Phenylacetic acid chloride

Different montmorillonites are also employed to react resorcinol with phenylacetic acid chloride [122,123]. A high resorcinol conversion is reached (65-80%), but the yield of the desired ketone is poor and only with KS montmorillonite is an appreciable yield of 25% achieved, the ester being nevertheless the main product. The ketone/ester ratio remains practically constant during the... 

The ketones are readily prepared, for example, acetophenone from benzene, acetyl chloride (or acetic anhydride) and aluminium chloride by the Friedel and Crafts reaction ethyl benzyl ketones by passing a mixture of phenylacetic acid and propionic acid over thoria at 450° and n-propyl- p-phenylethylketone by circulating a mixture of hydrocinnamic acid and n-butyric acid over thoria (for further details, see under Aromatic Ketones, Sections IV,136, IV,137 and IV,141). 

Phenylacetic acid. Use 5 0 g. of magnesium, 25 g, (23 ml.) of redistilled benzyl chloride (Section IV,22) and 75 ml. of sodium-dried ether. Allow the reaction mixture to warm to 15° and then decompose it with dilute hydrochloric or sulphuric acid. Filter off the crude acid and recrystallize it from water. The yield of pure phenylacetic acid, m.p. 76-77°, is 11 g. 

This product is sufficiently pure for the preparation of phenylacetic acid and its ethyl ester, but it contains some benzyl tso-cyanide and usually develops an appreciable colour on standing. The following procedure removes the iso-cyanide and gives a stable water-white compound. Shake the once-distilled benzyl cyanide vigorously for 5 minutes with an equal volume of warm (60°) 60 per cent, sulphuric acid (prepared by adding 55 ml. of concentrated sulphuric acid to 100 ml. of water). Separate the benzyl cyanide, wash it with an equal volume of sa+urated sodium bicarbonate solution and then with an equal volume of half-saturated sodium chloride solution- Dry with anhydrous magnesium sulphate and distil under reduced pressure. The loss in washing is very small (compare n-Butyl Cyanide, Section 111,113, in which concentrated hydrochloric acid is employed). 

This procedure is called chloromethylation and will not only turn 1,3-benzodioxole into a methyl chloride but will work equally well in converting plain old benzene into benzyl chloride. Both are important stepping stones towards the production of X and meth. For example, benzyl chloride is a schedule I controlled substance because it will beget benzaldehyde and phenylacetonitrile (a precursor for phenylacetic acid). 

The phenylacetic acid derivative 469 is produced by the carbonylation of the aromatic aldehyde 468 having electron-donating groups[jl26]. The reaction proceeds at 110 C under 50-100 atm of CO with the catalytic system Pd-Ph3P-HCl. The reaction is explained by the successive dicarbonylation of the benzylic chlorides 470 and 471 formed in situ by the addition of HCl to aldehyde to form the malonate 472, followed by decarboxylation. As supporting evidence, mandelic acid is converted into phenylacetic acid under the same reaction conditions[327]. 

Reactions of the Side Chain. Benzyl chloride is hydrolyzed slowly by boiling water and more rapidly at elevated temperature and pressure in the presence of alkaHes (11). Reaction with aqueous sodium cyanide, preferably in the presence of a quaternary ammonium chloride, produces phenylacetonitrile [140-29-4] in high yield (12). The presence of a lower molecular-weight alcohol gives faster rates and higher yields. In the presence of suitable catalysts benzyl chloride reacts with carbon monoxide to produce phenylacetic acid [103-82-2] (13—15). With different catalyst systems in the presence of calcium hydroxide, double carbonylation to phenylpymvic acid [156-06-9] occurs (16). Benzyl esters are formed by heating benzyl chloride with the sodium salts of acids benzyl ethers by reaction with sodium alkoxides. The ease of ether formation is improved by the use of phase-transfer catalysts (17) (see Catalysis, phase-thansfer). 

Diphenylbutadiene has been obtained from phenylacetic acid and cinnamaldehyde with lead oxide, by the dehydrogenation of l,4-diphenyl-2-butene with butyllithium, and by the coupling reaction of benzenediazonium chloride and cinnamyl-ideneacetic acid." The present method gives better yields than those previously reported, is adaptable to the preparation of a variety of substituted bistyryls, and is relatively easy to carry out. 

Under comparable conditions the corresponding alkylations of phenylacetic acid with a-phenylethyl chloride and benzhydryl chloride have been effected to form o ,/3-diphenylbutyric acid and a ,/3,/3-triphenylpropionic acid in yields of 74% and 51%, respectively. ... 

Phthalic anhydride is reacted with phenylacetic acid to form 3-benzylidenephthalide which is then hydrogenated to 2-phenethylbenzoic acid. Conversion to the acid chloride followed by intramolecular dehydrochlorination yields the ketone, 5H-dibenzo[a,d] cyclohepten-5-one. The ketone undergoes a Grignard reaction with 3-(dimethylamino)propyl chloride to give 5-(7-dimethylaminopropylidene)-5H-dibenzo[a,d] cycloheptene. 

Yamase and Goto406 determined first- and second-order rate coefficients for the aluminium chloride-catalysed reaction of halide derivatives of benzoic acid (lO5 = F, 1.73 Cl, 4.49 Br, 4.35 I, 0.81) and phenylacetic acid (105fc2 = F, 12 Cl, 21 Br, 9 I, 6) with benzene. The maxima in the rates for the acid chloride are best accommodated by the assumption that a highly (but not completely) polarised complex takes part in the transition state. Polarisation of such a complex would be aided by electron supply, and consistently, the acetyl halides are about a hundred times as reactive as the benzoyl compounds (see p. 180, also Tables 105 and 108). 

Similarly, Pd/tppts was used by Hoechst (Kohlpainter and Beller, 1997) as the catalyst in the synthesis of phenylacetic acid by biphasic carbonylation of benzyl chloride (Fig. 2.29). The new process replaces a classical synthesis by reaction of benzyl chloride with sodium cyanide, followed by hydrolysis of the resulting benzyl cyanide. Although the new process produces one equivalent of sodium chloride, this is substantially less salt production than in the original process. Moreover, sodium cyanide is about seven times as expensive per kg as carbon monoxide. 

Organic groups can be rendered more nucleophilic toward carbon monoxide by adding halide ions. Benzyl chloride easily gives phenylacetic acid in this way (example 20, Table VII). 

Eastman Kodak Company white label grade of phenylacetyl chloride was used, but equally good results are obtained with the crude acid chloride obtained by treating phenylacetic acid with an excess of thionyl chloride and removing the latter under reduced pressure. 

Oxalyl Chloride Phenyl-2-Propanone Phenylacetic Acid Phenylacetone... 

Ethyl phenylacetate may be prepared by the treatment of benzyl cyanide with alcohol and hydrochloric acid gas.1 It is much more convenient in the laboratory, however, to use sulfuric acid in place of hydrochloric acid in fact, the yields obtained are better than those recorded in the literature. This ester may also be made by the esterification of phenylacetic acid with hydrochloric acid and alcohol 2 or with alcohol and sulfuric acid 3 the following less important methods of preparation may be mentioned the action of benzyl magnesium chloride upon ethyl chlorocarbonate,4 and the action of copper on a mixture of bromobenzene and ethyl chloroacetate at 1800.5... 

Benzyltriethylammonium chloride is frequently used as the phase-transfer catalyst, but it has been noted that the catalyst itself produces phenylacetic acid under the carbonylation conditions [6]. Trimethyl(phenyl)ammonium chloride and tetra-n-butylammonium chloride both catalyse the reaction efficiently. 

The reaction has also been applied to the conversion of vinyl bromides into acrylic acids, e.g. 1-bromo- and 1-chlorocyclooctene are converted into cyclooctene-1-carboxylic acid (ca. 98%) [3], 2-chloro-3,3-dimethylbut-l-ene yields 4,4-dimethylpent-2-enoic acid (95%), and tams-cinnamic acid is obtained (85%) from fran.v-p-bromostyrene. cis-p-Bromostyrene produces a mixture of cis- and trans-cinnamic acids in 38 and 42% yields, respectively [3]. In these reactions, benzyltri-ethylammonium chloride cannot be used as the phase-transfer catalyst, as it leads to the production of phenylacetic acid [3]. 

Anionicallv Activated Alumina. At this time we had also developed an interest in anionically activated alumina. These basic reagents were active in promoting alkylation(42), condensation(43) and hydrolysis(44) reactions. Thus, we impregnated alumina with sodium hydroxide and used this combination both with and without a phase transfer catalyst (benzyltriethyl ammonium chloride). When BTEAC was added, the conversion to ether was decreased and the formation of ester was noted. In the absence of a phase transfer catalyst, the ether became a minor product and methyl phenylacetate became the major product with coproduction of phenylacetic acid. This ester does not result from esterification of the acid as simple stirring of phenylacetic acid with Na0H/A1203 in methanol does not produce methyl phenylacetate. 

Further data from the polarography and cyclic voltammetry in dimethylformamide are given in Table 5.1 for a series of overall two-electron processes leading to cleavage of a benzyl-heteroatom bond. The first electron transfer step is of the dissociative electron transfer type leading to a benzyl radical. This radical is reduced firrther, at the working potential, to the benzyl carbanion. The carbanion fi om benzyl chlorides, esters, ethers, sulphides, sulphones and quaternary ammonium salts can be trapped by carbon dioxide to form phenylacetic acid [2]. Reac-... 

Indolylthio)phenylacetic acid 168 in 50% polyphosphate ester in methylene chloride at room temperature affords 169 as a major product in 65% yield. In hot polyphosphoric acid (PPA) cyclized 169 and 170 were formed in 15 and 21% yields, respectively, due to the partial isomerization. Heating in PPA for a prolonged period gives a 90% yield of 170 as a sole product of... 

A related agent, g1icetanile sodiurn (42), is made by a variant of this process. Methyl phenylacetate is reacted with chlorosulfonic acid to give which itself readily reacts with ami nopyrimidine derivative 39 to give sulfonamide Saponification to acid is followed by conversion to the acid chloride and amide formation with 5-chloro-2-methoxyaniline to complete the synthesis of the hypoglycemic agent glicetanile (42). ... 

Diclofenac Diclofenac, 2-[(2,6-dichlorophenyl)-amino]-phenylacetic acid (3.2.42), is synthesized from 2-chIorobenzoic acid and 2,6-dichloroaniline. The reaction of these in the presence of sodium hydroxide and copper gives iV-(2,6-dichlorophenyl)anthranyIic acid (3.2.38), the carboxylic group of which undergoes reduction by lithium aluminum hydride. The resulting 2-[(2,6-dicholorphenyl)-amino]-benzyl alcohol (3.2.39) undergoes further chlorination by thionyl chloride into 2-[(2,6-dichlorophenyl)-amino]-ben-zylchloride (3.2.40) and further, upon reaction with sodium cyanide converts into... 

With the same procedure /-butyl phenylacetate has been prepared in 47% yield.4 When esters of less common alcohols were prepared, anhydrous ether was used as a solvent instead of excess alcohol. Equivalent amounts of alcohol, n-butyllithium, and acid chloride were employed. Thus the triethylcarbinol ester of p-toluic acid and the 2,2-diphenylethanol ester of benzoic acid have been prepared in 72 and 70% yields, respectively. 

---