Platinum catalyst, catalytic oxidation

Catalytic oxidation ia the presence of metals is claimed as both nonspecific and specific for the 6-hydoxyl depending on the metals used and the conditions employed for the oxidation. Nonspecific oxidation is achieved with silver or copper and oxygen (243), and noble metals with bismuth and oxygen (244). Specific oxidation is claimed with platinum at pH 6—10 ia water ia the presence of oxygen (245). Related patents to water-soluble carboxylated derivatives of starch are Hoechst s on the oxidation of ethoxylated starch and another on the oxidation of sucrose to a tricarboxyhc acid. AH the oxidations are specific to primary hydroxyls and are with a platinum catalyst at pH near neutraUty ia the presence of oxygen (246,247). Polysaccharides as raw materials ia the detergent iadustry have been reviewed (248). 

A major step in the production of nitric acid [7697-37-2] (qv) is the catalytic oxidation of ammonia to nitric acid and water. Very short contact times on a platinum—rhodium catalyst at temperatures above 650°C are required. 

Catalytic Oxidation. Catalytic oxidation is used only for gaseous streams because combustion reactions take place on the surface of the catalyst which otherwise would be covered by soHd material. Common catalysts are palladium [7440-05-3] and platinum [7440-06-4]. Because of the catalytic boost, operating temperatures and residence times are much lower which reduce operating costs. Catalysts in any treatment system are susceptible to poisoning (masking of or interference with the active sites). Catalysts can be poisoned or deactivated by sulfur, bismuth [7440-69-9] phosphoms [7723-14-0] arsenic, antimony, mercury, lead, zinc, tin [7440-31-5] or halogens (notably chlorine) platinum catalysts can tolerate sulfur compounds, but can be poisoned by chlorine. 

Hydroxylamine sulfate is produced by direct hydrogen reduction of nitric oxide over platinum catalyst in the presence of sulfuric acid. Only 0.9 kg ammonium sulfate is produced per kilogram of caprolactam, but at the expense of hydrogen consumption (11). A concentrated nitric oxide stream is obtained by catalytic oxidation of ammonia with oxygen. Steam is used as a diluent in order to avoid operating within the explosive limits for the system. The oxidation is followed by condensation of the steam. The net reaction is... 

Usually they are employed as porous pellets in a packed bed. Some exceptions are platinum for the oxidation of ammonia, which is in the form of several layers of fine-mesh wire gauze, and catalysts deposited on membranes. Pore surfaces can be several hundred mVg and pore diameters of the order of 100 A. The entire structure may be or catalytic material (silica or alumina, for instance, sometimes exert catalytic properties) or an active ingredient may be deposited on a porous refractory carrier as a thin film. In such cases the mass of expensive catalytic material, such as Pt or Pd, may be only a fraction of 1 percent. 

Hydrogen cyanide reactions catalysts, 6,296 Hydrogen ligands, 2, 689-711 Hydrogenolysis platinum hydride complexes synthesis, 5, 359 Hydrogen peroxide catalytic oxidation, 6, 332, 334 hydrocarbon oxidation iron catalysts, 6, 379 reduction... 

Eigure 3.9 shows temperatures for 50% conversion (T o) of CH3OH and its decomposed derivatives over Pt/y-Al203, Pd/y-Al203, and Au/a-Pe203 catalysts [52]. Eor MeOH oxidation, palladium is more active than platinum, while gold lies in between. These three catalysts are similarly active for the oxidation of HCHO and HCOOH. Catalytic oxidation at temperatures below 0°C can proceed over palladium and platinum for H2 oxidation, while it happens over gold for CO oxidation. 

While the discovery of the catalytic properties of zeolites was driven by the desire to improve industrial prcKessing, the development of emission control catalysts was necessitated by governmental fiat. The first requirement was for 90+% removal of CO and of hydrocarbons, a goal which could not be met by oxidation with base metal oxides. To achieve the required spedfications during automobile operations, it was necessary to develop supported platinum catalysts. Originally the support was alumina in pellet form. Later platinum on cordierite was used in honeycomb form, containing 200-400 square channels per square inch. 

It was found in the 1960s that disperse platinum catalyst supported by certain oxides will in a number of cases be more active than a similar catalyst supported by carbon black or other carbon carrier. At platinum deposits on a mixed carrier of WO3 and carbon black, hydrogen oxidation is markedly accelerated in acidic solutions (Hobbs and Tseung, 1966). This could be due to a partial spillover of hydrogen from platinum to the oxide and formation of a tungsten bronze, H WOj (0 < a < 1), which according to certain data has fair catalytic properties. 

It was seen when studying mixed systems Pt-WOj/C and Pt-Ti02/C that with increasing percentage of oxide in the substrate mix the working surface area of the platinum crystallites increases, and the catalytic activity for methanol oxidation increases accordingly. With a support of molybdenum oxide on carbon black, the activity of supported platinum catalyst for methanol oxidation comes close to that of the mixed platinum-ruthenium catalyst. 

To the contrary, mnlticomponent nonmetallic systems such as mixed oxides often provide the possibility for a smooth or discontinuous variation of electrophysical parameters, and thns for some adjustment of their catalytic properties. In a number of cases, one can do without expensive platinum catalysts, instead using nonmetallic catalysts. Serious research into the properties of nonmetallic catalytic electrodes was initiated in the 1960s in connection with broader efforts to realize various kinds of fuel cells. 

Jones AK, Sillery E, Albracht SPJ, Armstrong FA. 2002. Direct comparison of the electro-catalytic oxidation of hydrogen by an enzyme and a platinum catalyst. Chem Commun 866-867. 

Thermal treatment—Processes in which vapor-phase contaminants are destroyed via high-temperature oxidation the primary categories of thermal treatment used to treat MTBE and other oxygenates include thermal oxidation, which employs a flame to generate the high temperatures needed to oxidize contaminants, and catalytic oxidation, which employs lower temperatures in the presence of a catalyst (typically platinum, palladium, or other metal oxides) to destroy contaminants. 

Reactions over chromium oxide catalysts are often carried out without the addition of hydrogen to the reaction mixture, since this addition tends to reduce the catalytic activity. Thus, since chromium oxide is highly active for dehydrogenation, under the usual reaction conditions (temperature >500°C) extensive olefin formation occurs. In the following discussion we shall, in the main, be concerned only with skeletally distinguished products. Information about reaction pathways has been obtained by a study of the reaction product distribution from unlabeled (e.g. 89, 3, 118, 184-186, 38, 187) as well as from 14C-labeled reactants (89, 87, 88, 91-95, 98, 188, 189). The main mechanistic conclusions may be summarized. Although some skeletal isomerization occurs, chromium oxide catalysts are, on the whole, less efficient for skeletal isomerization than are platinum catalysts. Cyclic C5 products are of never more than very minor impor-... 

Catalytic converters are basically smog control devices on newer automobiles. Catalytic converters have an oxidation catalyst that oxidizes CO and hydrocarbons to CO2 and H2O. It may also have a reduction catalyst that reduces NO to N2. The catalysts involved with these processes are generally platinum or palladium metal operating at relatively high temperature. 

Oxycat A catalytic oxidation process for removing combustible vapors from air and industrial exhaust gases. The catalyst is platinum on alumina, supported inside a porcelain tube. 

Searching for a better catalyst than platinum to oxidize methanol to COad ° y be a new direction of the catalyst search. If such a catalyst is combined with a good catalyst for COad oxidation to C02> the overall catalytic activity may exceed that of platinum based catalysts. Platinum has catalytic activities for both reactions to some extent. For each reaction, however, platinum is not necessarily the best. Palladium may be a good catalyst to oxidize methanol to COad because it is known as a good catalysts for dehydrogenation of hydrocarbons. 

---