Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Peel adhesion testing

FIGURE 23.17 Styrene-butadiene copolymer (SBR) peel adhesion test piece after first appl3nng a gas decompression (GD) procedure and then peel testing. [Pg.652]

BS 903 Part A4858 is identical to ISO 4647 and Part A 5659 identical to ISO 5603. It is significant that the equivalent ASTM standards are not produced under the auspices of the committee for rubber but in a subcommittee of the textiles committee specifically covering tyre cord and fabrics. The H-test is in D477660 and the method for steel cord in D222961. There is also a method for strap peel adhesion test of reinforcing cords or fabric in D439362. [Pg.375]

Fig. 13. Results of 180° peel adhesion tests for epoxy cured with polyamic acid systems (cir-cles=cure for 1 h at 125 °C, 2 h at 250 °C, squares=cme for 1 h at 250 °C, triangles=low molecular weight PA A, cure for 1 h at 125 °C, 2 h at 250 °C)... Fig. 13. Results of 180° peel adhesion tests for epoxy cured with polyamic acid systems (cir-cles=cure for 1 h at 125 °C, 2 h at 250 °C, squares=cme for 1 h at 250 °C, triangles=low molecular weight PA A, cure for 1 h at 125 °C, 2 h at 250 °C)...
Figure 7.28 Peel adhesion test loading jig with attached deadweight (Heimann, 1999). Figure 7.28 Peel adhesion test loading jig with attached deadweight (Heimann, 1999).
Sexsmith, M. and Troczynski, T. (1994) Peel adhesion test for thermal spray coatings. /. Therm. Spray Technol, 3 (4), 404—414. [Pg.440]

Other Materials. The acrylic D, Hypalon E, and Butyl F caulking compounds were too weak and tacky for the tensile testing technqiues employed and thus were not evaluated in these tests. (Peel adhesion tests, a topic of a future paper, were employed in monitoring the hydrolytic stability of these soft caulking compounds). [Pg.63]

Figure 1 Peel adhesion testing (a) 180° peel (b) 90° peel (c) reverse 180° peel (d) adhesion of irregular shapes. Figure 1 Peel adhesion testing (a) 180° peel (b) 90° peel (c) reverse 180° peel (d) adhesion of irregular shapes.
Figure 2 90° peel adhesion testing (a) controlled 90° peel adhesion (b) drum peel. [Pg.259]

Most of the testing we did early on was pretty simple. There are three basic properties of all pressure-sensitive adhesives peel, tack and shear. Most of the testing we did was pretty limited to peel adhesion tests, tack tests and shear tests. We weren t doing a lot of application-related testing. Testing was done in lab conditions on stainless steel test panels, and customers were trying to translate that information into whether the adhesive would actually perform on their specific substrate. [Pg.36]

While the numerical values of a tensile adhesion test according to ASTM C633-01 (2001) and a peel adhesion test according to a modified ASTM D3167-03a (2004) designation (Sexsmith and Troczynski,... [Pg.364]

Processability studies Cel fraction analysis Eleat-shrinkable property Contact angle measurements Peel adhesion test... [Pg.8]

Wan KT (1999) Fracture mechanics of a V-peel adhesion test transition from a bending plate to a stretching membrane. J Adhes 70(3 ) 197 Wan KT, Lim SC (1998) The bending to stretching transition of a pressurized blister test. Int J Fract 92(4) L43... [Pg.549]

FIGURE 11.4 Peel adhesion tests, (a) 90° peel test and (b) 180° peel test. [Pg.247]

It should be emphasized that peel adhesion test is only an indirect indicator of actual plate adhesion the correlation between peel adhesion values and pass/fail in thermal cycle and/or thermal shock is quite weak. The lower limit of 5 Ib/in is based on empirical data. Values greater than 10 Ib/in are routinely seen for ABS or ABS-rich... [Pg.711]

Figure 3 Double Copper Peel Adhesion test for CP8930 plaques at different molding conditions... Figure 3 Double Copper Peel Adhesion test for CP8930 plaques at different molding conditions...

See other pages where Peel adhesion testing is mentioned: [Pg.90]    [Pg.468]    [Pg.469]    [Pg.469]    [Pg.653]    [Pg.82]    [Pg.90]    [Pg.143]    [Pg.351]    [Pg.353]    [Pg.256]    [Pg.266]    [Pg.805]    [Pg.468]    [Pg.469]    [Pg.469]    [Pg.23]    [Pg.6711]    [Pg.594]    [Pg.599]    [Pg.355]    [Pg.254]    [Pg.559]    [Pg.657]    [Pg.373]    [Pg.63]    [Pg.65]    [Pg.711]    [Pg.712]   
See also in sourсe #XX -- [ Pg.657 ]




SEARCH



Adhesion modified peel test

Adhesion peel tests

Adhesion peel tests

Adhesion test

Adhesion testing

Adhesive Tests

Adhesive bond strength tests 180° peel

Adhesive strength Peel test

Adhesive testing

Adhesiveness test

Adhesives peel test

Adhesives peel test

Peel adhesion

Peel test

Peel test for adhesives

Peeling tests

Test, testing adhesion

© 2024 chempedia.info