Osmosis, electrical

Electro-osmosis Electric field Stationary In movement... 

Data on the electro-osmosis of water through a membrane of cellulose acetate have been analysed in terms of non-equilibrium thermodynamics. The linear phenomenological equations were found to be valid for the system. The efficiencies of energy conversion for both electro-osmosis (electrical energy into mechanical work) and streaming potential (mechanical work into electrical energy) were calculated. 

Related phenomena are electro-osmosis, where a liquid flows past a surface under the influence of an electric field and the reverse effect, the streaming potential due to the flow of a liquid past a charged surface. 

Electrophoresis and electro osmosis can be used to enhance conventional cake filtration. Electrodes of suitable polarity are placed on either side of the filter medium so that the incoming particles move toward the upstream electrode, away from the medium. As most particles carry negative charge, the electrode upstream of the medium is usuaHy positive. The electric field can cause the suspended particles to form a more open cake or, in the extreme, to prevent cake formation altogether by keeping aH particles away from the medium. 

The 2eta potential (Fig. 8) is essentially the potential that can be measured at the surface of shear that forms if the sohd was to be moved relative to the surrounding ionic medium. Techniques for the measurement of the 2eta potentials of particles of various si2es are collectively known as electrokinetic potential measurement methods and include microelectrophoresis, streaming potential, sedimentation potential, and electro osmosis (19). A numerical value for 2eta potential from microelectrophoresis can be obtained to a first approximation from equation 2, where Tf = viscosity of the liquid, e = dielectric constant of the medium within the electrical double layer, = electrophoretic velocity, and E = electric field. 

In other areas, POD has been used to improve the wear resistance of a mbber latex binder by incorporation of 25% of Oksalon fibers. Heat-resistant laminate films, made by coating a polyester film with POD, have been used as electrical insulators and show good resistance to abrasion and are capable of 126% elongation. In some instances, thin sheets of PODs have been used as mold release agents. For this appHcation a resin is placed between the two sheets of POD, which is then pressed in a mold, and the sheets simply peel off from the object and mold after the resin has cured. POD-based membranes exhibit salt rejection properties and hence find potential as reverse osmosis membranes in the purification of seawater. PODs have also been used in the manufacturing of electrophotographic plates as binders between the toner and plate. These improved binders produce sharper images than were possible before. 

Nonporous Dense Membranes. Nonporous, dense membranes consist of a dense film through which permeants are transported by diffusion under the driving force of a pressure, concentration, or electrical potential gradient. The separation of various components of a solution is related directiy to their relative transport rate within the membrane, which is determined by their diffusivity and solubiUty ia the membrane material. An important property of nonporous, dense membranes is that even permeants of similar size may be separated when their concentration ia the membrane material (ie, their solubiUty) differs significantly. Most gas separation, pervaporation, and reverse osmosis membranes use dense membranes to perform the separation. However, these membranes usually have an asymmetric stmcture to improve the flux. 

Membrane Filtration. Membrane filtration describes a number of weU-known processes including reverse osmosis, ultrafiltration, nanofiltration, microfiltration, and electro dialysis. The basic principle behind this technology is the use of a driving force (electricity or pressure) to filter... 

The individual membrane filtration processes are defined chiefly by pore size although there is some overlap. The smallest membrane pore size is used in reverse osmosis (0.0005—0.002 microns), followed by nanofiltration (0.001—0.01 microns), ultrafHtration (0.002—0.1 microns), and microfiltration (0.1—1.0 microns). Electro dialysis uses electric current to transport ionic species across a membrane. Micro- and ultrafHtration rely on pore size for material separation, reverse osmosis on pore size and diffusion, and electro dialysis on diffusion. Separation efficiency does not reach 100% for any of these membrane processes. For example, when used to desalinate—soften water for industrial processes, the concentrated salt stream (reject) from reverse osmosis can be 20% of the total flow. These concentrated, yet stiH dilute streams, may require additional treatment or special disposal methods. 

Behavior. Diffusion, Brownian motion, electrophoresis, osmosis, rheology, mechanics, and optical and electrical properties are among the general physical properties and phenomena that are primarily important in coUoidal systems (21,24—27). Of course, chemical reactivity and adsorption often play important, if not dominant, roles. Any physical and chemical feature may ultimately govern a specific industrial process and determine final product characteristics. 

Electrically assisted transdermal dmg deflvery, ie, electrotransport or iontophoresis, involves the three key transport processes of passive diffusion, electromigration, and electro osmosis. In passive diffusion, which plays a relatively small role in the transport of ionic compounds, the permeation rate of a compound is deterrnined by its diffusion coefficient and the concentration gradient. Electromigration is the transport of electrically charged ions in an electrical field, that is, the movement of anions and cations toward the anode and cathode, respectively. Electro osmosis is the volume flow of solvent through an electrically charged membrane or tissue in the presence of an appHed electrical field. As the solvent moves, it carries dissolved solutes. 

TDS affects taste also, and waters over 500 - 600 ppm can taste poor. When the levels top 1500 ppm, most people will report the water tastes very similar to weak alka-seltzer. TDS is removed by distillation, reverse-osmosis or electrodialysis. In our area, most desalination projects, both large and small are accomplished with reverse-osmosis. Depending on the water chemistry, reverse osmosis systems are the most popular, given their low cost and ease of use. Distillers work very well also, and produce very high quality water, but require electricity and higher... 

Electro-osmosis has been defined in the literature in many indirect ways, but the simplest definition comes from the Oxford English Dictionary, which defines it as the effect of an external electric held on a system undergoing osmosis or reverse osmosis. Electro-osmosis is not a well-understood phenomenon, and this especially apphes to polar non-ionic solutions. Recent hterature and many standard text and reference books present a rather confused picture, and some imply directly or indirectly that it cannot take place in uniform electric fields [31-35]. This assumption is perhaps based on the fact that the interaction of an external electric held on a polar molecule can produce only a net torque, but no net force. This therefore appears to be an ideal problem for molecular simulation to address, and we will describe here how molecular simulation has helped to understand this phenomenon [26]. Electro-osmosis has many important applications in both the hfe and physical sciences, including processes as diverse as water desahnation, soil purification, and drug delivery. 

The molecular simulations also showed that electro-osmosis is also observed in aqueous electrolyte solutions, as long as the external electric field is reversed periodically to prevent the ions from accumulating near the membrane. An example of this is shown in Fig. 10, which shows the effect of an electric field on a 4.67 mole percent aqueous LiCl solution at 25°C. It is quite clear that the mobility of the solvent molecules increases as a result of... 

S. Murad, R. Madhusudan, J. G. Powles. A molecular simulation to investigate the possibility of electro-osmosis in non-ionic solutions with uniform electric fields. Mol Phys 90 671, 1997 R. Madhususan, J. Lin, S. Murad. Molecular simulations of electro-osmosis in fluid mixtures using semi-permeable membranes. Eluid Phase Equil 150 91, 1998. 

The electrical conductivity of the water is critical to the correct operation of this type of boiler, and the precise level varies with design and power requirements. However, the conductivity is always relatively low (often specifications require a level of below 15-50 p,S/cm), so demineralized or reverse-osmosis (RO) quality FW is usually specified. 

---