Paint-like surface

Coatings are applied to the outside or inside of the foundation, creating a radon-resistant barrier between the source and the inside of the home. They come in a wide variety of materials including paint-like products that can be brushed on the interior of the foundation, tar-like materials that are applied to the outside, and cementitious materials that can be brushed or troweled on. They cannot be applied to the underside of the concrete floor slab for obvious reasons, so they must be applied to the inside surface of the slab. The effective life of an interior coating can be greatly diminished by damage therefore, care must be taken to provide protection to the material used. 

Line has personality, just like people. The personality of a line is expressed by its size, type, direction, location, and character. The character of the line can come from the medium. A charcoal line will be different in character from a wire line. Lines are short or long, wide or narrow, curved, straight, wavy, or jagged. They cross a painting s surface, move up and down, in and out, and back and forth. A line may unify or divide. Lines can show a variety of character, depending on the tool used to create them. A brushstroke line... 

In a second test of spray pattern, special slides were obtained from Erie Scientific, Inc. (Portsmouth, NH) that were evenly coated over their entire surface with a paint-like coating that does not make fluids bead up, nor does it allow bleeding of applied fluids. These slides were loaded onto the platen, and the instrument was programmed to spray dye onto all three positions of each slide. The slides were then kept on the machine until all water had evaporated, leaving the dye residue on the coating in the original area sprayed. This test resulted in circular spray patterns over... 

For the development of design surface, a distinction between the pre-and posttreatment of mold cavity surface and pure pre-treatment for coating (e.g., eroded mold surfaces) has to be done. For the design development, processes such as micro-radiation, mat-down treatment, or micro mat can be used. Depending on the technology used, as shown in Figure 2.110, paint-like or very dull surfaces can be established. 

The characteristics of fluoropolymers are summarized in Table 1. Thermal and chemical resistance is in general with most of plastics, elastomers and perfluorinated membranes. Weather resistance with the outdoor durability for more than 20 years is specific for fluorinated paint resins. Surface properties such as water and oil repellency are provided by acrylic polymer-based textile finishes and coatings with long-chain per-fluoroalkyl groups. Electrical properties as well as a low refractive index are important for optoelectronics applications like optical fibers. 

Wettability is determined by who wins the competition between paint-substrate adhesive forces and cohesive forces in the paint (19). Adhesive forces cause the paint to spread. Cohesive forces cause the drop to bead up. The contact angle is determined by the balance between the two forces. Wetting occurs when the liquid paint likes the substrate, that is, is compatible with it, and beading occurs when the paint does not like the substrate. Surface contamination, sanding, cleaning, and other processes can can change this compatibility, thereby changing the wettability. 

These grass-like and resident instadations require substantial amounts of synthetic materials. A typical sports field covered with artificial turf requires approximately 15,000 kg of fabric, 15,000—30,000 kg of shock-absorbing underpad, and 5,000—10,000 kg of adhesive and seaming materials. The artificial surface for a 0.40-km miming track may require 50,000—70,000 kg of materials. Paint striping and marking of turf, tracks, and courts cad for additional materials. 

The back paper or gray back is also a three-ply paper very similar ia constmction to the face paper, except it is approximately 4 ft (1.2 m) wide and the outside surface is not treated for paint absorption like the cream face. 

---