber coated with 85-p.m polyacrylate film. After equilibration at 65 °C for 40 min, the fiber was exposed to the sample headspace for 20 min and inserted into the GC port. Despite its accuracy, the GC-MS method is not widely used, presumably because of its cost and complexity. 

As a result of the increase in the number of laboratories carrying out environmental analysis and the corresponding increase in the volumes that are used primarily for extraction and have to be disposed of, there has been increasing use of solid-phase extraction (SPE) methods including solid-phase microextraction (SPME) procedures using fiber-coated poly(dimethylsilox-ane), methyl silicone, or polyacrylate. These procedures are discussed in Sections 2.2.4 and 2.2.7. 

LLE, liquid-liquid extraction MAE, microwave-assisted extraction SEE, solid-phase extraction SPME, solid-phase microextraction LPME, liquid-phase microextraction SOME, single-drop microextraction D-LLLME, dynamic liquid-liquid-liquid microextraction SEE, supercritical fluid extraction MIP, molecularly imprinted polymers sorbent SPMD, device for semipermeable membrane extraction PDMS, polydimethylsiloxane coated fiber PA, polyacrylate coated fiber CW-DMS, Carbowax-divinylbenzene fiber PDMS-DVB, polydimethylsiloxane divinylbenzene fiber CAR-PDMS, Carboxen-polydimethylsiloxane coated fiber DVB-CAR-PDMS, divinylbenzene Carboxen-polydimethylsiloxane coated fiber CW-TPR, Carbowax-template resin HS-SPME, headspace solid-phase microextraction MA-HS-SPME, microwave-assisted headspace-solid-phase microextraction HEM, porous hollow fiber membrane PEl-PPP, polydydroxylated polyparaphenylene. 

Solid-phase microextraction (SPME) in open-tobular fused-silica capillary columns or in fused-silica or Carbowax-templated poly(divinylbenzene) resin fibers coated or filled with a stationary phase (polydimethylsiloxane or polyacrylate) 2 has recently been used to extract analytes from liquid or gaseous samples. This procedure is more restricted to the extraction of volatile compounds, which are... 

---