Autocatalytic oxidation

The main experimental features may be summarized as follows [42, 60]. In acid-washed pyrex vessels, below 150 °C acetaldehyde oxidizes autocatalytically and with a pressure decrease over most of the reaction, peracid being produced in approximate accordance with... 

The combination of unsaturation and peroxides produced during the first minute of processing has a powerful photoactivating effect on poly(vinyl chloride) during UV irradiation. Figure 3.38 shows that unprocessed (solvent cast) film of poly(vinyl chloride) photo-oxidizes autocatalytically as measured... 

Bromide ion acts as an inliibitor through step (9) which competes for HBr02 with the rate detennining step for the autocatalytic process described previously, step (4) and step (5). Step (8) and Step (9) constitute a pseudo-first-order removal of Br with HBr02 maintained in a low steady-state concentration. Only once [Br ] < [Br ] = /fo[Br07]//r2 does step (3) become effective, initiating the autocatalytic growth and oxidation. 

Thermal Oxidative Stability. ABS undergoes autoxidation and the kinetic features of the oxygen consumption reaction are consistent with an autocatalytic free-radical chain mechanism. Comparisons of the rate of oxidation of ABS with that of polybutadiene and styrene—acrylonitrile copolymer indicate that the polybutadiene component is significantly more sensitive to oxidation than the thermoplastic component (31—33). Oxidation of polybutadiene under these conditions results in embrittlement of the mbber because of cross-linking such embrittlement of the elastomer in ABS results in the loss of impact resistance. Studies have also indicated that oxidation causes detachment of the grafted styrene—acrylonitrile copolymer from the elastomer which contributes to impact deterioration (34). 

The mechanism of oxidative dyeing involves a complex system of consecutive, competing, and autocatalytic reactions in which the final color depends on the efficiency with which the various couplers compete with one another for the available diimine. In addition, hydrolysis, oxidation, or polymerization of diimine may take place. Therefore, the color of a mixture caimot readily be predicted and involves trial and error. Though oxidation dyes produce fast colors, some off-shade fading does occur, particularly the development of a red tinge by the slow transformation of the blue indamine dye to a red phenazine dye. 

Thermal Decomposition of GIO2. Chloiine dioxide decomposition in the gas phase is chaiacteiized by a slow induction period followed by a rapid autocatalytic phase that may be explosive if the initial concentration is above a partial pressure of 10.1 kPa (76 mm Hg) (27). Mechanistic investigations indicate that the intermediates formed include the unstable chlorine oxide, CI2O2. The presence of water vapor tends to extend the duration of the induction period, presumably by reaction with this intermediate. When water vapor concentration and temperature are both high, the decomposition of chlorine dioxide can proceed smoothly rather than explosively. Apparently under these conditions, all decomposition takes place in the induction period, and water vapor inhibits the autocatalytic phase altogether. The products of chlorine dioxide decomposition in the gas phase include chlorine, oxygen, HCl, HCIO, and HCIO. The ratios of products formed during decomposition depend on the concentration of water vapor and temperature (27). 

Uninhibited chloroprene suitable for polymerisation must be stored at low temperature (<10° C) under nitrogen if quaUty is to be maintained. Otherwise, dimers or oxidation products are formed and polymerisation activity is unpredictable. Insoluble, autocatalytic "popcorn" polymer can also be formed at ambient or higher temperature without adequate inhibition. For longer term storage, inhibition is required. Phenothiasine [92-84-2] / fZ-butylcatechol [2743-78-17, picric acid [88-89-17, and the ammonium salt of /V-nitroso-/V-pheny1hydroxy1 amine [135-20-6] have been recommended. 

Degenerate Explosion it was a free radical autocatalytic process and control was difficult, but manageable. The main disadvantage was that it produced as much or more acrolein as propylene oxide. Because no market existed for acrolein at that time, the project was abandoned. Within two years, the acrylic market developed and a new project was initiated to make acrolein and acrylic acid by vapor-phase catalytic oxidation of propylene. 

The fimction of an antioxidant is to divert the peroxy radicals and thus prevent a chain process. Other antioxidants fimction by reacting with potential initiators and thus retard oxidative degradation by preventing the initiation of autoxidation chains. The hydroperoxides generated by autoxidation are themselves potential chain initiators, and autoxidations therefore have the potential of being autocatalytic. Certain antioxidants fimction by reducing such hydroperoxides and thereby preventing their accumulation. 

Once radicals are generated in the presence of air the reaction becomes autocatalytic (see Fig. 15). Ignoring the relatively infrequent radical combination processes (Fig. 15, Eqs. 8-10) the net reaction (Fig. 15, Eqs. 1-7) shows that for every new radical generated three more are created. Oxidation produces water, and alcohols. 

The autocatalytic behaviour found [1203] for chromite formation, through the reactions of Cr203 with various oxides (CdO, CuO, MgO, NiO, and ZnO) in air, was attributed to the intermediate production of the chromate which later decomposed to MCr204. Haber [1204] concluded that during the reaction... 

This very situation has been encountered during the oxidation of Ta Br2 (= A) to TafiBrJj(= P) by VO, the dioxovanadium(l+) ion (= B), in aqueous solution.19 The autocatalytic reaction of Ta Br and VOJ produces Ta Br l = I), which does not accumulate in the system owing to its rapid reaction with TaeBrfr. 

Iron is the most abundant, useful, and important of all metals. For example, in the 70-kg human, there is approximately 4.2 g of iron. It can exist in the 0, I, II, III, and IV oxidation states, although the II and III ions are most common. Numerous complexes of the ferrous and ferric states are available. The Fe(II) and Fe(III) aquo complexes have vastly different pAa values of 9.5 and 2.2, respectively. Iron is found predominantly as Fe (92%) with smaller abundances of Fe (6%), Fe (2.2%), and Fe (0.3%). Fe is highly useful for spectroscopic studies because it has a nuclear spin of. There has been speculation that life originated at the surface of iron-sulfide precipitants such as pyrite or greigite that could have caused autocatalytic reactions leading to the first metabolic pathways (2, 3). 

The oxidation is autocatalytic, being catalyzed by the product, benzeneseleninic acid. If the temperature drops significantly below 30°, the addition of hydrogen peroxide should be stopped, and the ice-salt bath should be removed to maintain the rate of oxidation and avoid an accumulation of hydrogen peroxide in the flask. 

It is noteworthy that, as early as 1929, Shibata and Tsuchida reported a kinetic resolution of rac-3,4-dihydroxyphenylalanine by selective oxidation of one enantiomer using a chiral cobalt complex [Co(en)3NH3Cl]Br2 as a catalyst [46,47]. Figure 12 shows a highly enantioselective addition of diisopropy-Izinc to 2-(ferf-butylethynyl)pyrimidine-5-carbaldehyde via an autocatalytic process in the presence of a chiral octahedral cobalt complex with ethylenedi-... 

The electrochemistry of single-crystal and polycrystalline pyrite electrodes in acidic and alkaline aqueous solutions has been investigated extensively. Emphasis has been laid on the complex anodic oxidation process of pyrite and its products, which appears to proceed via an autocatalytic pathway [160]. A number of investigations and reviews have been published on this subject [161]. Electrochemical corrosion has been observed in the dark on single crystals and, more drastically, on polycrystalline pyrite [162]. Overall, the electrochemical path for the corrosion of n-EeS2 pyrite in water under illumination has been described as a 15 h" reaction ... 

No published work exists on the kinetics of acid permanganate oxidation of hydroxy-acids although Pink and Stewart have noted that benzilic acid is oxidised by acid permanganate to benzophenone in an autocatalytic process with knjo/ Dio of unity. 

The oxidation of di-2-chloroethyl ether is first-order with respect to ether, but is autocatalytic and chloride ion is liberated. A hydrogen atom abstraction process, similar to that above, probably takes place, viz. 

At first sight the argument of Westheimer, according to which it is unwise to postulate a reaction in which two unstable intermediates are simultaneously produced, seems to be acceptable, especially if we take into consideration that these induced oxidations are not autocatalytic in nature most of mechanisms involving arsenic(IV), chromium(IV), and chromium(V) lead to the conclusion that the... 

Section 3 deals with reactions in which at least one of the reactants is an inorganic compound. Many of the processes considered also involve organic compounds, but autocatalytic oxidations and flames, polymerisation and reactions of metals themselves and of certain unstable ionic species, e.g. the solvated electron, are discussed in later sections. Where appropriate, the effects of low and high energy radiation are considered, as are gas and condensed phase systems but not fully heterogeneous processes or solid reactions. Rate parameters of individual elementary steps, as well as of overall reactions, are given if available. 

Lipid hydroperoxides are either formed in an autocatalytic process initiated by hydroxyl radicals or they are formed photochemically. Lipid hydroperoxides, known as the primary lipid oxidation products, are tasteless and odourless, but may be cleaved into the so-called secondary lipid oxidation products by heat or by metal ion catalysis. This transformation of hydroperoxides to secondary lipid oxidation products can thus be seen during chill storage of pork (Nielsen et al, 1997). The secondary lipid oxidation products, like hexanal from linoleic acid, are volatile and provide precooked meats, dried milk products and used frying oil with characteristic off-flavours (Shahidi and Pegg, 1994). They may further react with proteins forming fluorescent protein derivatives derived from initially formed Schiff bases (Tappel, 1956). 

---